-
Chamberlain CR550 - page 1
CR550 Rolling Garage Door Opener Installation and Operating Instructions www .chamberlainanz.com Owners Copy: Please keep these instructions for future reference This manual contains IMPORT ANT SAFETY information DO NOT PROCEED WITH THE INST ALLA TION BEFORE READING THOROUGHL Y ...
-
Chamberlain CR550 - page 2
1 CONTENTS P AGE SAFETY INSTRUCTIONS . . . . . . . .1 CART ON INVENT ORY . . . . . . . . . .2 TOOLS REQUIRED . . . . . . . . . . . .2 DOOR REQUIREMENTS . . . . . . . .2 PREP ARE & TEST THE DOOR . .3-4 INST ALLA TION . . . . . . . . . . . . . .5-6 CONNECT ELECTRIC POWER . . .7 ADJUSTMENT . . . . . . . . . . . . . . .7-8 INST ALL THE PROTECTOR SY ...
-
Chamberlain CR550 - page 3
2 1. Instruction manual (this document) 2. W arning and risk of entrapment labels 3. Hardware bag 4. Release handle, cord and risk of entrapment card 5. 3 Channel mini transmitter (2) 6. W all or visor mounted transmitter 7. Stop collar 8 . Clamp bracket and plate 9. Weight bar 10. Extension poles & brace (2) C ART ON INVENTOR Y 1 1 2 3 4 5 6 7 ...
-
Chamberlain CR550 - page 4
TESTING THE DOOR Complete the following test to ensure your door is well balanced, and not sticking or binding: • Disable all locks and remove any ropes connected to the garage door . • Lift the door to about halfway and then release it. The door should remain suspended entirely by its spring. • Raise and lower the door to determine if there ...
-
Chamberlain CR550 - page 5
4 PREP ARING THE OPENER 7 For left hand side installations the wire jumper should be removed . For right hand side installations the wire jumper should be in place (factory installed). Set opener position (left or right hand) Extension pole Reinforcing Brace Drive leg Note: A ballooning door may delay the safety reversal response and can compromise ...
-
Chamberlain CR550 - page 6
5 INST ALLA TION STEPS 9 FOR RIGHT HAND INST ALLA TIONS • Ensure that the opener position jumper (wire connector) is installed (refer Section 7). • Place the opener in manual release mode (refer Section 1 1). • Open the roller door fully . For safety , tie a rope around the door (as shown). • Mark the position of the door axle on the right ...
-
Chamberlain CR550 - page 7
1 0 • Thread one end of the rope through the hole in the top of the red handle so “NOTICE” reads right side up as shown. • Secure with an overhand knot at least 25 mm from the end of the rope to prevent slipping. • Thread the other end of the rope through the loop of the manual release cable. • Adjust the rope length so the handle is no ...
-
Chamberlain CR550 - page 8
T ravel limits regulate the points at which the door will stop when moving UP or DOWN. During the set up procedure, the motor will run and operate the door . T he opener must be fully installed on the door and all installation steps completed before proceeding. PREP ARA TION: • Position the door about half way and engage the opener (section 1 1). ...
-
Chamberlain CR550 - page 9
T he force, as measured on the closing edge of the door , should not exceed 400 N (40 kg). If the closing force is measured to more than 400 N, The Protector System TM (IR Beams) must be installed (refer section 16). The force setting regulates the amount of power required to open and close the door . • Door should be closed before proceeding. ? ...
-
Chamberlain CR550 - page 10
NOTE: This accessory must be used for all installations where the closing force as measured on the bottom of the door is over 400 N (40 kgf). After the opener has been installed and adjusted, the Protector System™ (IR Beams) accessory can be installed. Instructions are included with this accessory . The Protector System™ (IR Beams) provides an ...
-
Chamberlain CR550 - page 11
10 ADDING transmitters using the learn button • Press and hold down the transmitter button you wish to program to the opener . • The orange LED will flash continuously to indicate it is receiving signal from the transmitter . • Press and release the learn button on the opener . • The courtesy LED will flash once. • Ensure the door is clea ...
-
Chamberlain CR550 - page 12
Wireless Keypad 8747AML Using the (purple) learn button: 1. Press and release the (purple) learn button (1) on the opener (the orange LED will light). 2. Within 30 seconds, enter a four digit personal identification number (PIN) of your choice on the keypad (2), then press and hold the ENTER button. 3. Release the button when the opener courtesy LE ...
-
Chamberlain CR550 - page 13
12 1 2 L O C K L I G H T 1.Multifunction control panel Connect white/red wire to the red “wired wall control” quick connect terminal and the white wire to the white “wired wall control” quick connect terminal. 2 .The Protector System™ (IR Beams) Connect both white wires to the white “safety beam” quick connect terminal and both white/ ...
-
Chamberlain CR550 - page 14
TROUBLESHOOTING 1.The opener doesn't operate from either the GREEN start button or the transmitters: • Does the opener have electric power? Plug a lamp into t he outlet. If it doesn't light, check the fuse box. • Have you disabled all door locks? Review installation instruction warnings on page 1. • Is there a build-up of ice or sno ...
-
Chamberlain CR550 - page 15
14 O PERA TION OF YOUR OPENER Y our opener can be activated by any of the following devices: • The GREEN start button Hold the button down until door starts to move. • The wall control, outside keyswitch or keyless e ntry system (if you have installed any of these accessories). • The transmitter or wireless wall control (84330AML) Hold the pu ...
-
Chamberlain CR550 - page 16
15 © 2012 The Chamberlain Group, Inc 1 14B4542B TM T rademark of The Chamberlain Group, Inc. ® Registered Trademark of The Chamberlain Group, Inc. Chamberlain Limited W arranty , we may , subject to your other rights and remedies as a consumer , charge you a fee to repair , replace and/or return the Unit to you. Exclusions This Chamberlain Limite ...
¿Tienes una pregunta acerca de Chamberlain CR550?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Chamberlain CR550, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Chamberlain CR550 probablemente compartirá una forma de solucionarlo.