-
American Audio 2500 - page 1
User Instructions AMERICAN AUDIO ® 4295 Charter Street Los Angeles Ca. 90058 4/07 Pr ofessional Power Amplier VLP 2500 ...
-
American Audio 2500 - page 2
This symbol is intended to alert the user to the presence of non insulated "danger ous voltage" within the product's enclosur e that may be of sufcient magnitude to constitute a risk of electric shock to persons. This symbol is intended to alert the user of the presence of important operating and maintenance (servicing) instructio ...
-
American Audio 2500 - page 3
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER. THERE ARE NO USER SERVICEABLE P ARTS INSIDE. REFER ALL SERVICE TO YOUR AUTHORIZED AMERICAN AUDIO ® DEALER. CAUTION Do not open - risk of electric shock FOR OPTIMUM PERFORMANCE AND RELIABILITY DO NOT PRESENT THE AMPLIFIER WITH A SPEAKER LOAD OF LESS THAN 2 OHMS OR ANY COMBINA T ...
-
American Audio 2500 - page 4
Important Pr ecautions • T o reduce the risk of electrical shock or re, do not expose this unit rain or moisture. • Do not spill water or other liquids into or on to your unit. • Do not attempt to operate this unit if the power cord has been frayed or broken. • Do not attempt to remove or br eak off the ground pr ong fr om the electrical ...
-
American Audio 2500 - page 5
PROFESSIONAL POWER AMPLIFIER VLP2500 FHE 9B?F FEM;H '& '+ 9>7 &Z8 '& , ) ' .& )& '+ FHE 9B?F FEM;H '& '+ 9>8 &Z8 '& , ) ' .& )& '+ 1. Channel 1 Gain Contr ol - This rotary knob is used to control the out- put signal of channel one. T ur ning ...
-
American Audio 2500 - page 6
©American Audio® - www .americanaudio.com - VLP 2500 Power Amplifier User Manual Page 6 Rear Panel Contr ol VLP2500 21. Cooling Fans - Dual high speed cooling fans 22. Channel 2 XLR Input - Channel two 3-pin XLR balanced input jack. See page 9 for more details. 23. Channel 2 TRS Input - Channel two 1/4” female jack. Excepts either a bal - anced ...
-
American Audio 2500 - page 7
OUTPUTS: Binding Post/Banana Plug - Connect your speakers to the binding post outputs on the rear of the amplier . The speaker wire may be connect by bare wir e (directly connected, usually for permanent connections), banana plug, or spade connector . Connections are made to Channels 1 and 2 output’ s for ster eo mode or across the red ter - m ...
-
American Audio 2500 - page 8
Spade Connector: (Figure 8) When connecting your speakers to the amplifier using spade connector; Unscrew the red and black caps on the binding post, be sur e not to completely r emove or unscr ew the red and black caps. Insert the spade con- nector in to the binding post and tighten the caps down on the spade connector . T o reduce the risk of sho ...
-
American Audio 2500 - page 9
SPE AKON ASSE MBL Y : Y ou w ill n eed a pa ir of Neu trik S peak on ® N L4FC connectors. Y ou will also need high-quality two or four conductor speaker cable, a pair of needle-nosed pliers and a 1.5-mm Allen key to assemble the Speakon connectors to your speaker wir e. T o assemble the Neutrik Speakon NL4FC connector , complete the following step ...
-
American Audio 2500 - page 10
©American Audio® - www .americanaudio.com - VLP 2500 Power Amplifier User Manual Page 10 OPERATING MODES: Always configure your amplifier operating mode before beginning operation. If you want to change it dur - ing performance. Y ou must decrease the gain controls to their lowest levels to pr otect the speakers from any popping noise. Stereo Ope ...
-
American Audio 2500 - page 11
©American Audio® - www .americanaudio.com - VLP 2500 Power Amplifier User Manual Page 11 Mono Subwoofer - This operation is similar to the Stereo Subwoofer operation but in mono. When running subwoofers it is usually recommended to run them in mono mode to achieve a cleaner tighter low end. This operation allows you to run several subwoofers down ...
-
American Audio 2500 - page 12
©American Audio® - www .americanaudio.com - VLP 2500 Power Amplifier User Manual Page 12 put). Short Circuit Pr otection can usually be traced back to the signal output line (i.e. speaker line). Check the line fr om the output ter - minal of the amplifier to the speaker . If this line good, check the internal speaker connections and components. A ...
-
American Audio 2500 - page 13
©American Audio® - www .americanaudio.com - VLP 2500 Power Amplifier User Manual Page 13 TYPICAL MONO BRIDGE SET -UP SPEAKERS 8 OHM MINIMUM TYPICAL STEREO OUTPUT CONNECTIONS SPEAKERS 4 OHM MINIMUM SPEAKERS 4 OHM MINIMUM Use Channel 1 Inputs Only (XLR or 1/4” Jacks) X Use Speakon or Banana Jacks Use the two positive binding post termainals (red) ...
-
American Audio 2500 - page 14
The VLP 2500 carries a one year limited warranty . W e recommend you fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must be fr eight pre-paid and accompany a R.A. (return authorization) number . If the mixer is under warranty , you must pr ovide a proof of purchase invoice. Y ...
-
American Audio 2500 - page 15
VLP 2500 SPECS Power supply: AC 100V , 50/60Hz (Japan) AC 110V , 60Hz (Colombia) AC 120V , 60Hz (U.S.A. and Canada) AC 127V , 60Hz (Mexico) AC 220V , 50Hz (Chile and Ar gentina) AC 220V , 60Hz (Philippines and Korea) AC 230V , 50Hz (Europe, New Zealand, South Africa, and Singapor e) AC 240V , 50Hz (Australia and U.K.) MODEL: VLP2500 Output Power: 7 ...
-
American Audio 2500 - page 16
©American Audio® American Audio® is part of the American DJ® Gr oup of Companies American DJ® W orld Headquarters: 4295 Charter Street Los Angeles, CA 90058 USA T el: 323-582-2650 / Fax: 323-582-2610 web: www .americanaudio.com / e-mail: info@americanaudio.com ...
¿Tienes una pregunta acerca de American Audio 2500?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con American Audio 2500, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con American Audio 2500 probablemente compartirá una forma de solucionarlo.