-
Frigidaire 2020215A0320 - page 1
T ABLE OF CONTENTS www .frigidaire.com USA 1 -800-944-9044 www .frigidaire.ca Canada 1 -800-265-8352 All a bout th e Us e & Ca r e Care and Cleaning .............................................. 10 Energy Saving Ideas ........................................... 10 2020215A0320 (June 2009) Product Registration ........................................................... 3 Packaging 3 Normal Sounds .................................................... 3 ............................................. Air Conditioner Features 4 ....................................... Important Safety Instructions ............................... 2 Operating Instructions 4-9 ..................................... ...
-
Frigidaire 2020215A0320 - page 2
Important Safety Instructions READ THIS SECTION BEFORE ATTEMPTING TO OPERATE AIR CONDITIONER. Unit must be upright for one hour prior to oper ating. Plug in & press RESET The power supply cord contains a current device that senses damage to the power cord. T o test your power supply cord do the following: Plug in the Air Conditioner . The power supply cord will have TWO buttons on the plug head. Press the TEST button. Y ou will notice a click as the RESET button pops out. Press the RESET button. Again you will notice a click as the button engages. The power supply cord is now supplying electricity to the unit. (On some products this is also indi- cated by a light on the plug head). Groun ...
-
Frigidaire 2020215A0320 - page 3
Record Your Model and Serial Numbers Record in the space provided below the model and serial numbers. On all models, the serial plate is located on the outside of the cabinet. Model No. Serial No. Register Your Product The self -addressed PRODUCT REGISTRA TION CARD should be filled in completely , signed and returned to the Frigidaire Company . Normal Sounds T oday’s high efficiency compressors may have a high pitched chat ter during the cooling cycle. High pitched Chatter Unit may vibrate and mak e noise because of poor wall or window construction or incorrect installation. Vibration Pinging or Swishing Droplets of water hitting condenser during normal operation may cause “pinging or sw ...
-
Frigidaire 2020215A0320 - page 4
4 Before you begin, thoroughly f amiliarize yourself with the control panel and remote as shown below and all its functions, then follow the symbol f or the functions you desire. The unit can be controlled by the touch pad alone or with the remote. ELECTRONIC CONTROL Air Conditioner Features 2009 Electrolux Home Products, Inc. All rights reserved. Operating Instructions NOTE The following instructions represent the T ouch Pad, the same instructions can be used f or the Remote Control. TO TURN UNIT ON: YOU WILL SEE: PRESS ON/OFF BUT TON DO THIS: Air Conditioner Features & Operating Instructions ADJUSTS TEMPERA TURE OR TIME DISPLA YS TEMPERA TURE/TIME SETS F AN SPEED SETS MODE TURNS UNIT O ...
-
Frigidaire 2020215A0320 - page 5
5 Operating Instructions TO CHANGE TEMPERATURE SETTlNG: TO ADJUST FAN SPEEDS: YOU WILL SEE: Note: F an starts at High Speed and adjusts to a slower speeds the room temperature dictates. F or example, if the room doesn't get too warm, it will stay at the slowest speed. If the room temperature rises quickly , such as a door being opened, it will automatically go to the highest speed. The fan speeds will re-adjust back to the slowest speed as the room returns to the original set temperature. Press either the fan slower or fan faster but ton to adjust the fan speed manually . 2009 Electrolux Home Products, Inc. All rights reserved. YOU WILL SEE: PRESS TO RAISE PRESS TO L OWER DO THIS: Note: ...
-
Frigidaire 2020215A0320 - page 6
6 Operating Instructions Operating Instructions (continued) TO OPERATE ON FAN ONLY: YOU WILL SEE: TO USE THE ENERGY SAVER (ECON) FEATURE: YOU WILL SEE: 2009 Electrolux Home Products, Inc. All rights reserved. DO THIS: PRESS MODE BUTTON CHOOSE FAN ONLY CHOOSE ECON Note: In this mode the selected temperature will increase by 2 °F 30 minutes after the mode is selected. The tempe- rature will then increase by another 2 °F after an additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to the originally selected tempera- ture. This ends the "Sleep" mode and the unit will continue to operate as originally programmed. The "Sleep" mode prog ...
-
Frigidaire 2020215A0320 - page 7
7 Operating Instructions Operating Instructions (continued) CHECK FILTER FEATURE, YOU WILL SEE: 2009 Electrolux Home Products, Inc. All rights reserved. DO THIS: PRESS FILTER RESET BUTTON TIMER: DELAY STOP / START FEATURE YOU WILL SEE HOW MUCH TIME IS CHOSEN: FIRST DO THIS: PRESS TIMER BUTTON THEN DO THIS: PRESS UP/DOWN BUTTONS Note: This feature is a reminder to clean the Air Filter (See Care and Cleaning) for more efficient operation. The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the "Filter Reset" button and the light will go off. Note: For Delay Stop, the unit must be in the On position ． Note: For Delay Start, the uni ...
-
Frigidaire 2020215A0320 - page 8
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode. To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Ne xt, use the “ ” buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself ). The LIGHT on the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal. lt will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop butt on. lf the unit does not receive the remote sensing signal ...
-
Frigidaire 2020215A0320 - page 9
9 Operating Instructions Operating Instructions (continued) 2009 Electrolux Home Products, Inc. All rights reserved. ADDITIONAL THINGS YOU SHOULD KNOW Now that you have mastered the operating procedure, here are more features in your control that you should become familiar with . The "Cool" circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time. The control will maintain the set temperature within 2 degrees Fahrenheit, between 60F and 90F degrees. There is a 2-Second delay for the compressor shutting down when selec ...
-
Frigidaire 2020215A0320 - page 10
Care and Cleaning & Energy Saving Ideas 10 2009 Electrolux Home Products, Inc. All rights reserved. Energy Saving Ideas Do not block air flow inside with blinds, curtains or furniture; or outside with shrubs, enclosures, or other buildings. The capacity of the room air conditioner must fit the room size for ef ficient and satisfactory oper ation. Install the room air conditioner on the shady side of your home. A window that faces north is best because it is shaded most of the day . Close the fireplace damper , floor and wall r egisters so cool air does not escape up the chimney and into the duct work. K eep blinds and drapes in other windows closed during the sunniest part of the day . C ...
-
Frigidaire 2020215A0320 - page 11
OCCURRENCE SOLUTION W all plug disconnected. Push plug firmly into wall outlet. Plug Current Device T ripped. Press the RESET button. House fuse blown or circuit breaker tripped. R eplace fuse with time delay type or reset circuit break er . Control is OFF . T urn Control ON and set to desired set ting. Air conditioner will not operate. Air conditioner cooling, but room is too warm - NO ice forming on cooling coil behind decorative front. Dirty air filter - air restricted. Clean air filter . Ref er to Care and Cleaning section. T emper ature is set too high. Set temperature to a lower setting. Air directional louvers positioned improperly . Position louvers for better air distribution. Front ...
-
Frigidaire 2020215A0320 - page 12
Major Appliance Warranty 12 Y our appliance is covered by a full one- year warrant y and a limited 2-5 year warr anty(sealed system). F or one year from your original date of purchase, Electrolux will pay all costs for r epairing or replacing an y parts of this appliance that prove to b e defective in materials or workmanship when such appliance is inst alled, used and maintained in accordance with the provided instructions. From the second to the fifth year from your original purchase date, Electrolux will r epair or replace any parts in the Sealed Refriger ation System (compressor , condenser , evapor ator and tubing) proves to be defectiv e in materials or workmanship. The consumer will b ...
¿Tienes una pregunta acerca de Frigidaire 2020215A0320?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Frigidaire 2020215A0320, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Frigidaire 2020215A0320 probablemente compartirá una forma de solucionarlo.