-
Fluke 23 - page 1
77/75/23/2 1 English Instru ction Sheet Page 1 ® 77/75/23/21 Series III Multimeter Instruction Sheet W Read First: Safe ty Information • Never use the m eter if t he meter or t est leads look dama ged. • Be sure the tes t leads an d switc h are in t he correct p osition for the desir ed measurem ent. • Never meas ure resistanc e in a circ ui ...
-
Fluke 23 - page 2
77/75/23/2 1 English Instru ction Sheet Page 2 Input Jacks V 600V 1000V FUSED CAT CAT Volts, Ohms, Diode Test Common Terminal Amp Milliamp hc1f.eps See Specific ations for overload protection. Autorange The meter defa u lts to autorange w hen you tur n on the meter. Manual Range Manual rangi ng is available in V ac, V dc, ohms, A ac , and A dc. RAN ...
-
Fluke 23 - page 3
77/75/23/2 1 English Instru ction Sheet Page 3 Automatic Touch Hold Mode W Warning To avoid electric shock, do not use the Touch Ho ld mode to determine if a circuit with high voltage i s dead. The Touch Hol d mode will not capture unstable or noisy re adings. The Touch H old mod e automatic ally captures an d displays stable readi ...
-
Fluke 23 - page 4
77/75/23/2 1 English Instru ction Sheet Page 4 Standby If the meter is on but is inactive for an ho ur (20 minutes in diode test), the dis play goes blank and displays four bar graph segments . To resume op eration, turn the rotary switc h or press a button. AC and DC Voltage ( K L m L ) RANGE CAT CAT + __ RANGE CAT CAT + _ RANGE CAT CAT + Volts AC ...
-
Fluke 23 - page 5
77/75/23/2 1 English Instru ction Sheet Page 5 Diode Test ( G ) RANGE CAT + __ Forward Bias Single Beep RANGE CAT CAT + Reverse Bias _ RANGE CAT CAT + Shorted Open and Good Diode Good Diode Bad Diode _ RANGE CAT CAT + Bad Diode hc5f.eps ...
-
Fluke 23 - page 6
77/75/23/2 1 English Instru ction Sheet Page 6 Continuity Test ( R ) RANGE CAT CAT + _ RANGE CAT CAT + _ hc8f.eps If continuity exists (resistance < 210 Ω for Models 21/75 and <270 Ω for Models 23/77), the beeper s ounds c ontinuously. The meter beeps twice if it is in Touc h Hold mode. Current ( ? A ) W Warning To avoid injury, do n ...
-
Fluke 23 - page 7
77/75/23/2 1 English Instru ction Sheet Page 7 Probe Holder hc14f.eps Maintenanc e W Warning To avoid electr ic shock, r emove the test lead s before opening t he case, and close the case before using the met er. To prevent fire and possible arc- flash, use fuses w ith ratings shown on the back of the meter. Caution To avoid cont amination or stati ...
-
Fluke 23 - page 8
77/75/23/2 1 English Instru ction Sheet Page 8 Battery R epla cement Note Before opening the case, make sure t he test leads are removed and the rotary switch is turned to OFF. hc12f.eps Fuse Replace ment F2 F2 F1 F1 23/77 21/75 hc13f.eps Cleaning To clean the m eter, use a damp cloth and mil d detergent; do not use abrasiv es or solv ents on the m ...
-
Fluke 23 - page 9
77/75/23/2 1 English Instru ction Sheet Page 9 Service a nd Part s To contact Fl uke, call one of the follow ing telepho ne numbers: USA and Canada: 1-888-99-FLUKE (1-8 88-993-5853) Europe: +31 402- 678-200 Japan: +81-3- 3434-0181 Singapore: +65- * -276- 6196 Anywhere in the world: +1-425-356-5 500 Or, vis it Fluke’ s Web site at www .fluke.com . ...
-
Fluke 23 - page 10
77/75/23/2 1 English Instru ction Sheet Page 10 Electromagnet ic Compatibility In RF field of 3 V/m on all functi ons. Total a ccuracy = Specified a ccura cy + 0.1% of range. Relative Humidity except 32 M Ω range 32 M Ω range only 0% to 90% (0 ° C to 3 5 ° C) 0% to 70% (35 ° C to 50 ° C) 0% to 80% (0 ° C to 35 ° C) 0% to 70% (35 ° C to 5 ...
-
Fluke 23 - page 11
77/75/23/2 1 English Instru ction Sheet Page 11 Function Range Accuracy L 3.200 V, 32.00 V, 320.0 V 600 V (21/75), 1000 V (23/77) ± (0.3%+1) ± (0.4%+1) m L 320.0 mV ± (0. 3%+1) K (45 to 500 Hz, 3.2 V range. Other ranges 45 to 1 kHz) 3.200 V, 32.00 V, 320.0 V 600 V (21/75), 1000 V (23/77) ± (2%+2) ± (2%+2) 21/75: 23/77: 320.0 Ω 3200 Ω , 32. ...
-
Fluke 23 - page 12
77/75/23/2 1 English Instru ction Sheet Page 12 Overload pro tection for all functions and r anges: Rated voltage . Function Input Impedance (Nominal) L , m L , K >10 M Ω , <50 pF Common Mo de Rejection Ratio (1 k Ω Un balanced) Normal Mode Rejection L , m L >120 dB at dc, 50 Hz, or 60 Hz >60 dB at 50 Hz or 60 Hz K >60 dB dc to 6 ...
¿Tienes una pregunta acerca de Fluke 23?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Fluke 23, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Fluke 23 probablemente compartirá una forma de solucionarlo.