-
Sony SFM1 - page 1
INSTALLATION MANUAL SFM1 Sony Electronics, Inc. 16540 West Bernardo Drive San Diego, CA 92127 www.sony.com IN-SFM1.R2 ...
-
Sony SFM1 - page 2
PBL-110 Projector Mount Page - 2 - Installation Manual ...
-
Sony SFM1 - page 3
SFM1 Installation Manual Page - 3 - Table of Contents WARNING STATEMENTS ............................................................................................................ ................. - 4 - PARTS LIST .................................................................................................................... ................ ...
-
Sony SFM1 - page 4
SFM1 Page - 4 - Installation Manual Warning Statements WARNING: THE WALL STRUCT URE MUST BE CAPAB LE OF SUPPORTING AT LE AST FIVE (5) TIMES THE WEIGHT OF THE DISPLAY. IF NOT, THE WALL STRUCTURE MUST BE REINFORCED. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVIC E TECHNICIAN, AS OUTLINED IN THE IN STALLATION INSTRUCTIONS, MUST BE ADHERED TO. FAI ...
-
Sony SFM1 - page 5
SFM1 Installation Manual Page - 5 - Parts List NOTE: This wall mount is shipped with all proper installation hardware and com ponents. Make sure that none of these parts are missing and/or damaged be fore beginning installati on. If there are parts missing and/or damaged, please stop the installa tion and contact Sony Electronics (800)222-7669. Wal ...
-
Sony SFM1 - page 6
SFM1 Page - 6 - Installation Manual Flat Panel Mount Location WARNING : INVERT THE FLAT PANEL. PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILUR E TO DO SO WILL RESULT IN DAMAGING THE FLAT P AN EL. DO NOT LAY THE FLAT PANEL ON THE FLOOR WITHOUT ANY PROTECTION TO THE GLASS. THE FLAT PANEL IS HEAVY ...
-
Sony SFM1 - page 7
SFM1 Installation Manual Page - 7 - Figure 3. Mounting Bracket Installation NOTE : The mounting guides are designed w ith a center viewing guide on the side of them . There will be a “notch” cut on the side of the bracket (Figure 4 ). Figure 4 . Locating the Center of the Flat Panel 2. Match the center of the viewi ng guide with the cente rline ...
-
Sony SFM1 - page 8
SFM1 Page - 8 - Installation Manual Griplates™ 1. The Griplates™ have M4, M5, M6 a nd M8 hole patterns to fit the hardwa re that the flat panel requires. Example : If your display uses M8 x 20 Phillips head screws. Use the M8 mounting points (Figure 5). Figure 5 . Griplates™ Orientation 2. Once the mounting brackets are aligned, secure the Gr ...
-
Sony SFM1 - page 9
SFM1 Installation Manual Page - 9 - Wood Stud Location 1. Using a stud finder, locate the 16” or 24” stud centers behind the wall. 2. Once found, make a pencil mark on the center of the wood studs (Figure 7). NOTE : The wall plates have three 16” and 12” mounting slot positions. 16" Figure 7 . Locating the Wooden Stud 3. Measure from t ...
-
Sony SFM1 - page 10
SFM1 Page - 10 - Installation Manual Marking the Mounting Points 1. Place the bottom portion of the wall plate to the refere nce line and m ark the four (4) lag bolt mounting points through the wall pl ate slots on the wall. 2. Level the wall plate with the reference ar row pointing up to the ceiling (Figure 9). 16" Figure 9 . Marking the Moun ...
-
Sony SFM1 - page 11
SFM1 Installation Manual Page - 11 - 3. Use the information below when mounting to the following surfaces (Figure 10): Wood Studs : Drill four (4) ¼” pilot holes to the marked wall. Concrete Wall : Drill four (4) 3/8” pilot holes to the m arked wall 16" Figure 10 . Mounting Surfaces Securing the Wall Plat e to the Wooden Studs 1. Level an ...
-
Sony SFM1 - page 12
SFM1 Page - 12 - Installation Manual Securing the Wall Plat e to a Concrete W all 1. Level and secure the plate to the wa ll with the reference arrow f acing up to the ceiling. 2. Use a minimum diameter of 5/16” x 2 ¼” wedge anchors – commercially available (Figure 12). CAUTION : Do not overtighten the wedge anchor bolts. NOTE : Use a minimu ...
-
Sony SFM1 - page 13
SFM1 Installation Manual Page - 13 - Securing the Flat Panel to the Wall Mount WARNING : At least (2) qualified personnel are strongly recommended for installati on of this product. Failure to do so could result in se rious injury and possible da mage to the flat panel. 1. Raise the flat panel with the LEFT and RIGHT mounting brackets secured to th ...
-
Sony SFM1 - page 14
SFM1 Page - 14 - Installation Manual CSL2 Security Cable 1 3 4 2 ...
-
Sony SFM1 - page 15
SFM1 Installation Manual Page - 15 - Technical Specifications (127) (36.91) (31.75) (606 .92) (406.4) (406.4) (406.4) (49.53) (711.2) (88.9) A. Wall plate B. Mounting brackets C. ¼” x 20 Safety scre ws D. Leveling feet Figure 15. Technical Specifications ...
-
Sony SFM1 - page 16
SFM1 Page - 16 - Installation Manual Warranty Limited Lifetime Warranty This product carries a limited lifetime warranty from ship date against defects in materials and workm anship. Sony Electronics is not liab le for improper installation that results in damage to mounts, adapters, display equipment or personal injury. Customer Support In the eve ...
¿Tienes una pregunta acerca de Sony SFM1?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Sony SFM1, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Sony SFM1 probablemente compartirá una forma de solucionarlo.