-
Hayter Mowers 446E - page 1
Operator ’ sManual R48 Recycling Mower G008079 Code 445E, 446E, 447E Serial No. 280R00001, 280S00001,or 280T00001 and Up Manual Part No. 1 1 1-2087 Rev B ...
-
Hayter Mowers 446E - page 2
Introduction R ead this infor mation carefully to learn ho w to operate and maintain your product properly and to av oid injur y and product damage. Y ou are responsible for operating the product properly and safely . Whenever you need ser vice, g en uine par ts , or additional infor mation, contact an A uthorized Service Dealer and hav e the model ...
-
Hayter Mowers 446E - page 3
Safety Improper ly using or maintaining this mower can result in injur y . T o reduce the potential for injur y , comply with these safety instr uctions. This mow er was designed and tested for reasonably safe ser vice; howev er , failure to comply with the following instr uctions ma y result in personal injury . T o ensure maximum safety , best pe ...
-
Hayter Mowers 446E - page 4
– Do not mow ex cessi v ely steep slopes . – Exercise extreme caution when on slopes . – Mow across the face of slopes , never up and down and exercise extreme caution when changing direction on slopes . – Alwa ys be sure of your footing on slopes . • Use lo w throttle settings when engaging the traction-clutch, especially in high gears . ...
-
Hayter Mowers 446E - page 5
Safety and Instructional Decals Important: Safety and instr uction decals are located near areas of potential danger . Replace damaged decals. Manufacturer ’ s Mark 1. Indicates the blade is identied as a part from the original machine manufacturer . 1 10-7058 1. Height of cut 1 10-7059 Model 447E only 1. Read the Operator ’s Manual. 4. Inst ...
-
Hayter Mowers 446E - page 6
Setup Unfolding the Handle 1. Unlock the handle locks , mov e the handle sections into the operating position, and lock the handle locks (Figure 3). Figure 3 2. Unlock the upper handle loc ks and rotate the upper handle upward and lock it into a position that is comfortable to you (Figure 4). Figure 4 1. Highest position 3. Lowest position 2. Middl ...
-
Hayter Mowers 446E - page 7
Installing the Fuse (Model 447E Only) Y our mo wer comes with a 40-amp fuse that protects the electric star ter . Important: Y ou cannot start the mower with the electric star ter or charge the batter y unless y ou install the fuse. 1. R emov e the battery co ver and the battery and locate the fuse holder (Figure 7). Figure 7 1. Screw 3. Fuse holde ...
-
Hayter Mowers 446E - page 8
Product Overview G008078 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Figure 9 Model 447E shown 1. Lower handle lock 9. Oil ll/Dipstick (not shown) 2. Grass bag 10. Fuel tank cap 3. Upper handle lock 1 1. Cutting height lever (2) 4. Recoil start handle 12. Spark plug 5. Upper handle (Models 446E and 447E only) 13. Primer 6. Blade control bar 14. Air l ...
-
Hayter Mowers 446E - page 9
detergent oil with an API ser vice classication of SF , SG , SH, SJ , SL, or higher .) 3. Install the dipstic k. Adjusting the Cutting Height Adjusting the cutting height may bring y ou into contact with the moving blade, causing serious injur y . • Stop the engine and w ait for all moving par ts to stop . • Do not put y our nger s under ...
-
Hayter Mowers 446E - page 10
Figure 15 4. If the mower does not start in 1 or 2 pulls (or within 5 seconds using the electric starter), press the primer button 1 or 2 times and try starting it again. Note: If the mower still does not star t, contact an Authorized Ser vice Dealer . Using the Self-propel Drive (Models 446E and 447E Only) T o operate the self-propel dri ve , simp ...
-
Hayter Mowers 446E - page 11
T o bag the grass clippings , install the grass bag (refer to Installing the Grass Bag) and mo v e the R ecycling/bag ging lev er to the bagging mode (Figure 18). Installing the Grass Bag Raise and hold up the rear door , install the bag, and low er the rear door (Figure 19). G008083 Figure 19 Removing the Grass Bag T o remo v e the bag, rev erse t ...
-
Hayter Mowers 446E - page 12
W et grass or leav es can cause serious injur y if y ou slip and contact the blade. Mow only in dr y conditions. • Alternate the mowing direction. This helps disperse the clippings o ver the lawn for even fertilization. • If the nished la wn appearance is unsatisfactory , tr y one or more of the follo wing: – R eplace the blade or ha v e i ...
-
Hayter Mowers 446E - page 13
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Interval Maintenance Procedure After the rst 5 hours • Change the engine oil. Before each use or daily • Check the engine oil level. • Ensure that the engine stops within 3 seconds after releasing the blade control bar . • Clean the mower . Every 25 hours • Charge the ...
-
Hayter Mowers 446E - page 14
Lubrication Lubricating the Wheel Gears Ser vice Inter v al: Y early—Lubricate the wheel gears . 1. R emov e the wheel bolts on the rear wheels and remov e the rear wheels . 2. Apply a lubricating oil to the gear as sho wn in Figure 22. Figure 22 3. Install the rear wheels . Engine Maintenance Replacing the Air Filter Ser vice Inter v al: Y early ...
-
Hayter Mowers 446E - page 15
Figure 24 4. Slowly pour oil into the oil ll tube until the oil level reaches the Full line on the dipstic k (Figure 6). Do not o v erll. (Max. ll: 0.59 l, type: SAE 30W detergent oil with an API service classication of SF , SG , SH, SJ , SL, or higher .) 5. Install the dipstick securely . 6. Dispose of the used oil properly at a local ...
-
Hayter Mowers 446E - page 16
Drive System Maintenance Adjusting the Self-propel Drive If y our mo wer does not self-propel properly , adjust the self-propel driv e cable. 1. Loosen the n ut on the cable mount (Figure 26). Figure 26 1. Nut on cable mount 2. Pull the upper handle bac k fully rearw ard (Figure 27). Figure 27 3. Pull the cable jack et downward until you remov e th ...
-
Hayter Mowers 446E - page 17
Blade Maintenance Replacing the Blade Ser vice Inter v al: Ev ery 25 hours—R eplace the blade or hav e it sharpened (more frequently if the edge dulls quic kly). Important: Y ou will need a torque wr ench to install the blade pr oper l y . If y ou do not ha ve a torque wrench or are uncomfor ta ble perfor ming this procedure, contact an Authoriz ...
-
Hayter Mowers 446E - page 18
Cleaning Cleaning the Mower Ser vice Inter v al: Before each use or daily—Clean the mow er . Tipping the mo wer may cause the fuel to leak from the carburetor or the fuel tank. P etrol is extremely ammable, highly explosi ve, and under certain condition can cause per sonal injur y or proper ty damage. Run the engine dr y or remov e the fuel wi ...
-
Hayter Mowers 446E - page 19
Notes: 19 ...
-
Hayter Mowers 446E - page 20
Notes: 20 ...
-
Hayter Mowers 446E - page 21
1st Y ear (12 months) W e certify that this service has been carried out by an Authorised Hayter Service Dealer Date: 1st Y ear (12 months) Owner’s Name: Serial Number: Date: 2nd Y ear (24 months) W e certify that this service has been carried out by an Authorised Hayter Service Dealer Date: Owner’s Name: Serial Number: Date: Note for dealer : ...
-
Hayter Mowers 446E - page 22
...
-
Hayter Mowers 446E - page 23
LIMITED WARRANTY Hayter Limited warrants to the original user/purchaser that this unit shall be free from defects in material and workmanship under normal use and service for a period of three years from the date of purchase. The manufacturer of major proprietry components ie. engines, gearbox / transaxle (where applicable) furnish their own warran ...
-
Hayter Mowers 446E - page 24
CUS T OME R INFO RMA TI ON Date of Sale:- Y our Local Dealer:- HA Y TER L IM ITED , SPEL L BR OO K, BI SHOP ’S S T OR TF ORD , H E R T S . C M 23 4B U, E N G L A N D Code Serial No. ...
¿Tienes una pregunta acerca de Hayter Mowers 446E?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Hayter Mowers 446E, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Hayter Mowers 446E probablemente compartirá una forma de solucionarlo.