-
Philips MCB146 - page 1
MCB146 Micr o Hi-Fi System User manual User manual Register your pr oduct and get support at www .philips.com/welcome MCB146_05_Eng_ASDA 4/2/10, 15:05 1 ...
-
Philips MCB146 - page 2
2 Important notes for users in the U.K. Mains plug This apparatus is fitted with an approved 13 Amp plug. T o change a fuse in this type of plug proceed as follows: 1 Remov e fuse cover and fuse. 2 Fix new fuse which should be a BS1362 3 Amp, A.S.T .A. or BSI approved type. 3 Refit the fuse co ver . If the fitted plug is not suitab le for your sock ...
-
Philips MCB146 - page 3
3 PULL TO OPEN % # @ ! 0 $ 9 7 8 1 3 4 2 5 6 1 2 3 4 5 6 8 9 0 7 ! 9 MCB146_05_Eng_ASDA 4/2/10, 15:05 3 ...
-
Philips MCB146 - page 4
English 4 Contents General Information Supplied accessories ............................................ 5 En vironmental Information ................................ 5 Safety Inf ormation ................................................ 5 Hearing Safety ....................................................... 6 Preparations Rear connections ....... ...
-
Philips MCB146 - page 5
5 English General Information Congratulations on your purchase and welcome to Philips! To fully benefit from the suppor t that Philips off er s, register your product at www .philips.com/ w elcome. This pr oduct complies with the radio interference r equirements of the Eur opean Community . Supplied accessories –2 speaker box es – remote contro ...
-
Philips MCB146 - page 6
English 6 General Information warm location, or is placed in a ver y damp room, moisture ma y condense on the lens of the disc unit inside the system. Should this occur , the CD play er would not operate nor mally . Lea ve the po wer on for about one hour with no disc in the system until normal playback is possible. ● The mechanical par ts of the ...
-
Philips MCB146 - page 7
7 English Pr eparations Rear connections The type plate is located at the rear of the system. F or users in the U.K.: please follo w the instructions on page 2. A Po w e r – Before connecting the A C power cord to the wall outlet, ensure that all other connections ha ve been made. WARNING! –F or optimal performance, use only the original po wer ...
-
Philips MCB146 - page 8
English 8 Preparations Notes: –F or optimal sound perf ormance , use the supplied speak ers. – Do not connect more than one speak er to any one pair of + / - speak er terminals. – Do not connect speak er s with an impedance lo wer than the speak ers supplied. Please refer to the SPECIFIC A TIONS section of this manual. Inserting batteries int ...
-
Philips MCB146 - page 9
9 English Contr ols (illustrations on page 3) Contr ols on the system 1 ST ANDBY -ON 2 – switches the system to standby or on. 2 iR – infrared sensor for remote control. 3 TUNING 4 ¢ f or FM .................. tunes to a r adio frequency . f or D AB .............. changes DAB stations, or navigates menu options. f or CD ................. skips ...
-
Philips MCB146 - page 10
English 10 Contr ols (illustrations on page 3) ! 4 ¢ f or FM .................. tunes to a r adio frequency . f or D AB .............. changes DAB stations, or navigates menu options. f or CD ................. skips to the beginning of the current/previous/subsequent track. ................................. fast searches back and forward within a ...
-
Philips MCB146 - page 11
11 English Basic Functions IMPOR T ANT: Befor e you operate the system, complete the prepar ation procedur es . Switching the system on ● Press ST ANDBY -ON 2 or SOURCE ( 2 on the remote control). ➜ The system will switch to the last selected source. ● Press DISC , TUNER , DA B or AU X on the remote control. ➜ The system will switch to the ...
-
Philips MCB146 - page 12
English 12 CD Operation Basic pla yback contr ols To pla y a disc ● Press 2; to star t playback. ➜ The current tr ack number and “PLA Y” icon are displayed during disc playback. To select a different track ● Press 4 / ¢ once or repeatedly until the desired track number appear s in the display . To find a passage within a track 1 Press an ...
-
Philips MCB146 - page 13
13 English CD Operation Differ ent pla y modes: SHUFFLE and REPEA T Y ou can select and change the var ious play modes before or during playback. The play modes cannot be combined with PR OGRAMME. SHUF ................ tracks of the entire disc are play ed in random order . REP ALL ........... repeats the entire disc/ programme . REP .............. ...
-
Philips MCB146 - page 14
English 14 DA B Radio Switching on D AB radio F or the first time when D AB mode is switched on, the system will perform an auto scan. Then all the availab le DAB stations will be stored on the set, and the radio will tune to the fir st availab le station. 1 Press ST ANDBY -ON 2 or SOURCE ( 2 on the remote control) to po wer on the system. 2 Press ...
-
Philips MCB146 - page 15
15 English D AB Radio Selecting a pr eset D AB station 1 Press PRESET + + + + + / - - - - - ( 3 / 4 on the remote control ) to select desired preset station. 2 Press 2; to conf irm the selection. Note – If you have not yet stored a DAB station in one of the presets, "Empty preset" will be display ed. The display will re ver t to the pre ...
-
Philips MCB146 - page 16
English 16 Dynamic Range Control (DRC) DRC adds or remo ves a degree of compensation for the diff erences in the dynamic range between radio stations. For example, a station broadcasting popular music ma y hav e a high level of compensation applied since the emphasis is on a constant high listening level, whereas a station broadcasting classical m ...
-
Philips MCB146 - page 17
17 English FM Radio T uning to radio stations 1 Press SOURCE (or TUNER on the remote control ) repeatedly until the desired waveband (FM) is displayed. 2 Press br iefly SCAN . ➜ The radio automatically tunes to a station with sufficient reception. “Searching.... “ is dispalyed during automactic tuning. 3 Repeat step 2 if necessar y until you ...
-
Philips MCB146 - page 18
English 18 FM Radio AUX RDS The feature RDS ( R adio D ata S ystem) is a ser vice that allows FM stations to send additional information along with the regular FM radio signal. When you are receiving an RDS station, and the station name are display ed. Switching through RDS information 1 T une to the desired RDS r adio station on the FM wa veband ( ...
-
Philips MCB146 - page 19
19 English Clock/Timer 6 Press 4 / ¢ to set the minutes. 7 Press TIMER to conf ir m the time . ➜ The timer is now set and activated. Note: – If CD source is selected and no disc is in the CD tray or the disc has an err or, TUNER will be selected automatically. Activating and deactivating TIMER ● In standby or during playback, press TIMER onc ...
-
Philips MCB146 - page 20
English 20 Specifications AMPLIFIER Output pow er ........................................... 2 x 2W RMS Signal-to-noise r atio .......................... ≥ 60 dBA (IEC) Frequency response ....................... 125 – 16000 Hz Impedance loudspeakers ......................................... 8 Ω CD PLA YER Frequency range .................... ...
-
Philips MCB146 - page 21
21 English “ NO CD ” is displa y ed. Radio reception is poor . The system does not react when buttons ar e pressed. Sound cannot be heard or is of poor quality . The left and right sound outputs ar e re versed. The remote contr ol does not function pr operly . ✔ Inser t a disc . ✔ Check if the disc is inser ted upside down. ✔ W ait until ...
-
Philips MCB146 - page 22
English 22 The time is not working. The Clock/Timer setting is erased. The indication “No station a vailable” is displa yed. The indication “Station off air” is displa yed. I cannot hear the D AB station I hav e selected. ✔ Set the clock correctly . ✔ Press TIMER to switch on the timer . ✔ Po w er has been inter r upted or the power c ...
-
Philips MCB146 - page 23
MCB146_05_Eng_ASDA 4/2/10, 15:06 23 ...
-
Philips MCB146 - page 24
Printed in China CLASS 1 LASER PRODUCT MCB146 MCB146_05_UM_V3.0 Meet Philips at the Internet http://www .philips.com F rançais Po r tuguês Deutsch Italiano Nederlands Italiano Sv enska Dansk Suomi P olski English MCB146_05_Eng_ASDA 4/2/10, 15:06 24 ...
¿Tienes una pregunta acerca de Philips MCB146?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Philips MCB146, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Philips MCB146 probablemente compartirá una forma de solucionarlo.