-
Fisher & Paykel GD50S1 - page 1
F ood waste disposer Installation instructions and user guide NZ GD50S1 ELBA_Wastedisposal_UG.indd 1 10/22/08 6:22:36 PM ...
-
Fisher & Paykel GD50S1 - page 2
ELBA_Wastedisposal_UG.indd 2 10/22/08 6:22:36 PM ...
-
Fisher & Paykel GD50S1 - page 3
1 Safety and warnings 2 Installation instruc tions 3 Operating instruc tions 8 Cleaning and maintenance 9 T r oubleshooting 10 Manufacturer ’ s warranty 11 Customer care 12 Con tents Impor tant! SA VE THESE INSTRUCTIONS The models shown in this user guide may not be available in all markets and are subject to change at any time. For current detai ...
-
Fisher & Paykel GD50S1 - page 4
2 Use this appliance only for its intended purpose as describe d in this User Guide. Impor tant sa fety precautions ! When using this appliance, always use basic safet y precautions, including the following: Danger! This appliance is not intended for the use by children or infirmed persons without super vision. T o reduce the risk of injur y , clos ...
-
Fisher & Paykel GD50S1 - page 5
3 Before you begin Please read these installation instructions completely and carefully . The following installation instructions are intended as a general guide. Please ensure that the waste disposal unit is installed according to local building codes for your area. Installation is recommended to be done by a qualified plumber or installer . Produ ...
-
Fisher & Paykel GD50S1 - page 6
4 1 2 3 4 5 6 7 8 10 9 11 14 13 12 16 17 15 1 2 3 4 5 6 7 8 10 9 11 14 13 12 16 17 15 Installation instruc tions Fig 1. Three Bolt Mount System Fig 1.2. Elbow Unpacking your waste disposer 1 Remove the waste disposer from the packaging. 2 Identify and check that all components are included in the car ton before beginning the installation (fig. 1). ...
-
Fisher & Paykel GD50S1 - page 7
5 Installation instruc tions Installation 1 Loosen the clamp screw to allow the mounting system to be removed (fig.2). 2 T urn the mounting assembly over and remove the flange r ing from the track on the sink flange. Undo the three screws holding it together . This will allow the sink flange, mount ring, and protector ring to separate (fig 3). Use ...
-
Fisher & Paykel GD50S1 - page 8
6 Installation instruc tions 7 Connect the discharge elbow to the lower outlet on the waste disposer (fig. 7). 8 Prior to connec ting the waste disposer to the mounting assembly , press firmly down on the rubber splash guard to check that is firmly fitted onto the neck of the hopper . 9 Lubricate the top lip and angled sur face of the rubber splash ...
-
Fisher & Paykel GD50S1 - page 9
7 Contr olling the waste disposer All elec trical connections MUST be done by a registered electrician. The waste disposer must be connec ted to the power supply by an ear thed 3-pin outlet socket, mounted adjacent to the waste disposer under the sink . W all mounted switch The waste disposer can be controlled by means of a wall mounted power switc ...
-
Fisher & Paykel GD50S1 - page 10
8 Operating instruc tions Operating instruc tions 1 Remove the sink stopper and turn on a medium flow of cold water . Note: Do not use hot water . Only cold water should be run through the waste disposer. 2 Press the wall mounted control switch, or an air switch if fitted, to activate the waste disposer . 3 F eed food items through the sink opening ...
-
Fisher & Paykel GD50S1 - page 11
9 Y our waste disposer is self-cleaning and scours itself with each use. Under normal usage, your waste disposer will not require any special care. Note: Always run cold water into the chamber before, during and after using the waste disposer . Do not use hot water . Removing an odour Grinding up a tray of ice cubes will help to clean the shredding ...
-
Fisher & Paykel GD50S1 - page 12
10 T r oubleshooting tips Problem Possible causes What to do W aste disposer is not star ting No elec tricity at the power outlet Check that the plug is correctly connected and power is turned on Check another appliance at the same outlet Check house fuse F oreign object may be lodged bet ween the turntable and grinding ring T urn power supply and ...
-
Fisher & Paykel GD50S1 - page 13
11 Manufac turer’ s warranty Fisher & Paykel under takes to Repair or , at its option, replace without cost to the owner either for material or labour any par t of the Product, the serial number of which appears on the Product, which is found to be defective within TWO YEARS from the date of purchase. This warranty DOES NOT Cov er A Ser vice ...
-
Fisher & Paykel GD50S1 - page 14
12 Check the things you can do yourself . Refer to your User Guide and check: 1 your appliance is correctly installed 2 you are familiar with its normal operation If after checking these points you still need assistance, please refer to your nearest Authorised Ser vice Centre , or contact us through our local website listed on the back cover . In N ...
-
Fisher & Paykel GD50S1 - page 15
13 ELBA_Wastedisposal_UG.indd 13 10/22/08 6:22:48 PM ...
-
Fisher & Paykel GD50S1 - page 16
Copyright © Fisher & Paykel 2008. All rights reser ved. The product specifications in this book let apply to the specific products and models described at the date of issue. Under our policy of continuous product improvement , these specifications may change at any time. Y ou should therefore check with your Dealer to ensure this booklet corre ...
¿Tienes una pregunta acerca de Fisher & Paykel GD50S1?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Fisher & Paykel GD50S1, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Fisher & Paykel GD50S1 probablemente compartirá una forma de solucionarlo.