-
Konica Minolta I60c - page 1
E INSTRUCTION MANUAL ...
-
Konica Minolta I60c - page 2
3 2 For Proper and Safe Use .................. 4 GETTING ST AR TED Names of Parts ................................ 10 Attaching the Camera Strap ............ 14 Inserting the Battery ........................ 15 Battery-condition Indicator .............. 16 Loading the Film .............................. 17 BASIC OPERA TION Fully Automatic Operation ...
-
Konica Minolta I60c - page 3
5 4 •T ape over lithium battery contacts to avoid short-circuiting during disposal; always follow local regulations for battery disposal. • Do not disassemble this product. Electric shock may cause injury if a high voltage circuit inside the product is touched. T ake the product to a Konica Minolta Service Facility when repairs are required. ? ...
-
Konica Minolta I60c - page 4
7 FOR PROPER AND SAFE USE 6 Continued on next page. • Do not fire the flash directly into the eyes. It may damage eyesight. • Do not fire the flash at vehicle operators. It may cause a distraction or temporary blindness which may lead to an accident. • Do not look directly at the sun or strong light sources through the viewfinder . It may dam ...
-
Konica Minolta I60c - page 5
9 FOR PROPER AND SAFE USE 8 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not approved by the p ...
-
Konica Minolta I60c - page 6
11 NAMES OF P ARTS 10 GETTING ST ARTED Continued on next page. * This camera is a sophisticated optical instrument. Care should be taken to keep these surfaces clean. Refer to the care and storage section at the back of this manual (p. 55). BODY The quartz-date model is illustrated. Flash* (p. 32) Self-timer/Remote-control lamp* (p. 41, 52) Lens* B ...
-
Konica Minolta I60c - page 7
13 12 NAMES OF P ARTS GETTING ST ARTED Battery-condition indicator (p. 16 ) Frame counter (p. 19 ) Film-transport signals (p. 19 ) Cartridge mark (p. 30 ) Self-timer indicator (p. 40 ) Date/T ime display (p. 44 ) (Quartz-Date model only) Autoflash Autoflash with red-eye reduction Fill-flash Flash cancel Night Portrait (with red-eye reduction) DA T ...
-
Konica Minolta I60c - page 8
15 • Quartz-date model: after installing the battery , the date and time must be set, see page 46. • When changing batteries, always turn the camera off. 14 INSERTING THE BA TTER Y The camera uses one 3-volt CR123A or DL123A lithium battery . 1. Open the battery-chamber door using the larger button key on the camera strap. 2. Insert the battery ...
-
Konica Minolta I60c - page 9
17 16 1. Slide the back-cover release down to open the back cover . • Before opening the back cover , look through the film window to confirm that film is not currently loaded. LOADING THE FILM • If the back cover does not open, turn the camera off and on to release the film- chamber lock. • Use only DX-coded 35mm film rated between ISO 25 an ...
-
Konica Minolta I60c - page 10
19 18 LOADING THE FILM 4. Close the back cover . • The film automatically advances to the first frame and “ 1 ” appears in the data-panel frame counter . • If the film has been loaded improperly , “0” will blink on the frame counter and the shutter will not release. Open the back cover and repeat the loading procedure. • Once the film ...
-
Konica Minolta I60c - page 11
21 20 1. Press the main switch to turn the camera on. •T o conserve battery power , the auto-power- off function will turn the camera of f eight minutes after the last operation. • Do not obstruct or hold the lens barrel. 2. Hold the camera steadily . Do not cover the flash, lens, AF window , or Meter window with your fingers. • For verticall ...
-
Konica Minolta I60c - page 12
23 22 FULL Y AUTOMA TIC OPERA TION 4. Place the subject within the focus frame and press the shutter-release button partway down. • The status of the AF system and flash are indicated by the lamps next to the viewfinder . Focus frames Focus lamp (green) Glows : focus confirmed Blinks rapidly : subject is too close Blinks slowly : focus not confir ...
-
Konica Minolta I60c - page 13
25 24 FOCUS LOCK FOCUSING RANGE BASIC OPERA TION If the subject is too close, the green focus lamp blinks rapidly and the shutter is locked. The subject must be beyond the minimum focusing distance. If the subject is extremely close, the green focus lamp may blink slowly and the shutter will release, but the focus will not be sharp. The subject mus ...
-
Konica Minolta I60c - page 14
27 26 When a low-contrast area fills the focus frame. When the subject is composed of a regular repeating pattern. The green focus lamp will blink slowly to warn that focus cannot be confirmed. The shutter can be released and the focus will be set to infinity; when using the flash, the focus is set between 2.3 - 6.8m (7.5 - 22.3 ft.) depending on t ...
-
Konica Minolta I60c - page 15
29 28 1. With subject in the focus frame, press and hold the shutter release button partway down. • The green focus lamp should glow to confirm the focus is locked. BASIC OPERA TION 2. While pressing the shutter-release button partway down, recompose the picture. 3. Press the shutter-release button all the way down to take the picture. Because of ...
-
Konica Minolta I60c - page 16
31 30 REWINDING THE FILM • If the rewind motor stops before the film has been completely rewound, all the indicators on the data panel will blink. Remove and insert the battery . • Although more pictures than specified on the film package may be taken, the film processor may only print the number specified on the film cartridge. Gently press th ...
-
Konica Minolta I60c - page 17
33 32 • When the camera is turned off, the fill-flash, flash cancel, or night portrait mode will be reset to autoflash or autoflash with red-eye reduction, whichever of the two modes was set last. SELECTING FLASH MODE The following flash modes can be selected: Press the flash-mode button until the desired flash-mode indicator appears on the data ...
-
Konica Minolta I60c - page 18
35 34 AUTOFLASH The flash will fire automatically in low-light or back-lit situations. Press the flash-mode button until the autoflash indicator appears on the data panel to set the flash mode. • When the orange flash lamp blinks quickly , the flash is charging. The shutter cannot be released until the flash is charged; the orange flash lamp will ...
-
Konica Minolta I60c - page 19
37 36 AUTOFLASH WITH RED-EYE REDUCTION The flash will fire a few short bursts before the main flash burst to reduce red-eye; an effect caused by light reflected from the retina. Used in low-light condition when taking photographs of people or animals, the pre-flashes contract the pupils of the subject’s eyes. The flash will fire automatically in ...
-
Konica Minolta I60c - page 20
39 38 FLASH CANCEL The flash will not fire in this mode. Use flash cancel when flash photography is prohibited, natural light is desired to illuminate the subject, or the subject is beyond the flash range. The camera-shake warning may appear in this mode. Press the flash-mode button until the flash- cancel indicator appears on the data panel to set ...
-
Konica Minolta I60c - page 21
41 40 SELF-TIMER 1. With the camera on a tripod, press the drive- mode button until the self-timer indicator appears on the data panel. 2. Frame the subject as described in the manual. • Focus lock can be used (P . 24). The self-timer is used for taking self-portraits. The self-timer delays release of the shutter for approximately 10 seconds afte ...
-
Konica Minolta I60c - page 22
43 42 CONTINUOUS ADV ANCE In this mode, the camera continuously takes pictures as long as the shutter-release button is held down. The camera will take one picture every 2.2 seconds. When the flash is used, the rate may be slower because the flash must recharge between frames. 1. Press the drive-mode button until the continuous-advance indicator ap ...
-
Konica Minolta I60c - page 23
BUTT ONS FOR THE DA TE FUNCTION Select button Adjust button Date button 45 44 FOR OWNERS OF THE QUARTZ-DA TE MODEL The quartz-date model has date and time imprinting and remote-control operation. DA TE AND TIME IMPRINTING The imprinting feature enables the date or time to be printed onto the lower-right portion of the picture. The date is recorded ...
-
Konica Minolta I60c - page 24
YY MM DD hh mm 47 46 FOR OWNERS OF THE QUARTZ-DA TE MODEL SETTING THE DA TE OR TIME Continued on next page. Note: the date and time must be reset each time the battery is replaced. 1. T urn the camera on. Press the date button until “ SEt ” appears on the data panel. 2. Press the select (SEL) button until the item to be adjusted blinks. • Eac ...
-
Konica Minolta I60c - page 25
49 48 FOR OWNERS OF THE QUARTZ-DA TE MODEL CHANGING THE DA TE FORMA T 1. Press the date button until “ SEt ” appears on the data panel. 2. Press and hold the select (SEL) button for more than 2 seconds until all items on the date display blink. Continued on next page. ADV ANCED OPERA TION • Pressing the select (SEL) button until the date/time ...
-
Konica Minolta I60c - page 26
51 50 FOR OWNERS OF THE QUARTZ-DA TE MODEL REMOTE CONTROL OPERA TION The quartz-date model can be controlled by the IR remote control RC-3 (sold separately). The remote control allows remote camera operation up to 5 meters (16.5 feet) away . • Focus lock cannot be used with the IR remote control. NAMES OF P ARTS Emitter window Delay button Releas ...
-
Konica Minolta I60c - page 27
53 52 FOR OWNERS OF THE QUARTZ-DA TE MODEL 3. Point the remote control toward the front of the camera and press either the release button (•) or the delay button (2s) to take the picture. • If the release button (•) is pressed, the self- timer/remote-control lamp on the front of the camera will blink once before the picture is taken. If the d ...
-
Konica Minolta I60c - page 28
55 • Never subject the camera to extreme humidity . •T o prevent condensation from forming, place the camera in a sealed plastic bag when bringing it from a cold environment into a warm one. Allow it to come to room temperature before removing it from the bag. 54 Continued on next page. APPENDIX CARE AND STORAGE OPERA TING TEMPERA TURE AND COND ...
-
Konica Minolta I60c - page 29
57 56 CARE AND ST ORAGE CLEANING • Keep the AF window clean to ensure accurate focus. • If the camera body is dirty , gently wipe it clean with a soft, clean, dry cloth. •T o clean the lens surface, first brush away any dust or sand then, if necessary , moisten a lens tissue with lens cleaning fluid and gently wipe the lens in a circular moti ...
-
Konica Minolta I60c - page 30
59 58 CAMERA ERROR If all the indicators on the data panel blink, or the data panel is blank and the camera will not function with a recently installed battery , remove and reinsert the battery . If the camera does not resume normal operation, or the camera malfunctions repeatedly , contact an authorized Konica Minolta Service Facility . QUESTIONS ...
-
Konica Minolta I60c - page 31
60 V iewfinder: Magnification: 0.37X - 1.46X Field of View: 85% (at 3m) Eye-relief: 17.3mm from the viewfinder frame Dimensions: 1 10.5 x 60.5 x 46.5 mm 4.4 x 2.4 x 1.8 in W eight: 190g (6.7 oz.) without battery Specifications are based on the latest information available at the time of printing and are subject to change without notice . 61 Camera ...
-
Konica Minolta I60c - page 32
63 62 MEMO MEMO ...
-
Konica Minolta I60c - page 33
0-43325-53159-0 9222-2479-1 1 NI-B401 Printed in China © 2003 Konica Minolta Camera Inc. under the Berne Convention and the Universal Copyright Convention ...
¿Tienes una pregunta acerca de Konica Minolta I60c?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Konica Minolta I60c, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Konica Minolta I60c probablemente compartirá una forma de solucionarlo.