-
Jensen BT360 - page 1
i JENSEN BT360 B B l l u u e e t t o o o o t t h h C C a a r r K K i i t t U U s s e e r r ’ ’ s s M M a a n n u u a a l l Installation and User Manual ...
-
Jensen BT360 - page 2
...
-
Jensen BT360 - page 3
Bluetooth C ar Kit Use r Manu al i Preface This publication, includin g all photogra phs, illustrations and soft ware, is protected under international copyright la ws, with all rights reserved. Neither this manual, nor any of the material contained herei n, ma y be reproduced without the express written consent of the manufacturer. Version 2.0, Ma ...
-
Jensen BT360 - page 4
ii Perface ....................................................................................................................... i Identify ing co mponents ...................................................................................... 1 Installing the jun c tion box ......................................................................... ...
-
Jensen BT360 - page 5
Bluetooth C ar Kit Use r Manu al 1 I I n n s s t t a a l l l l a a t t i i o o n n This section demonstrates how to set up and install the Bluetooth Wireless Car Kit into a vehicle. Identifying components Unpack the Car Kit package and ensure the following items are included. Remote Control Part # 31102000 Microphone Part # 31092440 Junction box Pa ...
-
Jensen BT360 - page 6
2 Installing the junction box This Car Kit is designed to work with a 12 - 24-volt vehicl e power supply. Refer to the following to install the junction box in a vehicle. 1. Locate a suitable place inside the car to mount the jun ction box. Select a dry place that avoids excessive heat and mechanical vibration. Ideally, the junction box sho uld be ...
-
Jensen BT360 - page 7
Bluetooth C ar Kit Use r Manu al Connecting the power supply The following illustration demonstrates how to connect the Car Kit’s power cabl es to the ve hi cle’s electrical system. Red cable To battery + 12/24V Blue cable To i g nition Black cable GND Power cables Yellow cable To car ra dio mute ( NPN 300mA ) Important! The Blue cable must be ...
-
Jensen BT360 - page 8
Connecting Components The following illustration shows wher e to connect the devices. Do not connect the components until you h ave followed the next steps and have finalized your installation. Ò CONNECT THE POWER HARNESS LAST. Junction b ox Speaker Microphone Control Module Control Module The control module sho uld be located within reach and vie ...
-
Jensen BT360 - page 9
Bluetooth C ar Kit Use r Manu al 5 Installing the Components Before installing the components, take n ote of the followin g: • Make sure that the cables can rea ch from the each component to the Junction Box. If the cable is too short, relocate the component. Do not lengthen the cable. • The supplied microphone is uni-directional. For be st res ...
-
Jensen BT360 - page 10
Installing the remote control Find a suitable place for remote control that will provide the best visibility. Remove dust and grease from the surf ace and firmly press BT360 control in place with the sticker pads provided. 6 ...
-
Jensen BT360 - page 11
Bluetooth C ar Kit Use r Manu al 7 G G e e t t t t i i n n g g S S t t a a r r t t e e d d I I n n t t r r o o d d u u c c t t i i o o n n The Bluetooth Wireless Car Kit is desig ned to help make your driving experience more convenient, safe, and provide you with years of trouble free use. Product overview and features This Car Kit is designed to m ...
-
Jensen BT360 - page 12
8 If you have a question about your phones features refer to the owner’s manual of your ph one. This Bluetooth Kit uses the latest Ve rsion of Bluetooth Software. Version 2.1. In the case of an upg raded software version for ne w phones in the future you can obtain the software upgrad e instructions and software a t WWW. JENSEN.COM. The BT360 is ...
-
Jensen BT360 - page 13
Bluetooth C ar Kit Use r Manu al Using the remote control The BT360 is operated using a wired remote control: Control Module Functions Volume Up/Down Press during operation to increase or l ower the volume. Answer/ Dial Last Call Press to answer a call. For call waiting, press to ans wer a second call during a call. Press agai n to return to the fi ...
-
Jensen BT360 - page 14
End/ Voice Dial Press to reject / disconnect a call. Press and hold for t wo seconds to activate the Voice Recognition function. After the tone, say the name and the phone will automaticall y dia l. Note: The voice dial function works only when the mob il e phone supports this function. OLED Display Display’s caller ID, FM Transmitter Frequen cy, ...
-
Jensen BT360 - page 15
Bluetooth C ar Kit Use r Manu al 2. Press and hold the Answer/redial and End/Voice dial buttons at the same time fo r 3 seconds until you hear a tone a nd the Display shows “pairing”. 3. Be sure Bluetooth is enabled on your phone. Follow the documentation provided with y our phone to search for new devices. 4. Select the BT360 from the list of ...
-
Jensen BT360 - page 16
Operation with multiple paired phones 12 . When the ignition is turned on the BT360 begins to search for paired phones. Priority is given to the most recently connecte d phone Example: Phone A is connected first, ph one B is connected second and phone C is connected third. If all three phones are in the car when the ignition is tu rned on phone C w ...
-
Jensen BT360 - page 17
Bluetooth C ar Kit Use r Manu al The car kit only connects to one phone at a time. However, it can be paired with up to 4 phones. Using Master Reset function will delete all pairings. To reset press and hold the Volume up and do wn keys at the same time. Continue holding the buttons until you hear a tone. After master reset, all the paired setting ...
-
Jensen BT360 - page 18
Note 1: The display will not show Incoming Call 2 during the call, but you will hear a waiting tone so you remember there is anothe r call waiting. Note 2: To transfer a privacy call from your phone to the BT360 follow the instructions provided with you r phone. Setting the FM Transmitter Mode for A2DP a. Press the Play/Pause key for 3 seco nd s to ...
-
Jensen BT360 - page 19
Bluetooth C ar Kit Use r Manu al Eg: (3 secs) Æ or to adjust Æ confirm d. The BT360 can memorize 3 FM channel s. When playing mu sic, first enter the FM mode, then press the Play/Pause key on e time to view the 3 set stations you have selected, M1, M2, M3. NOTE: The music will be muted automatically when a calls co mes in. Calls are hear d only t ...
-
Jensen BT360 - page 20
Voice Dialing Press and hold the End Key “ ” to activate the voice dial Eg: Nokia N95 Voice Dial Note: Voice dialing MUST be suppo rted by your phone to use this feature. Multimedia Function Using the Multimedia buttons to Play, Pause, Stop an d jump to Next or Previous song. Note: For so me mobile phones, us ers will need to turn on the MP3 be ...
-
Jensen BT360 - page 21
Bluetooth C ar Kit Use r Manu al 17 to re-record the voice tag while you are in the car. This will set not only the way you say the voice tag, but also record a famili ar background noise. Since phones are in continual co ntac t with the Car Kit, it is possibl e to use the included Car Kit’s microphone to reco rd the voice tag. Locate the feature ...
-
Jensen BT360 - page 22
BT Update USB MODE After upgrading, please turn the unit off and on again by turning yo ur cars ignition on and off. 18 ...
-
Jensen BT360 - page 23
Bluetooth C ar Kit Use r Manu al 19 Troubleshooting My mobile phone can’t make a connectio n. • Make sure the bluetooth functio n on your phone is enabled. • Make sure the car ignitio n is on. If on and no power check the fuses and wiring. • Reset the Ca r Kit and try again. • Turn your ph one off and on again, and try the proceedure for ...
-
Jensen BT360 - page 24
Warranty Information This Warranty is in lieu of all other e xpress warranties or liabilities. ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO TH E DURATION OF THIS WRITTEN WARRANTY. ANY ACTION FOR BREACH OF ANY WARRANTY HEREUNDER INCLUDING AN Y IMPLIED WARRANTY OF MERCHANTABILITY MUS T BE BROUGHT WITH ...
-
Jensen BT360 - page 25
Bluetooth C ar Kit Use r Manu al © 2009 Audiovox Electronics Corp., 150 Marcu s Blvd., Hauppauge, N.Y. 11788 21 ...
¿Tienes una pregunta acerca de Jensen BT360?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Jensen BT360, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Jensen BT360 probablemente compartirá una forma de solucionarlo.