-
Pelco CC3700H-2 - page 1
® Installa tion/Oper a tion CC3700 Series Color Camera C1986M-B (11/03) Pelco World Headquarters • 3500 Pelco Way, Clovis, CA 93612-5699 USA • www.pelco.com USA & Canada: Tel: 800/289-9100 • Fax: 800/289-9150 International: Tel: 1-559/292-1981 • Fax: 1-559/348-1120 ...
-
Pelco CC3700H-2 - page 2
[ 2 ] Pelco Manual C1986M-B (1 1/03) ...
-
Pelco CC3700H-2 - page 3
Pelco Manual C1986M-B (11/03) [ 3 ] CONTENTS IMPORT ANT SAFEGUARDS AND W ARNINGS .............................................................................................. ....... 4 Regulatory Notices ............................................................................................................. ................................... ...
-
Pelco CC3700H-2 - page 4
[ 4 ] Pelco Manual C1986M-B (1 1/03) IMPORT ANT SAFEGUARDS AND WARNINGS Prior to installation and use of this product, the following WARNINGS should be observed. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water . 6. Clean only with dry cloth. 7. Do not ...
-
Pelco CC3700H-2 - page 5
Pelco Manual C1986M-B (11/03) [ 5 ] DESCRIPTION The CC3700 Series is a compact, color video camera with a 1/3-inch CCD imager . All cameras have a direct drive/auto iris lens connector and adjustable back focus, and they accept C and CS lenses. Models CC3700S-2 Standard resolution, 330 TV lines, SuperHAD™ CCD, 0.5 lux @ 50 IRE, f1.2, NTSC CC3700H ...
-
Pelco CC3700H-2 - page 6
[ 6 ] Pelco Manual C1986M-B (1 1/03) CAMERA LA Y OUT NOTE: The cosmetic trim ring conceals the LED light for more discreet surveillance operations. The trim ring also hides the power connectors and protects the DIP switches. Figure 1. Camera Layout INST ALLA TION Lens Mounting The CC3700 Series camera can use fixed iris, manual iris, auto iris, or ...
-
Pelco CC3700H-2 - page 7
Pelco Manual C1986M-B (11/03) [ 7 ] PIN DC (AID) AUTO IRIS LENS VIDEO (AIV) AUTO IRIS LENS 1 Control coil negative (-) Lens positive supply 2 Control coil positive (+) Not used 3D rive coil positive (+) Video drive signal 4D rive coil negative (-) Ground Figure 2. AID/AIV Lens Connector Camera Mounting Use a standard 1/4-20 screw (provided) with a ...
-
Pelco CC3700H-2 - page 8
[ 8 ] Pelco Manual C1986M-B (1 1/03) POWER AND VIDEO CONNECTIONS The CC3700 Series camera is designed to operate from a 12 VDC or 24 V AC power supply . The power supply connections are shown in Figure 4. The LED on the back panel of the camera indicates that power is connected. Use only a UL Listed Class 2 isolated power supply . Power consumption ...
-
Pelco CC3700H-2 - page 9
Pelco Manual C1986M-B (11/03) [ 9 ] AC Operation Only – If you are wiring more than one camera to the same transformer , connect one side of the transformer to the same terminal on all cameras, and connect the other side of the transformer to the remaining terminal on all cameras. Failure to connect all of the cameras the same way will cause the ...
-
Pelco CC3700H-2 - page 10
[ 10 ] Pelco Manual C1986M-B (1 1/03) LENS SETUP AND FOCUS PROCEDURES V ideo Drive Auto Iris Lens When a video drive auto iris lens is used, the lens mode selector switch must be set to AIV . Switch the ESC and AGC OFF . Refer to the lens instructions and adjust the lens for the optimum picture (video output level of 1V peak-to-peak). Switch the AG ...
-
Pelco CC3700H-2 - page 11
Pelco Manual C1986M-B (11/03) [ 11 ] BA CK FOCUS ADJUSTMENT The back focus adjustment is located at the front of the camera and is accessible from either side of the case. To adjust the back focus: 1. Loosen the two back focus locking screws (one on each side). 2. T urn the back focus ring: a. Clockwise - Moves the CCD sensor assembly towards the b ...
-
Pelco CC3700H-2 - page 12
[ 12 ] Pelco Manual C1986M-B (1 1/03) SWIT CH SETTINGS Figure 7. Switch Settings (Defaults) Gamma (NOR/LIN Switch) - Switch Setting 8 Sets the Gamma level to one of the following: NOR (Default setting) - Increases visibility in dark areas of the picture. LIN - Linear response increases (overall) contrast. A utomatic Gain Control (AGC/Off Switch) - ...
-
Pelco CC3700H-2 - page 13
Pelco Manual C1986M-B (11/03) [ 13 ] Shutter Speed Selection - Switch Settings 4, 3, 2, and 1 ESC (Electronic Sensitivity Contr ol) Switch Settings 4, 3, and 1 The ESC feature compensates for an excessive light level by automatically adjust- ing shutter speed. Following are the ESC switch settings: ESC (Default setting) - Enables the Electronic Sen ...
-
Pelco CC3700H-2 - page 14
[ 14 ] Pelco Manual C1986M-B (1 1/03) CAMERA SYNCHRONIZA TION When using more than one camera power supply , a brief vertical roll may occur on the monitor when a camera view is switched. T o eliminate vertical roll, adjust the phase control by synchronizing, or line-locking, the cameras to one another . Set the INT/LL DIP switch to LL and use the ...
-
Pelco CC3700H-2 - page 15
Pelco Manual C1986M-B (11/03) [ 15 ] SPECIFICA TIONS GENERAL CCD Sensor: 1/3-inch Picture Elements CC3700S-2: 510 (H) x 492 (V) CC3700H-2: 768 (H) x 494 (V) Sensing Area: 6mm diagonal Synchronization System: AC line lock or internal oscillator Horizontal Resolution CC3700S-2, CC3700S-2X: 330 TV lines CC3700H-2, CC3700H-2X: 480 TV Lines Iris Control ...
-
Pelco CC3700H-2 - page 16
® Pelco, the Pelco logo, Spectra, Genex, Legacy , Esprit, and Camclosure are registered trademarks of Pelco. ™ HyperHAD and EXview HAD CCD are trademarks of the Sony Corporation. © Copyright 2002, Pelco. All rights reserved. WARRANTY AND RETURN INFORMA TION REVISION HISTOR Y Manual # Date Comments C1986M 3/02 Original version. C1986M-A 7/02 Rev ...
¿Tienes una pregunta acerca de Pelco CC3700H-2?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Pelco CC3700H-2, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Pelco CC3700H-2 probablemente compartirá una forma de solucionarlo.