-
Harman Stove Company 929BV - page 1
SAFETY NOTICE PLEASE READ THIS ENTIRE MANUAL BEFORE YOU INST ALL AND USE YOUR NEW ROOM HEA TER. F AILURE TO FOLLOW INSTRUCTIONS MA Y RESUL T IN PROPERTY DAMAGE, BODIL Y INJUR Y , OR EVEN DEA TH. IF THIS HARMAN STOVE IS NOT PROPERL Y INST ALLED, A HOUSE FIRE MA Y RESUL T . FOR YOUR SAFETY , FOL- LOW INST ALLA TION DIRECTIONS. CONT ACT LOCAL BUILDING ...
-
Harman Stove Company 929BV - page 2
2 INTRODUCTION ........................................................... 3 INST ALLA TION ............................................................. 4 Clearances ................................................................. 4 V enting ....................................................................... 5 T est for Flue Spillage ........ ...
-
Harman Stove Company 929BV - page 3
3 Introduction The Harman Clarity 929BV V ented Gas Heater is a listed gas-red vented room heater tested by Intertek T esting/W arnock Hersey to ANSI standard Z21.88- 2002, CSA 2.33-M02, and CAN/CGA-2.17-M91. The installation of the Clarity V ented Gas Heater must conform with local codes, or in the absence of local codes, with the current editi ...
-
Harman Stove Company 929BV - page 4
4 In addition to these clearances, adequate accessibil- ity clearance for servicing and proper operation must be maintained. Do not in any way obstruct the combustion air inlets that are located under the heater . If this appliance is installed directly on carpeting, tile or other combustible material other than wood ooring the appliance shall b ...
-
Harman Stove Company 929BV - page 5
5 VENTING Use Only Appr oved V enting The Clarity gas heater is tested and listed for connection to a 4" (100 mm) listed Class B venting system. If the uni t is i ns tal le d to vent thr oug h an appro ve d maso nr y chimney or a factory-built chimney system, an approved Class B chimney liner must be used. Observe local codes when venting the ...
-
Harman Stove Company 929BV - page 6
6 The front is released when levers on the left and right sides are pushed to the rear ASSEMBL Y The Clarity is shipped from the factory with the log set packed inside the rebox. T o prepare the stove for installa - tion, the log set must be unpacked, the appropriate burner system module for either natural gas or propane installed, and the logs ...
-
Harman Stove Company 929BV - page 7
7 Install the Back Log and Back Brick Panel These two components are installed as a single piece. Rest the back brick panel on the shelf located on the back side of the back log, and center it. Holding the two pieces as a single unit, tilt the top forward slightly and manuever it over the top of the rear burner—taking care that the top corners cl ...
-
Harman Stove Company 929BV - page 8
8 Pipe Length Schedule 40 Pipe T ubing, T ype L (Feet) Inside Diameter Outside Diameter RECOMMENDED GAS PIPE DIAMETER NOTE: NEVER USE PLASTIC PIPE. CHECK T O CONFIRM WHETHER YOUR LOCAL CODES ALLOW COPPER TUBING OR GAL V ANIZED PIPE. N.G. L.P . N.G. L.P . 0-10 1/2" 3/8" 1/2" 3/8" 1.3 cm 1.0 cm 1.3 cm 1.0 cm 10-40 1/2" 1/2&qu ...
-
Harman Stove Company 929BV - page 9
9 W ARNING: THIS HEA TER IS EQUIPPED WITH A THREE-PRONGED GROUNDING PLUG THA T SHOULD BE PLUGGED DIRECTL Y INTO A PROP - ERL Y GROUNDED RECEPT ACLE. DO NOT CUT OR R EMO VE TH E GR OU ND IN G PR ONG FRO M THE PLUG. T erminal strip for thermostat connec- tion Rear view of Clarity CONNECTING THE CORDSET The Clarity B-V ent Gas Heater must be installed ...
-
Harman Stove Company 929BV - page 10
10 MONITORING THE GAS FLAME Periodically , the ames of the Clarity B-V ent Gas Heater should be checked while it is operation. The ames should be relatively well-dened and stable. They should be bright yellow with a blue base where attached to the burner ports. The ames should not look orange or sooty . Portions of the logs will glow re ...
-
Harman Stove Company 929BV - page 11
1 1 •If the knob does not pop up when released, stop and immediately call your service technician or gas supplier . •If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call your service technician or gas supplier . 1 1. Turn the gas control knob counterclockwise to "ON." 12. Pl ace the ...
-
Harman Stove Company 929BV - page 12
12 Maintenance A qualied service person recommended by your Harman dealer should conduct an annual inspection and maintenance of your Clarity , its venting, and the installa - tion to keep it running safely and efciently . These pro - cedures should be performed only by a qualied service person. The gas supply should be turned of f wheneve ...
-
Harman Stove Company 929BV - page 13
13 The Clarity B-V ent gas heater , when installed, must be electri - cal ly gro un ded i n a cco rd anc e with local co des o r , in th e absen ce of local codes, with the current edition of the National Electri - cal Code, ANSI/NFP A 70 in the United States or the curr ent Canadian Electrical Code CSA 22.1 in Canada. ...
-
Harman Stove Company 929BV - page 14
14 Parts List The following replacement parts for your Harman Clarity B-V ent are available from your Harman dealer . ID# Part No. Part 1 1-89-08270 BVG weldment 2 1-10-08262-1 Left wing door 3 1-10-08262-2 Right wing door 4 3-40-08286 1/2" gas inlet ex 5 3-40-08235 Rear log 6 3-40-08236 Front log 7 3-40-08237 T op log 8 3-40-08401 Ember st ...
-
Harman Stove Company 929BV - page 15
15 Clarity B-V ent - Exploded V iew ...
-
Harman Stove Company 929BV - page 16
16 40 38 49 37 12 14 13 52 41 44 48 42 43 31 32 33 50 51 Clarity Burner Module - Exploded V iew ...
-
Harman Stove Company 929BV - page 17
17 Appendix A CONVER TING THE CLARITY B-VENT FROM ONE GAS T O ANOTHER IN THE FIELD NOTE: THE CONVERSION SHALL BE CAR- R I E D O U T I N A C C O R D A N C E W I T H T H E R E - QUIREMENTS OF THE PROVINCIAL OR LOCAL AUT HORI TIE S HA VING JUR ISD IC TION A ND IN ACCORDANCE WITH REQUIREMENTS OF THE CUR RE NT ED IT IO N OF THE NA TION AL FUE L GAS CODE ...
-
Harman Stove Company 929BV - page 18
18 Appendix B DE-RA TING FOR HIGH AL TITUDE For U.S. installations, the Clarity B-V ent is approved for elevations up to 2000 feet using the factory-installed burner injec tors. At elevations abov e 2000 fee t, U.S. codes req ui re a d ecr ea se in the input ratin g by c ha ngi ng t he burn er injectors to a smaller size. The chart below lists by p ...
-
Harman Stove Company 929BV - page 19
19 Clarity B V ent Gas Heater Specications T ested to ANSI Z21.88-2002, CSA 2.33-M02, CAN/CGA 2.17-M91. NA TURAL GAS PROP ANE Input Rating (Btu/hr) (0-1375 m) 40,000 40,000 Min. Input Rating (Btu/hr) (0-1375 m) 27,000 28,000 Injector Sizes (DMS) (front/center/rear (0-1375 m) 47/56/39 56/71/53 Manifold Pressure (in w .c./kPa) 3.5/0.87 10.0/2.49 M ...
-
Harman Stove Company 929BV - page 20
20 Harman Stove Company warrants its products to be free from defects in material or workmanship, in normal use and ser - vice, for a period of 6 years from the date of sales invoice and for mechanical and electrical failures, in normal use and service, for a period of 3 years from the date of sales invoice. If defective in material or workmanship, ...
¿Tienes una pregunta acerca de Harman Stove Company 929BV?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Harman Stove Company 929BV, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Harman Stove Company 929BV probablemente compartirá una forma de solucionarlo.