-
Pelco C1666M-A (4/06) 3 - page 1
INST ALLA TION TW3001AR Active Receiver Single Channel for UTP T ransmission C1666M-A (4/06) ...
-
Pelco C1666M-A (4/06) 3 - page 2
...
-
Pelco C1666M-A (4/06) 3 - page 3
C1666M-A (4/06) 3 Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install nea ...
-
Pelco C1666M-A (4/06) 3 - page 4
4 C1666M-A (4/06) Regulatory Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. RADIO AND TELEVISION INTERFERENCE Thi ...
-
Pelco C1666M-A (4/06) 3 - page 5
C1666M-A (4/06) 5 Description The TW3001AR is a single-channel active receiver that can receive live video over unshielded twisted pair (UTP) cable. The adaptive technology in the TW3001AR automatically adjusts the low , medium and high frequency components of the video signal allowing for the best possible video transmission. The adaptive technolo ...
-
Pelco C1666M-A (4/06) 3 - page 6
6 C1666M-A (4/06) PARTS OF THE RECEIVER Figure 1. TW3001AR Parts Rubber Feet (4): For placing unit on a fl at surface, such as a desk or shelf. Status LED: Lights red when there is no UTP video being received. Lights green when there is UTP video being received. Flashes amber when Coaxitron pan/tilt/zoom (PTZ) control commands are being re ...
-
Pelco C1666M-A (4/06) 3 - page 7
C1666M-A (4/06) 7 Installation Make sure all parts are present for the unit. 1 Universal power supply (Part #PS04-1502-0512G) 1 Wall clip 1 2-pin power connector 1 2-pin UTP connector MOUNTING The TW3001AR receiver is 3 rack units high and can be mounted into a fi ber rack, onto a wall using a fiber wall mount kit or into the supplied wall clip. ...
-
Pelco C1666M-A (4/06) 3 - page 8
8 C1666M-A (4/06) USING A WALL CLIP To attach the TW3001AR receiver to a wall using the supplied wall clip, refer to Figure 2 and do the following: 1. Attach the wall clip to a wall using two screws (not supplied). 2. Slide the receiver into the clip until the two holes on the bottom of the receiver align with the two holes on the lower fl ange of ...
-
Pelco C1666M-A (4/06) 3 - page 9
C1666M-A (4/06) 9 SETTING THE DIP SWITCHES Y ou can override the adaptive technology by manually adjusting switches 1-4 on the DIP Switch. The factory default switch positions are shown in Figure 3. Switches 1-4 are set to AUTO and Switch 5 is set to High Mode. Figure 3. Default Switch Positions If you want to transmit video over 4,000 feet (1,219 ...
-
Pelco C1666M-A (4/06) 3 - page 10
10 C1666M-A (4/06) APPLICATIONS Y ou can connect the TW3001AR active receiver to transmitters, such as the TW3001P passive trans- ceiver and the TW3001A T active transmitter , and to Pelco UTP cameras, such as the CC3710/CC3610 Series. Although you can connect these products using an unshielded twisted pair Cat3 and Cat5 cable, Cat5e and Cat6 are r ...
-
Pelco C1666M-A (4/06) 3 - page 11
C1666M-A (4/06) 11 Figure 4 shows a TW3001AR connected to a UTP camclosure. Figure 4. TW3001AR Connected to a UTP Camclosure + - CAMCLOSURE TW3001AR UTP MONITOR 12 VDC OR 24 VAC POWER SUPPLY BLUE WIRE = GRAY WIRE = POWER FROM RK5000PS-3U OR ...
-
Pelco C1666M-A (4/06) 3 - page 12
12 C1666M-A (4/06) Figure 5 shows a TW3001AR connected to a UTP fi xed camera. Figure 5. TW3001AR Connected to a UTP Fixed Camera + - TW3001AR FIXED CAMERA 8 PINS (4-/5+) MONITOR UTP PIN 5 + PIN 4 - 10 PINS (5-/6+) 12 VDC OR 24 VAC POWER SUPPLY POWER FROM RK5000PS-3U OR ...
-
Pelco C1666M-A (4/06) 3 - page 13
C1666M-A (4/06) 13 Figure 6 shows a TW3001AR connected to a UTP Spectra dome for Coaxitron PTZ control. Figure 6. TW3001AR Connected to a Spectra Dome + - TW3001AR UTP VIDEO COAXITRON SPECTRA MONITOR MATRIX VC-UTP BOARD 12 VDC OR 24 VAC POWER SUPPLY POWER FROM RK5000PS-3U OR ...
-
Pelco C1666M-A (4/06) 3 - page 14
14 C1666M-A (4/06) Figure 7 shows a TW3001AR connected to a TW3001P passive transceiver . The TW3001P then connects to a non-UTP fi xed camera. Figure 7. TW3001AR Connected to a Single Passive T ransceiver + - TW3001AR TW3001P UTP MONITOR DIRECT CONNECTION FIXED CAMERA 12 VDC OR 24 VAC POWER SUPPLY POWER FROM RK5000PS-3U OR ...
-
Pelco C1666M-A (4/06) 3 - page 15
C1666M-A (4/06) 15 Figure 8 shows a TW3001AR connected to a TW3032P passive transceiver . Figure 8. TW3001AR Connected to a 32-Channel Passive T ransceiver + - TW3001AR TW3032P MONITOR UTP 12 VDC OR 24 VAC POWER SUPPLY POWER FROM RK5000PS-3U OR ...
-
Pelco C1666M-A (4/06) 3 - page 16
16 C1666M-A (4/06) Figure 9 shows a TW3001AR connected to a TW3004P passive transceiver . The TW3004P then connects to a non-UTP fi xed camera. Figure 9. TW3001AR Connected to a 4-Channel Passive T ransceiver + - TW3001AR TW3004P 1 2 3 4 UTP MONITOR FIXED CAMERA 12 VDC OR 24 VAC POWER SUPPLY POWER FROM RK5000PS-3U OR ...
-
Pelco C1666M-A (4/06) 3 - page 17
C1666M-A (4/06) 17 Specifications ELECTRICAL Input Voltage 12 VDC or 24 VAC, 50-60Hz Power Consumption 2.5 watts Wire T ype Unshielded T wisted Pair (24 AWG maximum) Wire Category Cat3 or better DC Loop Resistance 52 ohms per 1,000 feet Differential Capacitance 19pF/ft max T ransient Immunity 300 W peak pulse power (8/20 US) Insertion Loss 72 dB o ...
-
Pelco C1666M-A (4/06) 3 - page 18
18 C1666M-A (4/06) ...
-
Pelco C1666M-A (4/06) 3 - page 19
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or workmanship for a period of one year after the date of shipment. Exceptions to this warranty are as noted below: • Five years on FR/FT/FS Series fiber optic products and TW3000 Series unshielded twisted p ...
-
Pelco C1666M-A (4/06) 3 - page 20
Worldwide Headquarters 3500 Pelco Way Clovis, California 93612 USA USA & Canada T el: 800/289-9100 Fax: 800/289-9150 International T el: 1-559/292-1981 Fax: 1-559/348-1120 www.pelco.com ISO 9001 United States | Canada | United Kingdom | The Netherlands | Singapore | Spain | Scandinavia | France | Middle East ...
¿Tienes una pregunta acerca de Pelco C1666M-A (4/06) 3?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Pelco C1666M-A (4/06) 3, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Pelco C1666M-A (4/06) 3 probablemente compartirá una forma de solucionarlo.