-
Lennox Hearth 1000 - page 1
Report No. 317-F-10-5 IN ST AL LA TI ON AN D OP ER A TIO N MA NU AL Do not store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance. WHA T TO DO IF YOU SMELL GAS • Do not light any appliance. • Do not touch any electrical switches; do not use any phone in your building. • Immediately call your ...
-
Lennox Hearth 1000 - page 2
2 1. 0 IM P OR T AN T SA FE TY A ND W AR NI NG IN FO RM A TI ON W ARNINGS If th e info rmat ion in th is man ual is not fo l- low ed ex actl y , a fire or ex plo sion ma y resu lt cau sin g pro per ty da mag e, pe rso nal inju ry or los s of lif e. IMPOR T ANT Rea d and unde rst and the se inst ruc tion s c ompl etel y bef ore in sta llin g or ope ...
-
Lennox Hearth 1000 - page 3
3 2.0 GENERAL INFORMA TION This appliance is a high efficiency , unvented, flame effect gas heater . It provides radiant and convected warmth both efficiently and safely utilizing the latest type catalytic convertor burner technology . The appliance does not require a flue system of any type as the catalytic converter cleans the flue products ...
-
Lennox Hearth 1000 - page 4
4 6.0 BURN-IN PERIOD On initial light up of a new appliance, the ‘newness’ will burn off within the first few hours of operation. During this period some smoke may be emitted from outlet grill, this should be no cause for concern. Accord- ingly , the room should be well ventilated with all windows and doors open during this period. Depending o ...
-
Lennox Hearth 1000 - page 5
5 8.0 COMBUSTION AND VENTILA TION AIR This heater shall not be installed in a confined space or unusually tight construction unless provisions are provided for adequate combustion and ventil ation air . The heater may be located in unusually tight construction provided the space is unconfined, or if confined, is provided with two permanent openi ...
-
Lennox Hearth 1000 - page 6
6 9.0 SITE REQUIREMENTS This appliance is designed to be wall-hung. Do not recess any part of the appliance into the wall. This appliance may be installed in any room in a home except bathrooms - or areas where large amounts of steam are likely to be generated. This appliance is approved for installation into a bedroom . It should be noted that hea ...
-
Lennox Hearth 1000 - page 7
7 Non-concealed gas connections may be made using the entry points at either end of the firebox or the one in the bottom of the firebox. A concealed gas connection may be made using the knock out hole in the center back of the firebox. Select the most appropriate entry point and knock out the relevant hole in both the firebox and the outer casi ...
-
Lennox Hearth 1000 - page 8
8 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE After having selected the final mounting position of the appliance, taking into account the site requirements as specified in these instructions, the integrity of the wall, and the feasibility of the proposed supply pipe routing, the firebox of appliance may be secured to the wall. 12.0 MOUN ...
-
Lennox Hearth 1000 - page 9
NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 9 It is recommended that the burner height, where possible, should be approximately 4 ft. from the floor . This will give the best viewing position. When selecting the height, ensure that the clearance to the ceiling is 32" minimum, as specified on Page 6 . After selecting the final mounting ...
-
Lennox Hearth 1000 - page 10
10 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 14.0 CHECKING THE BURNER There are no imitation fuel bed components, such as logs or rocks, to install. The appliance features a ribbon burner which is designed to produce a continuous band of flame over its length. The burner should be visually inspected to ensure it is free from any foreign ...
-
Lennox Hearth 1000 - page 11
NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 11 16.0 CHECKING THE GAS CONNECTIONS T urn on gas supply and test for gas leaks using a gas leak test solution (also referred to as bubble leak solution). NOTE: using a soapy water solution (50% dish soap, 50% water) is an effective leak test solution, but it is not recommended, because the soap ...
-
Lennox Hearth 1000 - page 12
12 18.0 SP ARK GAP The gap between the spark electrode and the pilot should be 1/8” to 3/16” to produce a good spark. There should be no need to adjust this (DO NOT A TTEMPT TO ADJUST THE GAP). If under any circumstances the piezo electric spark fails, the pilot cannot be lit manually . 19.0 BRIEFING THE CUSTOMER W ARNING Do not add logs or orn ...
-
Lennox Hearth 1000 - page 13
13 W ARNING Any cha nge to this hea ter or its con trol s ca n be dan ger ous. W ARNING No ad just men ts are to be ma de to the OD S pilo t sy st em . T amp er in g wi th thi s sys te m ca n be ext re me ly haz ard ous. W ARNING Y ou mu st ke ep con tro l are as, bu rne rs and circ ulat - ing a ir pass age ways of ap pli ance cl ean . Fai lure t o ...
-
Lennox Hearth 1000 - page 14
14 NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 21.0 CA T AL YSTS W ARNING Do not blo ck the cat aly sts or the app lia nc e out le t gr ill . Blo cka ge may cau se hig h car bon mono xid e lev els and /or bre akag e o f th e gl ass doo r as sem bly . It is recommended that the catalysts are inspected for signs of damage and dirt during rou ...
-
Lennox Hearth 1000 - page 15
15 FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTL Y , A FIRE OR EXPLOSION MA Y RESUL T CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lit with a piezo spark igniter . When lighting the pilot, follow these instructions exactly . B. BEFORE OPERA TING ...
-
Lennox Hearth 1000 - page 16
16 24.0 TROUBLESHOOTING GUIDE PROBLEM CORRECTIVE ACTION Igniter sparks but pilot does not light • No gas to Pilot, check the gas line connections. • Air not fully purged. Purge supply or wait longer . • Spark grounding to metal work, reset gap correctly . • Blocked pilot, clean out internally . Pilot lights but then goes out • Severe rest ...
-
Lennox Hearth 1000 - page 17
17 25.0 REPLACEMENT P ARTS - X-FIRES-1000 5 4 15 Hardware NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE 12 1 2 5 6 7 8 10 11 13 14 See ordering instructions on Page 20 WARNING CLEARANCES FROMCOMBUSTIBLE MATERIALS F860041/A The following clearances must be maintained at all times. Failure to do so may result in the risk of a fire. For full i ...
-
Lennox Hearth 1000 - page 18
18 26.0 POSITIONING OF FIELD REMOV ABLE P ARTS W ARNING Fai lur e to posi tion the par ts in acc ord ance wi th the se diag ram s or fai lur e to use onl y pa rts spe cifi- cal ly a ppro ved with this heat er may res ult in prop erty dama ge or per sona l in jury . Figure 13 4 off burner installation positions Figure 12 Glass Door Removal: Remove ...
-
Lennox Hearth 1000 - page 19
19 27.0 SPECIFICA TIONS NOTE: DIAGRAMS & ILLUSTRA TIONS ARE NOT TO SCALE X-FIRE-1000 Surround Kits Cat. No. Model Description S hi p . W t . Ship. Volume H7226 X-FIRE-1000-L Limestone Surround 5 5 l b . 4. 5 8 c u . f t . H7227 X-FIRE-1000-G Granite Surround 5 5 l b . 4. 5 8 c u . f t . 39-7/16” 11-1/4” 25-1/4” 21-3/16” 15-3/4” 23-3/4 ...
-
Lennox Hearth 1000 - page 20
Printed in U.S.A. © 2007 Lennox Hearth Products P/N 506023-01 REV . B 11/2008 Lennox Hearth Products reser ves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products. Consult your local distributor for fireplace code information. WARRANTY Y our gas a ...
¿Tienes una pregunta acerca de Lennox Hearth 1000?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Lennox Hearth 1000, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Lennox Hearth 1000 probablemente compartirá una forma de solucionarlo.