-
American Audio XLT1200 - page 1
User Instructions AMERICAN AUDIO ® 6122 S. Eastern Ave. Los Angeles Ca. 90040 1/12 Pr ofessional Power Amplier XL T Series ...
-
American Audio XLT1200 - page 2
This symbol is intended to alert the user to the presence of non insulated "danger ous voltage" within the product's enclosur e that may be of sucient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user of the presence of important operating and maintenance (servicing) instruction ...
-
American Audio XLT1200 - page 3
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. THERE ARE NO USER SERVICEABLE P ARTS INSIDE. REFER ALL SERVICE TO YOUR AUTHORIZED AMERICAN AUDIO ® DEALER. CAUTION Do not open - risk of electric shock FOR OPTIMUM PERFORMANCE AND RELIABILITY DO NOT PRESENT THE AMPLIFIER WITH A SPEAKER LOAD OF LESS THAN 2 OHMS OR ANY COMBINA T ...
-
American Audio XLT1200 - page 4
Important Pr ecautions • T o reduce the risk of electrical shock or r e, do not expose this unit rain or moisture. • Do not spill water or other liquids into or on to your unit. • Do not attempt to operate this unit if the power cord has been frayed or broken. • Do not attempt to remove or br eak o the ground prong fr om the electrica ...
-
American Audio XLT1200 - page 5
1. Indicator LEDs - Channel Protect Indicator - The r ed Protect LED will begin to glow when the channel goes into protect mode. When the channel goes into protect mode all output for that channel will tur n o. This is to protect any speakers connected to the channel. Channel Clip Indicator - This red LED will begin to ash when channel one be ...
-
American Audio XLT1200 - page 6
Rear Panel XL T900 Figure 2 8 17 15 12 11 10 9 13 14 ©American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 6 8. Channels 1 & 2 Speakon Outputs - Optional speaker output connections. Use pins 1+ and 1- of this 4-pole Speakon connector to connect to your speak- er’ s Speakon input jack. 9. Channel 1 & 2 O ...
-
American Audio XLT1200 - page 7
Rear Panel XL T1200, 2000, & 2500 16. Channels 1 & 2 Speakon Outputs - Optional speaker output connections. Use pins 1+ and 1- of this 4-pole Speakon connector to connect to your speak- er’ s Speakon input jack. 17. Channel 1 & 2 Output Jack/5 way Binding Post - Connect to your speak- er’ s input jack. Red is positive signal and Bla ...
-
American Audio XLT1200 - page 8
OUTPUTS: Binding Post - Connect your speakers to the binding post outputs on the rear of the amplier . The speaker wire may be connected by bare wir e (directly connected, usually for permanent connections). Connections are made to Channels 1 and 2 output’ s for ster eo mode or across the r ed terminals of Channels 1 and 2 for Mono Bridge Mode ...
-
American Audio XLT1200 - page 9
©American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 9 Mono Bridge Connections: Mono bridge operation connections will follow the above descriptions however , when operating in mono bridge operation the speaker connections will run between the two positive (red) leads. Use channel two pos- itive output terminal ...
-
American Audio XLT1200 - page 10
©American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 10 SPEAKON ASSEMBL Y : Y ou will need a pair of Neutrik Speakon ® NL4FC connectors. Y ou will also need high-quality two or four conductor speaker cable, a pair of needle-nosed pliers and a 1.5-mm Allen key to assemble the Speakon connectors to your speaker w ...
-
American Audio XLT1200 - page 11
©American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 11 OPERATING MODES : Always configure your amplifier operating mode befor e beginning operation. If you want to change it dur - ing performance. Y ou must decrease the gain contr ols to their lowest levels to protect the speakers fr om any popping noise. Stere ...
-
American Audio XLT1200 - page 12
©American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 12 PROTECTION: Thermal Protection - If the amplifiers operating temperature runs over 105°C (221°F) the amplifier will go into thermal protection to prevent damage fr om over heating. The Protect Indicator LED located on the front of the amp will light up, a ...
-
American Audio XLT1200 - page 13
©American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 13 8-Ohm Loads: The amplifier can operate at practically any power level without risk of overheating. However , if it is pushed hard enough to continually light the “CLIP” indicator , the amplifier’ s average output power can reach 150 watts. 4-Ohm Loads ...
-
American Audio XLT1200 - page 14
©American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 14 TYPICAL MONO BRIDGE SET -UP SPEAKERS 8 OHM MINIMUM TYPICAL STEREO OUTPUT CONNECTIONS SPEAKERS 4 OHM MINIMUM SPEAKERS 4 OHM MINIMUM Use Channel 1 Inputs Only (XLR or 1/4” Jacks) X Use Speakon Connections Use the two positive binding post termainals (red) f ...
-
American Audio XLT1200 - page 15
©American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 15 TYPICAL P ARALLEL SET -UP SPEAKERS 4 OHM MINIMUM SPEAKERS 4 OHM MINIMUM Figure 15 Use Channel 1 Inputs Only (XLR or 1/4” Jacks) Set the Operation Mode switch to Parallel ...
-
American Audio XLT1200 - page 16
American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 16 The XL T Series carries a one year limited warranty . W e recommend you fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must be freight pre-paid and accompany a R.A. (return authorizatio ...
-
American Audio XLT1200 - page 17
XL T Series SPECS Power supply: AC 100V , 50/60Hz (Japan) AC 110V , 60Hz (Colombia) AC 120V , 60Hz (U.S.A. and Canada) AC 127V , 60Hz (Mexico) AC 220V , 50Hz (Chile and Argentina) AC 220V , 60Hz (Philippines and Korea) AC 230V , 50Hz (Europe, New Zealand, South Africa, and Singapore) AC 240V , 50Hz (Australia and U.K.) MODEL: XL T 900 (Class AB) XL ...
-
American Audio XLT1200 - page 18
XL T Series SPECS Power supply: AC 100V , 50/60Hz (Japan) AC 110V , 60Hz (Colombia) AC 120V , 60Hz (U.S.A. and Canada) AC 127V , 60Hz (Mexico) AC 220V , 50Hz (Chile and Argentina) AC 220V , 60Hz (Philippines and Korea) AC 230V , 50Hz (Europe, New Zealand, South Africa, and Singapore) AC 240V , 50Hz (Australia and U.K.) MODEL: XL T 2000 (Class H) XL ...
-
American Audio XLT1200 - page 19
American Audio® - www .americanaudio.us - XL T Series Power Amplifier User Manual Page 19 Notes ...
-
American Audio XLT1200 - page 20
©American Audio® W orld Headquarters: 6122 S. Eastern Ave. Los Angeles, CA 90040 USA T el: 323-582-3322 Fax: 323-725-6100 W eb: www .AmericanAudio.us E-mail: info@americanaudio.us American DJ Europe Junostraat 2 6468 EW Kerkrade Netherlands service@americandj.eu / www .americandj.eu T el: +31 45 546 85 00 / Fax: +31 45 546 85 99 ...
¿Tienes una pregunta acerca de American Audio XLT1200?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con American Audio XLT1200, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con American Audio XLT1200 probablemente compartirá una forma de solucionarlo.