-
Swissvoice L7 TAM Code - page 1
cordless telephone with answering machine ...
-
Swissvoice L7 TAM Code - page 2
Safety precautions Caution: W arning/danger statem ent, follow safety precautions! ➭ Please note that the ringer for incomi ng calls as well as signal tones are emitted on the handset loudspeaker . Do not therefore hold the handset close to your ear while one of these functi ons is on, otherwise your hearing may be affected. ➭ Use only one of t ...
-
Swissvoice L7 TAM Code - page 3
Disposal Please dispose of batteries, base station, handset and mains unit s in an ecological manner . Do not dispose of them in domestic waste. IMPORT ANT Only use the telephone line cord supplied. Use only the approved re chargeable Li-Ion battery cell (Swissvoice C0487 or 043048, 3.7V , 550mAh, 2.04Wh) supplied wi th your L7 as well as the origi ...
-
Swissvoice L7 TAM Code - page 4
...
-
Swissvoice L7 TAM Code - page 5
1. Getting st arted ........................................................ 7 2. Getting to know your phone ................................ 10 3. Using the phone ................................................... 13 3.1 Switch the handset on / off ............................................................... 13 3.2 Make Calls / Preparatory dia ...
-
Swissvoice L7 TAM Code - page 6
9.4 Record personal outgoing messages ............................................... 24 9.5 Play or delete your personal outgoing message .............................. 24 9.6 Set the answer mode ....................................................................... 25 9.7 Record a memo ............................................................ ...
-
Swissvoice L7 TAM Code - page 7
7 1. Getting started Location Place your L7 base within 2 meters of t he mains power socket and 1.8 meters from the telephone wall socket. The socket-outle t shall be inst alled near the equipment and shall be easily accessible. Make sure that it is at le ast 1 meter away from other electrical appliances to avoid interferenc e. Y our L7 works by se ...
-
Swissvoice L7 TAM Code - page 8
8 Installing and charging the handset • Remove the battery cover from t he back of the handset and insert the rechargeable Li-Ion battery cell supplied. Make sure that the battery is inserted correctly (observe battery jack inside battery compartment). • Connect the charger as shown below and place the handset on the charger . • If you are ch ...
-
Swissvoice L7 TAM Code - page 9
9 BA TTERY LOW W ARNING If you hear a warning beep every 30 seconds during a call, you need to recharge the handset before you can use it again. When charging, icon will scroll on the display . BA TTERY PERFORMANCE In ideal conditions, fully charged batteries should give up to 10 hours talk time or up to 150 hours standby time on a single charge. 1 ...
-
Swissvoice L7 TAM Code - page 10
10 2. Getting to know your phone Overview of your handset 14 1 2 3 41 0 11 5 6 7 ABC DEF GHI JKL MNO PQRS WXYZ TUV R INT 123 456 78 9 0# 81 2 13 15 9 16 1. Earpiece 2. Display 3. Redial list / Scroll up / Pause In standby mode, press to open the redial list Scroll up through lists and menus Press and hold to enter a pause (P) when pre-dialling or s ...
-
Swissvoice L7 TAM Code - page 11
11 7. V oice Mail (1 key) In standby mode, long press to speed dial voice mail number 8. Recall ( * Key) Long press to activate recall function (R) during a communication 9. Intercom (0 key) Long Press to make private internal call between multiple handsets 10. Contact s / Clear / Back / Right sof tkey In standby mode, press to open the Contact li ...
-
Swissvoice L7 TAM Code - page 12
12 Handset LCD Display S teady when the handset is registere d and within range of the base. Flashes when handset is out of range or searching for the base. Displays when ECO mode is on, Zero Em ission mode is off, the icon should be antenna + E. Displays when ECO mode is off, Zero Emission mode is on, the icon should be antenna + leaf. Displays wh ...
-
Swissvoice L7 TAM Code - page 13
13 3. Using the phone NOTE - Y our handset automatically times the duration of every external call, the call timer will display on t he screen. When the call ends, the total duration of your talk time is shown for 5 seconds. 3.1 Switch the handset on / off Press and hold the End Call key to switch the handset on or off. 3.2 Make Calls / Preparatory ...
-
Swissvoice L7 TAM Code - page 14
14 3.5 Intercom and Push-T o-T alk 3.5.1 Make an internal call If you have more than one handset registered to the base, you can make internal calls between two handsets. Internal Call and Handset X displays to indicate an internal call. 1. Long Press followed by the number of th e handset you want to call. 2. Press OK . 3. In starting intercom, wh ...
-
Swissvoice L7 TAM Code - page 15
15 1. Press and hold PTT key . Wait 2 second s while units connect (tone will play). 2. Begin speaking. Release PT T key to finish the broadcast. 3.6 Hands-free speakerphone Hands-free lets you talk to your caller wi thout holding the handset. It also enables other people in the room to li sten to the conversation. 3.6.1 Make a hands-free call 1. D ...
-
Swissvoice L7 TAM Code - page 16
16 4.2 Answer/end calls hands-free Press PTT key to answer/end a call. NOTE - During a hands-free call, press -/+ or to adjust the volume. 4.3 Adjust the earpiece volume During a call, press or to increase or decrease the volume (8 levels). 4.4 Intercom and Push-T o-T alk 4.4.1 Make an internal call If stand-by mode, with a short press on PTT key , ...
-
Swissvoice L7 TAM Code - page 17
17 3. Enter a name and press OK , enter a number and press Save . 4. Scroll or to the melody you want and press Select . The entry is stored. NOTES - When the Contact list is empty , you cannot enter the first entry using the softkey Names, you must enter it over the menu: Press Menu , scroll to Contact then to Add entry . - If the L7 is connected ...
-
Swissvoice L7 TAM Code - page 18
18 - Delete Entry – Delete the selected entry from the Contact list. - Fast Call – S tore a Fast Call number: scroll or to Key X where the entry will be stored, press Select . Assign is highlighted press Select to confirm. Delete a Fast Call number: select Clear Entry and press Select to confirm. 6. Calls list If you have subscribed to Caller I ...
-
Swissvoice L7 TAM Code - page 19
19 Select a function from the following list: - Show Details – Show the date and time of the call - Save Number – Add a Calls list number to the phonebook - Delete Call 7. Settings 7.1 Set the date and time 1. Press Menu , scroll to Settings then Date & Time and press Select . 2. Enter the date using the format DD/ MM/YY e.g. 04/08/12 for 4 ...
-
Swissvoice L7 TAM Code - page 20
20 - Screensaver Activate or deactivate the screensaver. - Auto talk With Auto T alk switched on, you can answ er a call just by lifting the handset of f the base or charger . If switched off, you will have to press the T alk key to answer a call. - Key beep When the key beep function is turned to on, you hear a beep with each key press. - PBX acce ...
-
Swissvoice L7 TAM Code - page 21
21 - System PIN The System PIN is required when changing certain settings and for registration / de-registration. The default setting is 0000. Y ou can change this to your own preferred number (up to 8 digits). NOTE - Note your new PIN code and keep it somewhere safe. - Master Reset Y ou can restore the L7 to its default (origi nal) settings. Reset ...
-
Swissvoice L7 TAM Code - page 22
22 On the handset: 1. Press Menu , scroll to Registration and press Select . 2. Register HS is highlighted. Press Select . 3. Bases are displayed. Sele ct the desired base and press Select . 4. Enter the system PIN (0000 on delivery) and press OK . 5. The display shows Searching Base X . When registration is successful the display shows Handset Reg ...
-
Swissvoice L7 TAM Code - page 23
23 9.1 Overview of the base A B C D H I J F G E A. LED – Indicates when the answering machin e is on or off, and when you have new messages (LED is blinking) B. Answering machine On / Off – Switches the answering machine on / off Press and hold to enter the outgoi ng message selection mode. Then press key C to select Answer & Record outgoin ...
-
Swissvoice L7 TAM Code - page 24
24 I. Intercom and Push-T o-T alk – In standby , short press to call the handset(s). Press and hold to broadca st to every L7 handset J. Bottom key Page and Register key – Press and hold to enter registration mode when registering handsets 9.2 Switch the answering machine on/off 1. Press Menu , the display shows Answer Machine , press Select . ...
-
Swissvoice L7 TAM Code - page 25
25 9.6 Set the answer mode See chapter “Answeri ng machine settings” 9.7 Record a memo Y ou can record a memo which is stor ed on your answering ma chine and played back like a normal message. 1. Press Menu , the display shows Answer Machine , press Select . 2. Scroll to Record Memo and press Select . 3. The display shows Please speak after the ...
-
Swissvoice L7 TAM Code - page 26
26 9.11 Answering machine settings 1. Press Menu , the display shows Answer Machine , press Select . 2. Scroll to Answer Settings and press Select . Select a function from the list: - Language - Select the language for default outgoing messages - Answer Mode - Select Answer & Record or Answer Only . Then select Default OGM (prerecorded on deliv ...
-
Swissvoice L7 TAM Code - page 27
27 NOTE - If you enter an incorrect PIN code you hear two error beeps. T ry again. If it is still incorrect you hear a single error beep and the L7 hangs up. 9.13 Change the remote access PIN The default remote access PIN is 0000. Change the remote access PIN c ode for additional security: 1. Press Menu , the display shows Answer Machine , press Se ...
-
Swissvoice L7 TAM Code - page 28
28 icon is not scrolling during charge • Adjust the handset slightly on the base. • Clean the charging contacts with a cloth moistened with alcohol. • Check that the mains power is connected properly and switched on. • The battery is full. When the handset is fully charged, icon is steady on. No Caller ID • Check your subscription wi th y ...
-
Swissvoice L7 TAM Code - page 29
29 Several factors can cause a failure of specific features to function: • The Internet/cable telephony provi der may not provide the function on its Internet/cable telephony connection. • The adapter used to convert Intern et/cable telephony to analog telephony (usually supplied by the provider) may not forward the functi ons to connected tele ...
-
Swissvoice L7 TAM Code - page 30
30 incorrect use, ordinary wear and tear , or manipulation by third parties. This warranty does not cover consequent ial damage caused by the use, failure or defectiveness of the product. In particular , no liability whatsoever is accepted for damage to property and pecuniary loss. T o claim under this warranty , please cont act the ret ailer w her ...
-
Swissvoice L7 TAM Code - page 31
...
-
Swissvoice L7 TAM Code - page 32
32 www .swissvoice.net © Swissvoice SA 2013 All rights as well as delivery possib ilities and technical changes reserved. 204071 12en_ba_a0 SV 204071 12 ...
¿Tienes una pregunta acerca de Swissvoice L7 TAM Code?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Swissvoice L7 TAM Code, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Swissvoice L7 TAM Code probablemente compartirá una forma de solucionarlo.