-
Emerson CF943 - page 1
Part No. F40BP73350000 Form No. BP7335 ETL Model No.: CF943 READ AND SA VE THESE INSTRUCTIONS Net Weight: 37.9 Lbs. P ALAZZO ™ 54” Ceiling Fan Owner's Manual CF943AGW00 CF943BZH00 Model No. BP7335 Palazzo 1/9/07 9:05 AM Page 1 ...
-
Emerson CF943 - page 2
DATE CODE: The date code of this fan may be found on the box, stamped in ink on a white label. You should record this data above and keep it in a safe place for future use. 2 W ARNING: T o avoid fire, shock, and serious personal injury , follow these instructions. Safety Instructions 1. Read your owner ’s manual carefully and keep it for future r ...
-
Emerson CF943 - page 3
3 This Manual is Designed to Make it as Easy as Possible for Y ou to Assemble, Install, Operate and Maintain Y our Ceiling Fan Do not install or use fan if any part is damaged or missing. Call T oll-Free: 1-800-654-3545 ! W ARNING This product is designed to use only those parts supplied with this product and/or any accessories designated specifica ...
-
Emerson CF943 - page 4
4 2. Remove and discard the two cardboard shipping retainers securing the motor hub in the motor housing assembly . 3. Remove the fan motor assembly from the protective plastic bag. Place all carton contents on a protective surface. G. HANGER BRACKET D. F AN BLADES EMERSON ® HI MED LOW FAN OFF LIGHT ON OFF H. HANGER BALL/ 6" DOWNROD ASSEMBL Y ...
-
Emerson CF943 - page 5
5 Setting Operating Frequency of Wall Control and Receiver (Figure 1) Y our wall control and receiver have code switches which must be set in one of 16 possible code combinations. The four levers (numbered 1, 2, 3, and 4) on the switches are factory-set in the ON (up) position. Change the switch settings as follows: 1. Slide the four switch levers ...
-
Emerson CF943 - page 6
Installation of Wall Control SINGLE-POLE INSTALLATION (Figure 2) 1. Disconnect power at circuit breaker or remove fuse. 2. Remove faceplate and screws from existing wall switch. Pull switch out from the wall box. Determine the “hot” wire and the “load” wire and disconnect these wires from switch. Do not attempt to disconnect any wires not a ...
-
Emerson CF943 - page 7
4. Install a wall control in the wall box containing the “hot” wire first. Connect one black wire of the wall control to the “hot” wire. Securely connect wires with wire connectors supplied. 5. Connect the other black wire of the wall control to both remaining traveler wire(s) in the wall box and secure with wire connector supplied. NOTE: R ...
-
Emerson CF943 - page 8
#10-32 x 5/16" OV AL HEAD FLANGE SCREW (2 per flange) BLADE ASSEMBL Y MOTOR HOUSING ASSEMBL Y FLANGE SLOT 4. Securely connect the black wire connector of the light fitter assembly to the black motor wire connector . Securely connect the white wire of the light fitter assembly to the white motor wire (Figure 9). 5. Position the light fitter ass ...
-
Emerson CF943 - page 9
7. Carefully turn the fan motor assembly upside down in preparation for hanger ball/downrod installation. Place the partially assembled fan into the top half of the styrofoam as shown in Figure 1 1. Do not rest fan weight on the light fitter sockets. 8. Remove the hanger ball from the downrod by loosening the setscrews in the hanger ball until the ...
-
Emerson CF943 - page 10
17. Y ou have now completed the initial assembly of your new ceiling fan. Y ou can now proceed with hanging and wiring your fan. 16. Reinstall the hanger ball on the downrod (Figure 16) as follows. Route the motor leads through the hanger ball and slide the hanger ball over the downrod. Install the pin through the holes at the top of the downrod an ...
-
Emerson CF943 - page 11
1. Pull the wire leads, coming from the end of the downrod, and the supply wires through the open side of the hanger bracket. (Figure 20). a. Connect the white fan wire and the white supply wire to the white receiver wire (AC IN/ MOTOR N). b. Connect the black fan wire to the black receiver wire (TO MOT OR L). c. Connect the black supply wire to th ...
-
Emerson CF943 - page 12
WHITE SUPPL Y WIRE BLACK F AN WIRE SW105 RECEIVER TO 110V SUPPL Y SW113 FAN/LIGHT WALL CONTROL CAP THE YELLOW RECEIVER WIRE USING A WIRE CONNECTOR BLUE RECEIVER WIRE BLUE FAN WIRE BLACK SUPPL Y WIRE WHITE RECEIVER WIRE BLACK RECEIVER WIRE BLACK/WHITE RECEIVER WIRE YELLOW RECEIVER WIRE DOWNROD HI MED LOW FAN OFF ON OFF REV D/L U/L WHITE F AN WIRE Fi ...
-
Emerson CF943 - page 13
OUTLET BOX RECEIVER CEILING COVER HANGER BRACKET 1-1/4" THREADED STUDS (2) Figure 22 7. Slide the receiver up and over the hanger bracket. Press the receiver against the ceiling, then slide the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 23). 8. Secure the ceiling cove ...
-
Emerson CF943 - page 14
14 Operating Y our Ceiling Fan IMPORT ANT Fan installation must be completed, including the installation of the fan blades, before testing of the remote control. Y our Fan/Light Wall Control (Figure 26) has full control of your fan and light. However , airflow direction is controlled by a slide switch on the switch housing. 1. Restore electrical po ...
-
Emerson CF943 - page 15
15 INSTRUCTION TO THE USER (if device contains a digital device) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses ...
-
Emerson CF943 - page 16
16 1. Downrod Extension Kits (see store or catalog). 2. Ceiling Fan Controls (see store or catalog). 3. Blades (see store or catalog). Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock. ! W ARNING The use of any other control not specifically approved for this ...
-
Emerson CF943 - page 17
17 T rouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not 1. Fuse or circuit breaker 1. Check main and branch start. blown. circuit fuses or circuit breakers. W ARNING: Make sure main power is turned off. 2. Loose power line 2. Check line power connections connections to the fan. to fan. 3. Fan/Light W all Control is OFF. 3. T ur ...
-
Emerson CF943 - page 18
Repair Parts 15 8 13 14 5 4 18 3 2 1 9 6 12 16 17 21 22 11 10 19 24 23 20 HI MED LOW FAN OFF REV LIGHT ON OFF 7 Before discarding packaging material, be certain all parts have been removed. HOW TO ORDER REP AIR P ARTS WHEN ORDERING REP AIR P ARTS, AL WA YS GIVE THE FOLLOWING INFORMA TION: • P ART NUMBER • NAME OF ITEM • P ART DESCRIPTION • ...
-
Emerson CF943 - page 19
Part Numbers Key Model No. Model No. N o . Description CF943AGW00 CF943BZH00 * Hanger Pack, Consisting of: 761655-62 761655-61 1 Hanger Bracket — — 2 Hanger Ball — — 3 Downrod — — * Parts Bag, Containing: 763224 763224 4 Screw, #10-32 x 5/16” Pan Head Blade (16) — — 5 Washer , #10 flat (16) — — 6 Wire Connector (5) — — 7 C ...
-
Emerson CF943 - page 20
Part No. F40BP73350000 Printed in China 01/07 Form No. BP7335 Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant ¥ St. Louis, MO 63136 LIMITED W ARRANTY What The W arranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and material ...
¿Tienes una pregunta acerca de Emerson CF943?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Emerson CF943, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Emerson CF943 probablemente compartirá una forma de solucionarlo.