Español dropdown-ico

Manual de instrucciones Hobart 1HF50D

24 de páginas 1.43 mb
Descargar

Pasar a la página of 24

Summary
  • Hobart 1HF50D - page 1

    INSTALLATION & OPERATIONAL MANUAL 1HFD & HFC SERIES ELECTRIC FRYERS With KleenScreen PLUS ® Filtration Systems MODELS: 1HF50D ML-136500 1HF85CF ML-136819 1HF85CF Shown - Computer Control ENERGY STAR® Qualified For additional information on Hobart or to locate an authorized parts and service provider in your area, visit our website at www. ...

  • Hobart 1HF50D - page 2

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -2- IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRIC EQUIPMENT, WHO SHOULD PER FORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABL ...

  • Hobart 1HF50D - page 3

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -3- TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY……………………………… ………. 2 INTRODUCTION…………………… …………………………………… … 4 GENERAL…………………………… ……………………………… 4 ORDERING PARTS…? ...

  • Hobart 1HF50D - page 4

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -4- INTRODUCTION GENERAL Hobart Fryers are produced wit h quality workmanship and mate rial. Proper installation, usage and maintenance will result in year s of satisfactory performance. Before installing the fryer, thoroughly read th is manual and carefully fo llow all instructio ...

  • Hobart 1HF50D - page 5

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -5- Do not use the door or its handle to lift the fryer. MODEL - GMO Kw per Fry Tank Width Inch (cm) Total System Shortening lbs. (kg) Each Fry Tank 1HF50D 17 15.5" (39) 50 (23) 1HF85CF 24 21.0" (53) 85 (39) Voltage ranges are: 208, 3 Phase - 50 – 60 Hz 240, 3 Phase - ...

  • Hobart 1HF50D - page 6

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -6- CODES AND STANDARDS The fryer must be instal led in accordance with: In the United States:  State and local codes, or in the absence of local codes, with:  National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The National Fire Protection A ...

  • Hobart 1HF50D - page 7

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -7-  Australia, use only the caster suppl ied by the manufactu rer for the fryer device. The fryer must be installed usi ng a hose assembly restraining device to limit the movement of the appli ance in accordance with AS1869.  The fryer must be installed with a connector (no ...

  • Hobart 1HF50D - page 8

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -8- LEVELING THE FRYER Check the level of the fryer by placing a level on top of the fr yer after electrical connections have been made. Ensure that the fryer is level front-to-back and side-to-side in the final installed position. If using casters, lock the wheels after unit is l ...

  • Hobart 1HF50D - page 9

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -9-  Wipe tank completely dry with a soft, clean cloth. FILLING TANK WITH SHORTENING  Close the drain valve.  Fill the fryer tank with shortening. Hobart recommends using liquid shortening.  Shortening level should be between the MIN and MAX lines in the fryer tank. ? ...

  • Hobart 1HF50D - page 10

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -10-  Batter covered foods should be dropped carefully , one by one, into shortening or basket. If you use the basket, first dip the basket into the shortening to reduce batter-build up on basket surfaces.  When frying is completed, remove ba sket or product. Hang basket on ...

  • Hobart 1HF50D - page 11

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -11- Programming the Solid State Control ...

  • Hobart 1HF50D - page 12

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -12- Programming the Computer Control ...

  • Hobart 1HF50D - page 13

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -13- TURNING OFF THE FRYER  Open the door to the fryer. Press t he power switch to the OFF position. EXTENDED SHUTDOWN 1. Open the door to the fryer. Press the power switch to the OFF position. 2. Thoroughly drain the fryer. Refer to DRAINING THE FRYER. 3. Clean the fryer accor ...

  • Hobart 1HF50D - page 14

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -14- DRAINING THE TANK 1. Open the door to the fryer. The power must remain ON for the fryer to filter correctly. 2. Insert the drain extension into t he drain valve. Tighten only hand tight. 3. Direct the drain spout into the container that you want to drain the shortening into. ...

  • Hobart 1HF50D - page 15

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -15- 9. Drain the tank according to DRAINING TH E TANK. Rinse thoroughly with clear, hot water. All traces of cleaner must be removed. Dry the tank thoroughly. 10. Close the drain valve and add shorteni ng. Follow the FILLING TANK WITH SHORTENING procedure in this manual. The frye ...

  • Hobart 1HF50D - page 16

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -16- KleenScreen Plus ® Filtration System Installation and Operational Manual for “HFF” Models 1HF85CF Shown Electric KleenScreen PLUS® Models 8 1HF85CF ML-136819 ...

  • Hobart 1HF50D - page 17

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -17- Filtering Instructions for KleenScreen PLUS ® Fryers General The KleenScreen PLUS ® filtration system filters the oil as it is pumped back into its’ respective tank(s). Only one tank can be drained and filter ed at a time. Under no circumstances should both tanks be drain ...

  • Hobart 1HF50D - page 18

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -18- Fully assembled filter screen assembly: F i g . 2 Secure Tube with Suction Tube Clip Filter Screen Lays Flat On Bottom of Filter Pan Fig. 3 Micro-Filtration Fabric Envelope Assembly: Same Suction Tube F a b r i c E n v e l o p e I n s e r t (Different from Screen Assembly) Fa ...

  • Hobart 1HF50D - page 19

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -19- INSTRUCTIONS TO REMOVE & REPLACE KLEENSCREE N PLUS ® FILTER ENVELOPE FOR ABSOLUTE FILTRATION & MAXIMUM FLOW RATE WE RECOMME ND YOU CHANGE YOUR FI LTER ENVELOPES AT EVERY OIL CHANGE (10-14 DAYS DEPENDING ON OIL USAGE). Step 1 Discard all oil from the filter vessel, (s ...

  • Hobart 1HF50D - page 20

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -20- Operation Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer. Spilling hot frying compound can cause severe burns. Do not move fryer wi thout draining all frying compound from the tank. Never run water or boil out solution thr ough fi ...

  • Hobart 1HF50D - page 21

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -21- Filtering Instructions for KleenScreen PLUS ® Fryers with Computer Controls ...

  • Hobart 1HF50D - page 22

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -22- FILTERING TIP: Open the filtering drawer approximately 1” to allow any oil in the re turn line to run back into the filter pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter components. REMOVING EXCESS DEBRIS FROM THE SCREEN FI ...

  • Hobart 1HF50D - page 23

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -23- BOIL OUT PROCEDURE: Use the Boil Out By-Pass™ drai n extension allowing the boil out solution to exit the fry t ank without using the filtering system. Do not allow water to run through the motor / pump. Drain the boil out solution into a bucket or place a hose on the end o ...

  • Hobart 1HF50D - page 24

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -24- MAINTENANCE Hot oil and hot parts can cause burns. Use care when operating, cleani ng, and servicing the fry er. Spilling hot fryer com pound can cause severe burns. Do not move fryer without draining all frying com pound from the tank. Service in the US and Canada Contact yo ...

Fabricante Hobart Categoría Clothes Dryer

Los documentos del dispositivo Hobart 1HF50D que obtenemos del fabricante se pueden dividir en varios grupos. Entre ellos están::
- dibujos técnicos Hobart
- manuales de instrucciones 1HF50D
- hojas de producto Hobart
- folletos informativos
- o etiquetas energéticas Hobart 1HF50D
Todos son importantes, pero lo más importante desde el punto de vista del usuario de un dispositivo lo encontraremos en el manual de instrucciones Hobart 1HF50D.

Un conjunto de documentos determinado como manual de instrucciones se divide también en tipos más detallados, tales como: instrucciones de montaje Hobart 1HF50D, instrucciones de servicio, instrucciones cortas o instrucciones de usuario Hobart 1HF50D. Dependiendo de la situación debes buscar el documento que necesitas. En nuestra página puedes consultar el manual de instrucciones más popular del producto Hobart 1HF50D.

Manuales de instrucciones parecidos

El manual de instrucciones del dispositivo Hobart 1HF50D, ¿cómo debería ser?
El manual de instrucciones, también determinado como el manual de usuario o simplemente instrucciones, es un documento técnico que tiene como objetivo ayudar a los usuarios a utilizar Hobart 1HF50D. Las instrucciones normalmente las realiza un escritor técnico pero en un lenguaje comprensible para todos los usuarios de Hobart 1HF50D.

El manual de instrucciones completo de Hobart debe contener unos elementos básicos. Una parte de ellos es menos importante, como por ejemplo: la portada / la página principal o las páginas de autor. Sin embargo, lo demás debe facilitarnos la información más importante desde el punto de vista del usuario.

1. Introducción y pistas sobre cómo orientarse con el manual Hobart 1HF50D - Al principio de cada manual se deben encontrar las indicaciones acerca de la manera de usar un manual de instrucciones. Debe contener información sobre dónde encontrar el índice Hobart 1HF50D, preguntas frecuentes o problemas más comunes – son los apartados más buscados por los usuarios de cada manual de instrucciones.
2. Índice - listados de todos los consejos acerca de Hobart 1HF50D que encontraremos en el documento
3. Consejos de uso de las funciones básicas del dispositivo Hobart 1HF50D - que deben facilitarnos los primeros pasos durante el uso de Hobart 1HF50D
4. Troubleshooting - una secuencia sistematizada de acciones que nos ayudará a diagnosticar los problemas más importantes con Hobart 1HF50D
5. FAQ - las preguntas frecuentes
6. Datos de contacto Información acerca de cómo encontrar los datos de contacto del fabricante / servicio de Hobart 1HF50D en cada país si no somos capaces de solucionar el problema por nuestra cuenta.

¿Tienes una pregunta acerca de Hobart 1HF50D?

Utiliza el formulario que se encuentra abajo

Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Hobart 1HF50D, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Hobart 1HF50D probablemente compartirá una forma de solucionarlo.

Copia el texto de la imagen

Captcha
Nueva imagen

Comentarios (0)