-
iHome iH120 - page 1
Model iH120 Alarm Clock For Your iPod Questions? Visit www.ihomeaudio.com Model: iH120 (Cost down version) Instruction Manual Date: Fen 10, 2009 Print color : Black text on white paper Size: 178W x 178H mm Now Playing K e ith LuBra nt 1:03 - 2:30 A ll I W ant T o Be ...
-
iHome iH120 - page 2
T able of Contents 1 2 3 3 4 5 6 6 7 7 7 8 8 9 10 11 12 Quick Start Controls and Indicators iH120 Display Install Clock Backup Battery Using The Remote Control Unit Install/Replace the Remote Control Battery T o check for iPod compatibility Setting Up the iH120 Setting Time and Calendar Using the Alarm Charging your iPod Listening to iPod Listening ...
-
iHome iH120 - page 3
• Place the unit on a level surface away from sour ces of direct sunlight or excessive heat. • Protect your furniture when placing your unit on a natural wood and lacquer ed finish. A cloth or other protective material should be placed between it and the furniture. • Clean your unit with a soft cloth moistened only with mild soap and water . ...
-
iHome iH120 - page 4
Quick Start 2:inserts Select the dock insert for your iPod model from the table below and place insert in dock. Never dock an iPod without an insert in place. 3:iPod Insert iPod into dock with proper insert (iPod must not be in a skin or case). iPod will charge while docked. Press the Play Button on the iH120 to play iPod. 1:power Attach AC adaptor ...
-
iHome iH120 - page 5
Controls and Indicators 2 Front panel T op panel Alarm-1 Button << Button W ake-to Button Alarm Reset / Power Button V olume + Button V olume - Button iPod Dock Sleep Button >> Button iPod Play/Pause Button Snooze/Dimmer Button Alarm-2 Button Back panel Clock Adj Button Line-in JACK Time Zone Button DST Switch ...
-
iHome iH120 - page 6
3 iH120 Display Install Clock Backup Batterie s The iH120 uses 2 alkaline “AA” batteries to provide continuous alarm operation and clock settings in the event of a power failure. If the backup batteries have been installed and a power failure occurs or the AC cor d is accidentally discon- nected, the display backlight will not remain lit, but c ...
-
iHome iH120 - page 7
Pressing and holding FWD/REW while iPod is docked will scan forward/reverse within currently playing track. 4 Install/Replace the Remote Control Battery The remote contr ol battery is already installed at the factory . When the remote contr ol stops operating or its range seems reduced, it is time to replace the battery with a new one. 1. The batte ...
-
iHome iH120 - page 8
This unit is a PRESET Clock: the clock is preset for the corr ect Eastern Standard Time at the factory . Please follow the steps below to match settings to your location. 1. Depending on your location and whether or not Daylight Saving Time (DST) is in effect, set the DST Switch located on the back of the unit to +1 to add 1 hour or to -1 to subtra ...
-
iHome iH120 - page 9
Setting the Alarms 1. Pr ess and hold the or Button until the alarm icon and alarm time blink. Press the or Button to set the alarm time. Holding the button for a few seconds will advance or reverse rapidly . Remember to set the correct AM or PM time. 2. Press the W ake-to Button to select iPod or Buzzer alarm source. Y ou can set dif ferent alarm ...
-
iHome iH120 - page 10
During normal operation, press the Snooze/Dimmer Button to contr ol the brightness of the LCD display . 1. Dock the already playing iPod. The iH120 will automatically turn on and you will hear the music playing from your iPod. Note: If the playing song/music loudness is too low on the iPod itself, iH120 may not detect iPod is in play mode. Press th ...
-
iHome iH120 - page 11
8 During normal operation, press and hold the W ake-to Button to set button click sound on or off. After the display shows “CLC”, press or Button to set click sound on or of f, then wait around 5 seconds to exit the setting mode. Sleep mode lets you sleep to your iPod, gradually lowering the volume until the unit shuts off at the selected time. ...
-
iHome iH120 - page 12
A Consumer Guide to Product Safety 9 When used in the directed manner , this unit has been designed and manufactur ed to ensure your personal safety . However , improper use can r esult in potential electrical shock or fire hazar ds. Please read all safety and operating instructions car efu lly before installation and use, and keep these instructio ...
-
iHome iH120 - page 13
T rouble Shooting 10 Unit doesn’t respond (no power) iPod cannot dock properly AC adaptor isn’t plugged to a wall outlet or the connector is not plugged into the power supply jack on the back of the unit Wall outlet is not functioning Plug the AC adaptor into a wall outlet and plug the connector into the power supply jack on the unit Plug anoth ...
-
iHome iH120 - page 14
11 Síntoma Posible Problema Solución Solución De Problemas El adaptador de AC no está conectado al tomacorriente o el conector no está conectado a la ficha en la parte posterior de la unidad La unidad no funciona (no circula corriente eléctrica) Conecte el adaptador de AC al tomacorriente y también conecte el conector a la ficha en la parte ...
-
iHome iH120 - page 15
12 iHome Products, a division of SDI T echnologies Inc. (hereafter referred to as SDI T echnologies), warrants this product to be free fr om defects in workmanship and materials, under normal use and conditions, for a period of 90 days from the date of original pur chase. Should this product fail to function in a satisfactory manner , it is best to ...
¿Tienes una pregunta acerca de iHome iH120?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con iHome iH120, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con iHome iH120 probablemente compartirá una forma de solucionarlo.