-
Carrier Access KTA - page 1
Adapter KT A Series User Manual ...
-
Carrier Access KTA - page 2
1. Introduction ............................................................................................................................... ............................ 3 2. Sketch ............................................................................................................................... ..................................... ...
-
Carrier Access KTA - page 3
1. Introduction KT A series is one of V oIP te rminal products, with one port connecting with regular PSTN term inal devices and one port connecti ng with Internet. It transfers voice through net. By the m anagement of soft-switch pla tform and the support of tele com, KT A can com municate with V oIP term inals and dial to regula r phone inexpensi ...
-
Carrier Access KTA - page 4
2.2 LED Indicators RX TX MSG Phone Service Power Power —— Power On LED TX —— Network data being transmitted RX —— Network data being received Service —— Service connected (Remains illum inated wh en successfully logged-on to server) Phone —— phone in operation (phone in-used when light on means workin g under V oIP , when lig ht ...
-
Carrier Access KTA - page 5
(3) Plug one side of the RJ-1 1 of phone line to the PHONE Port(FXS) ⑤ of KT A, plug another sid e of the phone line into u ser te r minal (phone, line entrance to P ABX, etc.). (4) If you are the KT A1010,KT A101 1’ s user , put the phone line to the LINE Port(FXO) ⑥ of KT A, you will hav e the both function of V oIP and PSTN. (5) Plug the a ...
-
Carrier Access KTA - page 6
After network connection, please pick up handset, press key “#*047#” to hear IP address of the adaptor box. In the address field of browser, type the IP address and pres s ENTER to display the Settings page. A log-in page will be s hown. Enter log-in password to set parameters. The default password is 1234. If adaptor box cannot get IP, enter ? ...
-
Carrier Access KTA - page 7
HCP: If your router (or other network device) is conf igured to allocate an IP address to the KTA D automatically then you can simply set the KTA up for DHCP operation and no other network parameters need to be completed. PPPoE : If your ADSL modem (or other network device) doe s not allow you to conf igure PPPoE then you may need to configure this ...
-
Carrier Access KTA - page 8
Instruction: Depending on your service provider the KTA may display “gk zone” instead of “service address”. Notice: If login failed, contact your se rvice carrier t o adjust parameters. Do not aj ust default value in most cases. ¾ Audio Setting s Audio codec otice: A ll above audio par ameters are default settings. Con tact your operator t ...
-
Carrier Access KTA - page 9
¾ Upgrade Click “Update Firmware” of the right-bottom of setting page. KTA would autom atical ly reboot after up radin g, th en pl ease press key s on the phone as #358# （ #DLT# ） to restore default settings an d rebo ot again! Note: If you have been instructed to use the “Upgrade Tool ” to perfor m the upgrade then you will need to en ...
-
Carrier Access KTA - page 10
Every KT A can call any land or mobil e phone anywhe re in the world. Please dial with the service carrier’ s dialing rule. Press “#” after you dial the phone number . Example 1: If a U.S service carrier’ s dialin g rule: T o call a U.S or Cana da number , please first dial 1, then the telephone num ber . KT A user calling an U.S/Canad a re ...
-
Carrier Access KTA - page 11
Please input the forwarding number Please type in the tar get number , which will be forwarded to. Notice: Call forwarding target number must be a PSTN number, with more than 7 digits. Example 1: If a U.S service carrier ’ s di aling rule: T o forward to a U.S or Canada number , please first dial 1, then the telephone num ber . KT A user wants to ...
-
Carrier Access KTA - page 12
z Humidity: 10% to 90% no dew 5.3 Dimensions z 166.4x 1 19x 31.6mm (L x W x H) 6. Frequent Problems and Solutions Problems Probably Causes Solutions Bandwidth < 30Kbps Unacceptable voice quality under V oIP Unstable network quality: Delay>500ms or jitter>100ms or package loss>10% Using in network environment as stable and qualified as y ...
-
Carrier Access KTA - page 13
z V oice active detection z Comfortable noise generation z Echo cancellatio n z Dynamic buf fer managem ent—minimize ef fect to voice qu ality caused by audio delay jitter z Supports NA T z Supports.H.323/SIP z Supports Remote Upgra de z Supports Call Forwarding z Lightningproo f 7.2 Standards and agreements z IEEE 802.3 10 Base-T z G .71 1A, G . ...
-
Carrier Access KTA - page 14
impact, and do not leave the product in dump or highly humid conditions! Current user manual is made based on the functions of present pr oducts, if any content change has made, no further notice. 14 ...
¿Tienes una pregunta acerca de Carrier Access KTA?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Carrier Access KTA, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Carrier Access KTA probablemente compartirá una forma de solucionarlo.