-
Gorenje IT640-ORA-W - page 1
Ceramic glass induction hob MT Instructions for use, installation, and connection IE GB ...
-
Gorenje IT640-ORA-W - page 2
243971 The built-in ceramic-glass cooktop is intended for household use only . Materials used for packaging are nature friendly and may be recycled, deposited or destroyed without any threats to the environment. In order to recognize these features, all packing materials are marked with relevant symbols. Once your appliance has become obsolete and ...
-
Gorenje IT640-ORA-W - page 3
243971 • The appliance may be built-in and connected to the power supply only by a quali fi ed technician. • Particular areas of the cooktop surface (adjacent to the hotplates) are hot during operation. Prevent the children to hang around the appliance and warn them properly against the danger of burns. • Hot oil ignites readily , so be sure ...
-
Gorenje IT640-ORA-W - page 4
243971 A ON/OFF sensor B Hotplate power or remaining heat displays B1 Decimal dot on the power displays: - On : hotplate power control is possible - Off : hotplate power control is not possible C Hotplate selection and ON/OFF sensors (+) (hotplate number varies with different models) D Child lock ON/OFF sensor E Sensor (-) F Extra strong power sett ...
-
Gorenje IT640-ORA-W - page 5
243971 • Ceramic glass hob is fi tted with four hotplates. Hob surface is completely fl at and smooth, without edges to accumulate dirt. • The hob is fi tted with high power induction hotplates. Heat is generated directly at the bottom of the dish, where it is most needed, without any losses through the ceramic glass surface. This way the re ...
-
Gorenje IT640-ORA-W - page 6
243971 Magnet test Use small magnet to test if the dish bottom is magnetic. Only dishes where magnet sticks to the bottom are suitable for induction cooking. Dish recognition One of great advantages of the induction hotplate is dish recognition. Even if there are no dishes upon the hotplate, or the dish diameter is smaller than the diameter of the ...
-
Gorenje IT640-ORA-W - page 7
243971 • When buying cookware be careful in selecting size: pot diameter usually refers to the top edge of the dish, which is often larger than the dish bottom. • Steam-pressure pots (economic pots), which use pressure in tightly sealed interior , are especially economic, and save both time and energy . Shorter cooking time leaves more vitamins ...
-
Gorenje IT640-ORA-W - page 8
243971 • After turning the ceramic glass hob on all displays come on for a moment. The hob is ready for operation. • The hob is fi tted with electronic sensors which are switched on if you touch the relevant circle for at least one second. • Each sensor activation is followed by a sound signal. • Avoid placing any objects on sensor surface ...
-
Gorenje IT640-ORA-W - page 9
243971 Fast deactivation • Selected hotplate must be activated, decimal dot (B1) is on. • Press both (+) and (-) (C and E) sensors simultaneously , and the hotplate is immediately switched off. • The hob can be switched off any time by pressing the ON/OFF sensor (A). By activating the child lock protection you can stop the operation of the ap ...
-
Gorenje IT640-ORA-W - page 10
243971 During the time extra power is activated, the power of other hotplates is limited. This is indicated on the power display by intermittently showing the selected cooking level and limited power . Activating extra powerful setting • First select the hotplate by touching its relevant sensor , and immediately after press the sensor “P”. Ex ...
-
Gorenje IT640-ORA-W - page 11
243971 Hint • If the power selection knob remains at level 0 three seconds after the automatic fast heating is activated, that is if you fail to select the power setting for regular cooking, the fast heating function is switched off. • If you remove the dish from the hotplate and then within the next ten minutes return it on the hotplate, the f ...
-
Gorenje IT640-ORA-W - page 12
243971 Example: Set the hotplate to power level 6 and leave it operate for some time. If you do not change the above setting, the safety mechanism will switch the hotplate off after one hour and a half. Protection from overheating Induction hotplate is also fi tted with safety device against overheating which protects electronic parts from damages ...
-
Gorenje IT640-ORA-W - page 13
243971 Remaining cooking time Y ou can display the remaining cooking time by touching the hotplate ON/OFF sensor (C). Switching the timer off When the preset time expires a beep is heard which you can either turn off by touching any sensor or leave it to turn of f automatically after 2 minutes. Switching the timer of prior expiry of preset time: ? ...
-
Gorenje IT640-ORA-W - page 14
243971 • During the time the alarm is activated, timer can not be preset for any hotplate (to enable timer setting function, alarm must be switched off). The hob is equipped with the overheat safety sensors. When they are activated they turn off the hotplates nearest to the control board. Error , possible cause, remedy • Constant sound signal o ...
-
Gorenje IT640-ORA-W - page 15
243971 Major stains are removed with special ceramic-glass cleansers. Follow strictly the manufacturer ’s instructions. Be careful to remove any remains of cleansing agent from the hob surface, otherwise they will be heated during the next use and can damage the hob ( fi g. 3). Stubborn and burnt stains are removed with special ceramic- glass sc ...
-
Gorenje IT640-ORA-W - page 16
243971 Before inserting the appliance into the opening in the kitchen worktop, the supplied foam gasket must be attached to the lower side of the glass ceramic (glass) cooking hob (see fi gure above). Do not install the appliance without the foam gasket! The gasket should be attached to the appliance in the following way: - Remove the protective ? ...
-
Gorenje IT640-ORA-W - page 17
243971 empty and no objects may be stored or kept there. • Rear side of the kitchen element must also have a 140 mm high opening along the entire width of the element, and the front part must have an opening of no less than 6 mm. • Incorporation of the oven under the induction hob is permissible for all EVP4, EVP2…, oven types, equipped with ...
-
Gorenje IT640-ORA-W - page 18
243971 • The connection should be selected in accordance with the declared charge capacity of the mains and the fuse power . • Such appliances are allowed to be mounted on one side next to a high kitchen cabinet, the height of which may exceed that of the appliance. On the opposite side however , only a kitchen cabinet of equal height as the ap ...
-
Gorenje IT640-ORA-W - page 19
WE RESERVE THE RIGHT TO AL TER THE SPECIFICA TIONS WITH NO INFLUENCE T O THE OPERA TION OF THE APPLIANCE. 243971 T echnical information Rating plate A Serial number B Code C Model D T ype E T rademark F T echnical information G Compliance indications / symbols 19 ...
-
Gorenje IT640-ORA-W - page 20
SIVK - ORA ITO 243971/en (04-10) ...
¿Tienes una pregunta acerca de Gorenje IT640-ORA-W?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Gorenje IT640-ORA-W, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Gorenje IT640-ORA-W probablemente compartirá una forma de solucionarlo.