-
Gefen EXT-DVI-1CAT6-GI - page 1
Audio Embedder 3GSDI EXT-DVI-1CAT6-GI User Manual DVI over 1 CAT6 w/ Galvanic Isolator Release A2 *Pr eferred ...
-
Gefen EXT-DVI-1CAT6-GI - page 2
ii 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this product near water . 6. Clean only with a dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer ’s instructions. 8. Do not install or place this product near any heat sources su ...
-
Gefen EXT-DVI-1CAT6-GI - page 3
iii Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notied within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electric ...
-
Gefen EXT-DVI-1CAT6-GI - page 4
iv T echnical S upport (818) 772-9100 (800) 545-6900 8:00 AM to 5:00 PM Monday - Friday , Pacic T ime Fa x (818) 772-9120 Email support@gefen.com We b http://www .gefen.com Mailing Addr ess Gefen, LLC c/o Customer Service 20600 Nordhoff St. Chatsworth, CA 9131 1 Pr oduct R egistr ation Register your product here: http://www .gefen.com/kvm/Regist ...
-
Gefen EXT-DVI-1CAT6-GI - page 5
v • Always connect a bonding wire between an approved safety ground and the grounding screw on the chassis. • Electromagnetic Interference This product is subject to the following two conditions: ► This device may not cause harmful interference ► This device must accept any interference received including interference that may cause undesir ...
-
Gefen EXT-DVI-1CAT6-GI - page 6
vi Features and Packing List Features • Compliant with Medical Standards EN60601-1 and EN60601-1-2, 3rd Edition • Extends DVI up to 132 feet (40 meters) over CA T -6a • Extends DVI up to 100 feet (30 meters) over CA T -5e • Provides up to 5kV galvanic isolation between the source and the downstream equipment • Supports resolutions up to 1 ...
-
Gefen EXT-DVI-1CAT6-GI - page 7
...
-
Gefen EXT-DVI-1CAT6-GI - page 8
viii Table of Contents 1 Get ting St arted Introduction............................................................................................................ 2 Sender unit .................................................................................................... 2 Receiver unit ....................................................... ...
-
Gefen EXT-DVI-1CAT6-GI - page 9
...
-
Gefen EXT-DVI-1CAT6-GI - page 10
...
-
Gefen EXT-DVI-1CAT6-GI - page 11
DVI over 1 CAT6 w/ Galvanic Isolator 1 Ge t ting St ar t ed Introduction............................................................................................................ 2 Sender unit .................................................................................................... 2 Receiver unit ...................................... ...
-
Gefen EXT-DVI-1CAT6-GI - page 12
page | 2 Page Title Introduction Sender unit DVI over 1 CAT6 w/ Galvanic Isolator S 5V DC Power DVI In Link EXT -DVI-1CAT6-GIS Gefen DVI over 1 CAT6 w/ Galvanic Isolator S 5V DC Power DVI In Link EXT -DVI-1CAT6-GIS Gefen DVI over 1 CAT6 w/ Galvanic Isolator S 5V DC Power DVI In Link EXT -DVI-1CAT6-GIS Gefen 4 5 2 3 1 Getting S tart ed Getting S tar ...
-
Gefen EXT-DVI-1CAT6-GI - page 13
page | 3 Page Title Introduction ID Name Description 1 Link Connect a CA T -5e cable (or better) from this port to the Link port on the Receiver unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Power This LED will glow bright blue once the included 5V DC power supply has been properly connected between the locking p ...
-
Gefen EXT-DVI-1CAT6-GI - page 14
page | 4 Page Title Introduction Getting S tart ed Getting S tart ed Receiver unit DVI over 1 CAT6 w/ Galvanic Isolator R 5V DC Power DVI Out EQ Link EXT -DVI-1CAT6-GIR Gefen 1 2 3 4 5 6 7 0 DVI over 1 CAT6 w/ Galvanic Isolator R 5V DC Power DVI Out EQ Link EXT -DVI-1CAT6-GIR Gefen 1 2 3 4 5 6 7 0 DVI over 1 CAT6 w/ Galvanic Isolator R 5V DC Power ...
-
Gefen EXT-DVI-1CAT6-GI - page 15
page | 5 Page Title Introduction Getting S tart ed ID Name Description 1 Link Connect a CA T -5e cable (or better) from this port to the Link port on the Sender unit. 2 5V DC Connect the included 5V DC power supply to this power receptacle. 3 Power This LED will glow bright blue once the included 5V DC power supply has been properly connected betwe ...
-
Gefen EXT-DVI-1CAT6-GI - page 16
page | 6 Connection Instructions 1. Connect the included DVI cable from the imaging source (e.g. camera) to the DVI In port on the Sender unit. 2. Connect a DVI cable from the DVI Out port, on the Receiver unit, to a video scaler or high-resolution imaging display . 3. Connect a single CA T -5e or better cable from the Link jack on the Sender unit ...
-
Gefen EXT-DVI-1CAT6-GI - page 17
...
-
Gefen EXT-DVI-1CAT6-GI - page 18
...
-
Gefen EXT-DVI-1CAT6-GI - page 19
DVI over 1 CAT6 w/ Galvanic Isolator 2 Basic Oper ation DIP Switch Conguration .................................................................................... 10 Default Settings ........................................................................................... 10 EDID Management .................................................... ...
-
Gefen EXT-DVI-1CAT6-GI - page 20
page | 10 DIP Switch Conguration Basic Oper ation Basic Oper ation On the bottom panel of the Sender unit is a bank of 4 DIP switches. Remove the piece of colored tape to reveal the DIP switch bank. These DIP switches provide control over EDID management and color depth. DIP switches 3 and 4 are not used. Default Settings The following table lis ...
-
Gefen EXT-DVI-1CAT6-GI - page 21
page | 1 1 EDID Management The DVI over 1 CA T6 w/ Galvanic Isolator can be switched between two EDID modes: Internal or Pass-through. After changing DIP switch 1, the Sender unit must be power-cycled for changes to take effect. DIP Switch 1 Description ON (default) Pass-through mode. DDC and HPD are passed through. Both the connection status and t ...
-
Gefen EXT-DVI-1CAT6-GI - page 22
page | 12 The Receiver unit of the DVI over 1 CA T6 w/ Galvanic Isolator has a trim pot that is used to equalize the output signal, compensating for extension distance and cable skew . If there is no output video or if output video contains video artifacts and/or video noise such as snow , use the steps below to adjust the trim pot. 1. Use a small ...
-
Gefen EXT-DVI-1CAT6-GI - page 23
...
-
Gefen EXT-DVI-1CAT6-GI - page 24
...
-
Gefen EXT-DVI-1CAT6-GI - page 25
DVI over 1 CAT6 w/ Galvanic Isolator 3 Appendix Surface Mounting Instructions ............................................................................. 16 Specications ...................................................................................................... 17 ...
-
Gefen EXT-DVI-1CAT6-GI - page 26
page | 16 The Sender and Receiver units can be mounted on any at surface, as shown below (screws not included). There should be an inch or two of clearance between the edges of the unit and any walls or vertical surfaces to allow for enough clearance for connection and disconnection of the DVI cables. For installation on a drywall surface, use a ...
-
Gefen EXT-DVI-1CAT6-GI - page 27
page | 17 Specications Appendix Connectors & Indicators Video Input (Sender) • 1 x DVI 29-pin, female (digital only) Video Output (Receiver) • 1 x DVI 29-pin, female (digital only) Link (Sender / Receiver) • 1 x RJ-45 Power (Sender / Receiver) • 1 x Locking-type Power Indicator (Sender / Receiver) • 1 x LED, blue EDID Selector (Sen ...
-
Gefen EXT-DVI-1CAT6-GI - page 28
20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefen.com support@gefen.com Stretch it. Switch it. Split it. Gefen’s got it. ® 20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefen.com support@gefen.com *Pr eferred ...
¿Tienes una pregunta acerca de Gefen EXT-DVI-1CAT6-GI?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Gefen EXT-DVI-1CAT6-GI, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Gefen EXT-DVI-1CAT6-GI probablemente compartirá una forma de solucionarlo.