-
Poulan 192030 - page 1
OWNER'S MANUAL MODEL NUMBER: PP5524ESC SNO W THR O WER Alwa ys W ear Eye Pr otection During Operation IMPOR T ANT MANU AL Do Not Thr ow A way W ARNING: Read the Owner's Manual and fol low all W arnings and Safety In struc tions. F ail ure to do so can result in serious injury . 192030 07.29.04 BY Printed in U.S .A. ...
-
Poulan 192030 - page 2
2 Safe Operation Practices f or Snow Thrower s IMPORT ANT : This machine is capable of amputating hands and f eet and throwing objects. F ailure to obser v e the following saf ety instr uctions could result in serious injur y or death. SAFETY R ULES W ARNING: This snow thro wer is for use on sidewalks, drivewa ys and other ground le vel surfaces. C ...
-
Poulan 192030 - page 3
3 PR ODUCT SPECIFICA TIONS Gasoline Capacity 3.5 Quar ts and T ype: Unleaded Regular only Oil T ype SAE 30 (abov e 40°F) (API SG–SL): SAE 5W -30 or 10W -30 (0° to +40°F) SAE 0W -30 (below 0°F) Oil Capacity: 21 Ounces Spark Plug: Champion RN4C (Gap: .030") • Do not put hands or feet near or under rotating par ts . K eep clear of the dis ...
-
Poulan 192030 - page 4
4 P AR TS P A CKED SEP ARA TEL Y IN CAR T ON MAINTENANCE ..................................................... 14-15 MAINTENANCE SCHEDULE ..................................... 14 SER VICE AND AD JUST MENTS ........................... 16-18 ST ORA GE ................................................................... 18 TROU BLE SHOOT ING .......... ...
-
Poulan 192030 - page 5
5 ASSEMBL Y / PRE-OPERA TION Read these instructions and this man u al in its entirety bef ore you attempt to assemble or operate y our new sno w thrower . Y our new snow thro wer has been as sem bled at the f actor y with the e x cep tion of those par ts left unassembled f or shipping pur poses . All par ts such as nuts , washers, bolts, etc., nec ...
-
Poulan 192030 - page 6
6 ASSEMBL Y / PRE-OPERA TION INST ALL A UGER CONTROL R OD (See Figs. 5 and 6) The auger control rod has the shor t loop on the end of the spring as shown. 1. Slide rubber slee ve up rod and hook end of spring into control ar m with loop opening up as sho wn. 2. With top end of rod positioned under r ight side of control panel, push down on rod and ...
-
Poulan 192030 - page 7
7 ASSEMBL Y / PRE-OPERA TION CHECK TIRE PRESSURE The tires on your sno w thrower were o verinfl ated at the f ac- tor y f or shipping pur poses . Correct and equal tire pres sure is impor tant f or best snow throwing perf or mance . • Reduce tire pressure to 14-17 PSI. INST ALL DISCHARGE CHUTE / CHUTE RO T A TER HEAD (See Fig. 7) NO TE: The mult ...
-
Poulan 192030 - page 8
8 OPERA TION KNO W Y OUR SNO W THR O WER READ THIS O WNER'S MANUAL AND ALL SAFETY R ULES BEFORE OPERA TING Y OUR SNO W THRO WER. Compare the illustrations with y our snow thrower to f amiliarize yourself with the location of v arious controls and adjustments. Sav e this manual f or future reference . These symbols may appear on y our snow thr ...
-
Poulan 192030 - page 9
9 OPERA TION Drive speed control le ver - used to select forw ard or re verse motion and speed of snow thro wer . T raction drive control lever - used to engage power-pro- pelled f or ward or re verse motion of sno w thrower . A ug er contr ol lever - used to engage auger motion (throw snow). Discharge chute contr ol lever - used to change the di- ...
-
Poulan 192030 - page 10
10 The operation of any sno w thrower can result in f oreign objects thrown into the ey es, which can result in se vere e ye damage. Alwa ys wear saf ety glasses or eye shields while oper ating your sno w thrower or perf or ming an y ad just - ments or repairs. W e recommend standard saf e ty glasses or a wide vision saf ety mask wor n o ver specta ...
-
Poulan 192030 - page 11
11 T O MO VE FOR W ARD AND B ACKW ARD (See Fig. 16) SELF-PROPELLING, f orward and re verse mo vement of the snow thro wer , is controlled by the traction driv e control le ver located on the left side handle. • Squeeze tr action dr iv e control lev er to handle to en gage the drive system. • Release tr action dr iv e control lev er to stop the ...
-
Poulan 192030 - page 12
12 T O ADJUST SKID PLA TES (See Fig. 17) NO TE: The wrench provided in y our par ts bag may be used to adjust the skid plates. Skid plates are located on each side of the auger housing and adjust the clearance between the scr aper bar and the ground surf ace. Adjust skid plates ev enly to proper height f or current surface conditions. For remo val ...
-
Poulan 192030 - page 13
13 COLD ST AR T - ELECTRIC ST ARTER 1. Inser t saf ety ignition ke y into the ignition slot until it clicks . DO NO T tur n the k ey . K eep the extr a safety ignition ke y in a safe place . 2. Place throttle control in F AST position. 3. Rotate choke control to FULL position. 4. Connect the power cord to the engine . 5. Plug the other end of the p ...
-
Poulan 192030 - page 14
14 MAINTENANCE LUBRICA TION CHART GENERAL REC OM MEN DA TIONS The warranty on this sno w thrower does not co ver items that hav e been sub ject ed to operator abuse or negligence. T o receive full v alue from the warranty , operator must maintain snow thro wer as in str uct ed in this manual. Some ad just - ments will need to be made periodically t ...
-
Poulan 192030 - page 15
15 MAINTENANCE V -BEL TS Check V -belts f or deterioration and wear after e ver y 50 hours of operation and replace if necessary . The belts are not ad just able. Replace belts if they begin to slip from wear . (See “T O REMO VE BEL T CO VER” in the Ser vice and Adjustments section of this manual). The V -belts on your snow thro wer are of spec ...
-
Poulan 192030 - page 16
16 SER VICE AND ADJUSTMENTS W ARNING: T o a void serious injury , before perf orming any service or ad- just ments: 1. Be sure thr ottle is in STOP position. 2. Remove safety ignition ke y . 3. Make sure the augers and all mo v ing parts have completely stopped. 4. Disconnect spark plug wire from spark plug and place wire where it can not come in c ...
-
Poulan 192030 - page 17
17 SER VICE AND ADJUSTMENTS T O REPLA CE BEL TS (See Fig. 21) The auger and traction drive belts are not adjustab le. If the belts are damaged or begin to slip from wear , the y should be replaced. It is recommended that the belt(s) be replaced by a qualifi ed service center . NO TE: It is recommended that both the auger and traction drive belt be ...
-
Poulan 192030 - page 18
18 ST ORA GE Immediately prepare your sno w thrower f or storage at the end of the season or if the unit will not be used for 30 da ys or more. W ARNING: Never store the sno w thro wer with gaso line in the tank in side a build ing where fumes may reach an open fl ame , spark or pilot light as on a fur nace, water heater , clothes dryer or gas ap ...
-
Poulan 192030 - page 19
19 Does not start 1. Fuel shut-off valv e (if so 1. T ur n fuel shut-off v alve to OPEN position. equipped) in OFF position. 2. Safety ignition k ey 2. Inser t saf ety ignition ke y . is not inser ted. 3. Out of fuel. 3. Refi ll fuel tank with fresh, clean gasoline. 4. Throttle in STOP position. 4. Mov e throttle to F AST position. 5. Choke in OFF ...
-
Poulan 192030 - page 20
giving the complete mfg. ID#, serial number and date of purchase of your product and the name and address of the authorized dealer from whom it was purchased. THIS W ARRANTY DOES NO T APPL Y T O INCIDENT AL OR CONSEQUENTIAL D AMAGES AND ANY IMPLIED WA R RAN TIES ARE LIMITED TO THE SAME TIME PERIODS ST A TED HEREIN FOR OUR EXPRESSED W AR- RAN TIES. ...
¿Tienes una pregunta acerca de Poulan 192030?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Poulan 192030, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Poulan 192030 probablemente compartirá una forma de solucionarlo.