-
Zenith 36051 - page 1
Domestic models 37671 Z enith HydroT ap BC60/85 37601 Z enith HydroT ap BF60 (Ambient) 37691 Z enith HydroT ap B60 37676 Z enith HydroT ap BCD60/85 37606 Z enith HydroT ap BFD60 (Ambient) 37696 Z enith HydroT ap BD60 30009 Z enith HydroT ap HT60 30609 Z enith HydroT ap HTD60 36051 Z enith HydroT ap HT60/85 36651 Z enith HydroT ap HTD60/85 Zenith Hy ...
-
Zenith 36051 - page 2
Page 2 of 20 Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Contents Read These Warnings First . . . . . . . . . . . . . . . . . . . . . . . . . .3 Models covered by these instructions . . . . . . . . . . . . . . . . . .4 Installation Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Special to ...
-
Zenith 36051 - page 3
Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Page 3 of 20 Read These Warnings First Safety Do not allow young children, handica pped or infirm persons, to use the Z enith HydroT ap without super vision. Refrigerant The Z enith HydroT ap Chilling unit contains 134A refrigerant under pressure. No part of the uni ...
-
Zenith 36051 - page 4
Page 4 of 20 Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 These Installation Instructions cover the entire Z enith HydroT ap range. Use the chart on the left to identify the model you are using: Commercial and Domestic Models: BC = Boiling and Chilled, Filtered, Timer BF = Boiling, Filtered BD = Boiling and Am ...
-
Zenith 36051 - page 5
Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Page 5 of 20 In addition to normal tools, the following will be required: • 38mm diameter sheet metal hole punch for sink tops. (not supplied) • 38mm diameter hole saw for timber bench tops. (not supplied) • Nut runner tube spanner (supplied) for fixing tap as ...
-
Zenith 36051 - page 6
Page 6 of 20 Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Installation procedure continued Vent line Chilled line Hot line Front Vent Hot Outlet Step B - Installing the undersink unit (all models) SPECIAL NOTE: The HydroT ap undersink units are heavy , take note of the weights listed in the table on page 4. If ...
-
Zenith 36051 - page 7
Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Page 7 of 20 Step D - Connecting the water supply (all models) T o prevent sediment from entering the Z enith HydroT ap at connection, flush water through the supply line thoroughly before connection to the Z enith HydroT ap. Open the access door and check that the ...
-
Zenith 36051 - page 8
Page 8 0f 20 Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 LARGE HOLE 1. Position the Font template (provided) on the bench area. Ensure the position you select is within the length of the supply tube and USB cable fixed to the T ap Head Assembly . These cannot be extended. 2. Check again for correct positionin ...
-
Zenith 36051 - page 9
Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Page 9 of 20 Operating the T ap Blue Chilled Water Light On all the time: This indicates that the chilled water temperature is within the usable range. Flashing slowly : This indicates that the chilled wa ter is not at the right tempera ture. Wait up to 20 minutes.W ...
-
Zenith 36051 - page 10
Page 10 of 20 Z enith Hydro T a p Installation and Operating Instructions - 81467 - February 2005 Cleaning Do not use strong, corrosive, spray or abrasive cleaners. Clean with a soft cloth or brush and mild soap and water . Do not spray water over the tap as it may dama ge the low-volta ge electronics. Undersink units must never be cleaned with wat ...
-
Zenith 36051 - page 11
Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Page 11 of 20 Setting the Energy Saver Timer (products with this feature only) Normal Operation (not available on HT boiling only series) Set Time T o change time, press either Mode ∧ or Mode ∨ button until Set Time is on the display screen. Press ∧ Adjust but ...
-
Zenith 36051 - page 12
Page 12 of 20 Z enith Hydro T a p Installation and Operating Instructions - 81467 - February 2005 Auxiliary F an Attachment (excluding HT boiling only models) Auxiliary fan connection Cold water connection Electrical connections The HydroT ap is equipped with an auxiliar y connection point for an exhaust fan on the rear panel close to the cold wate ...
-
Zenith 36051 - page 13
Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Page 1 3 of 20 Symptom Possible Cause Solution No LED display , no tap head lights or , no water when ta p levers are operated. No water flow. Slow water recover y after use. Water not hot. Water not chilled. No power . Plug is not located in power socket. T ap loom ...
-
Zenith 36051 - page 14
Page 1 4 of 2 0 Z enith Hydro T a p Installation and Operating Instructions - 81467 - February 2005 Exploded V iew Chiller Module and Spare P arts Item Kit No. Description Item Kit No. Description 1 Z 90613 plumbing fittings kit 14 Z 90056 braided hose 2 Z 90614 safety solenoid kit 15 Z 90635 level sensor kit cold tank BC100/125 3 Z 90615 double so ...
-
Zenith 36051 - page 15
Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Page 1 5 of 2 0 Exploded V iew Boiler Module and Spare P arts Item Kit No. Description Item Kit No. Description 1 Z 90613 plumbing and fittings kit 13 Z 90130 clips kit 2 Z 90614 safety solenoid kit 14 Z 90628 stop valve and john guess fittings kit for filter 3 Z 90 ...
-
Zenith 36051 - page 16
Page 16 of 2 0 Z enith Hydro T a p Installation and Operating Instructions - 81467 - February 2005 Exploded V iew HT Series Boiling Only and Spare P arts ITEM KIT NO. DESCRIPTION 1 Z 90656 Plumbing and Fittings kit 2 Z 90614 Safety Solenoid Kit 3 Z 90657 Single Solenoid Kit 4 Z 90658 Gasket and Elbow Kit BC 100/125 5 Z 90579 Overload Kit 6 Z 90618 ...
-
Zenith 36051 - page 17
Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Page 17 of 2 0 Notes ...
-
Zenith 36051 - page 18
Page 18 of 2 0 Z enith Hydro T a p Installation and Operating Instructions - 81467 - February 2005 Notes ...
-
Zenith 36051 - page 19
Z enith Hydro T ap Installation and Opera ting Instructions - 81467 - February 2005 Page 19 of 2 0 Notes ...
-
Zenith 36051 - page 20
Z enith Hydrotap - Installation & Operating Instructions - 81438 - June 2004 Page 20 of 20 Head Office Parex Appliances 103 Central Park Dr Henderson Auckland Email: info@parex.co.nz Website:www.parex.co.nz T elephone (0 9) 836 6566 Facsimile (09) 836 6033 # Warranty Information The Z enith appliance you have chosen is precision-built from the ...
¿Tienes una pregunta acerca de Zenith 36051?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Zenith 36051, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Zenith 36051 probablemente compartirá una forma de solucionarlo.