-
Kenmore 153.32116 - page 1
Use & Care Guide Model No. 153.321160 60 Gallon 153.321180 80 Gallon C LLC US I<enmore® Elite @ For potable water heating only. Not suitable for space heating. INSTALLER: Afflx these instructions to or near the water heater. OWNER: Retain these instructions for future reference. Si no puede leer o entender el ingles y necesita el manual de ...
-
Kenmore 153.32116 - page 2
Your safety and the safety of others is extremely important in the installation, use and servicing of this water heater. Many safety-related messages and instructions have been provided in this manual and on your own water heater to warn you and others of a potential injury hazard. Read and obey all safety messages and instructions throughout this ...
-
Kenmore 153.32116 - page 3
Read and understand instruction manual and safety messages before installing, operating or servicing this water heater. Failure to follow instructions and safety messages could result in death or serious injury. Instruction manual must remain with water heater. Improper installation and use may result in property damage. • Do not operate water he ...
-
Kenmore 153.32116 - page 4
10 -YEAR LIMITED WARRANTY ON WATER H EATER For ten years from the date of purchase, if this water heater is installed and operated in a single-family home in accordance with the owner's manual instructions and all local applicable plumbing codes, Sears will: 1. Supply free water heater parts for those that are defective in material or workmans ...
-
Kenmore 153.32116 - page 5
SAFE INSTALLATION, USE AND SERVICE ....................................................................................................................................... 2 GENERAL SAFETY .................................................................................................................................................................. ...
-
Kenmore 153.32116 - page 6
Thank You for purchasing a Sears water heater. Properly the absence of Local Codes, with the current edition ofthe installed and maintained, itshould give you years oftrouble free service. It isstrongly suggested that this new water heater be professionally installed, contact the local Sears Service Center or any Sears store. They wilt arrange for ...
-
Kenmore 153.32116 - page 7
Materials Needed To simplify the installation Sears has available the installation parts shown below. You may or may not need all of these materials, depending on your type of installation. WATER HEATER INSTALLATION KIT WITH FLEXIBLE CONNECTORS FOR 3/4" THREADED OR COPPER PLUMBING. EXPANSION TANKS FOR THERMAL EXPANSION CONDITIONS AVAILABLE IN ...
-
Kenmore 153.32116 - page 8
Removing the Old Water Heater FIGURE 2. 1. Turn "OFF" electrical supply to the water heater. The water passing out of the drain valve may be extremely hot. To avoid being scalded, make sure all connections are tight and that the water flow is directed away from any person. 4. Check again to make sure the electrical supply is turned " ...
-
Kenmore 153.32116 - page 9
Mineral Buildup or Sediment MayAccumulate • This causes the water heater to become much heavier than normal. • If spilled, could causestaining. Mineral buildup or sediment may have accumulated in the old water heater. This causes the water heater to be much heavier than normal and this residue, if spilled out, could cause staining. Facts to Con ...
-
Kenmore 153.32116 - page 10
Water Piping System Water temperature over 125°F (52°C) can cause severe burns instantly resulting in severe injury or death. Children, the elderly, and the physically or mentally disabled are at highest riskfor scald injury. Feel water before bathing or showering. Temperature limiting valves are available. Read instruction manual for safe temper ...
-
Kenmore 153.32116 - page 11
8. After piping has been properly connected to the water heater, open the nearest hot water faucet. Then open the cold water shut off valve and allow the tank to completely fill with water. To purge the lines of any excess air and sediment, keep the hot water faucet open for 3 minutes after a constant flow of water is obtained. Close the faucet and ...
-
Kenmore 153.32116 - page 12
Temperature-Pressure Relief Valve Explosion Hazard Temperature-pressure relief valve must comply with ANSI Z21.22 CSA 4.4 andASME code. • Properly sized temperature-relief valve must be installed in opening provided. • Can result in overheating and excessive tank pressure. • Can cause serious injury or death. This heater is provided with a pr ...
-
Kenmore 153.32116 - page 13
Filling the Water Heater Property Damage Hazard • Avoid water heater damage. • Fill tan kwith water before operating. Never use this water heater unless it is completely full of water. To prevent damage to the tank and heating element, the tank must be filled with water. Water must flow from the hot water faucet before turning "ON" po ...
-
Kenmore 153.32116 - page 14
8. Connect the electrical supply to the water heater. NOTE: Remove the standard 1/2 inch knock-out (opening) in the junction box for conduit connections. 9. Connect ground wire to green ground wire in the electrical junction box of the water heater. 10. Reinstall the junction box cover. 11. Reattach the left touvered access panel to the water heate ...
-
Kenmore 153.32116 - page 15
Water Heater Location Condensate Drain Line [] Centrally located with the water piping system. [] The flooring beneath the water heater must be able to support the weight of the water heater when filled with water (See Table 1). [] Located indoors (such as a basement or garage) and in a vertical position. Sheltered from freezing temperatures. [] Pr ...
-
Kenmore 153.32116 - page 16
or state law requiring a certain temperature water at the hot water Before Using 1, 2, 3, 4, 5, 6, 7, Make sure the water heater has been properly installed. See "Installing Your Water Heater" section. Make sure the air filter is correctly seated, as it may shift during shipping or installation. See "Repair Parts Illustration" s ...
-
Kenmore 153.32116 - page 17
Operating Mode Descriptions The operating modes can be changed by touching the desired mode icon on the User Interface Module (see Figure 16.) NOTE: All buttons on the User Interface are touch sensitive and require only a light touch to actuate. ® HyE3R4D © ELECTRIC Hybrid Mode - This is the default, recommended setting. Combining high energy eff ...
-
Kenmore 153.32116 - page 18
If after manually operating the valve, it fails to completely reset and continues to release water, immediately close the cold water inlet to the water heater, follow the draining instructions, and replace the temperature-pressure relief valve with a new one. Failure to install and maintain a new properly listed temperature- pressure relief valve w ...
-
Kenmore 153.32116 - page 19
1. Press the power button on the user interface module to place the water heater in Standby Mode. 2. Turn off the power to the water heater. 3, FIGURE 18. Drain the water heater as directed in the "Draining and Flushing" section. • Burn hazard • Hotwater discharge. • Keep hands clear of drain valve discharge. 4, 5. 6. Remove the acc ...
-
Kenmore 153.32116 - page 20
2. Remove (slide) the filter from the unit. 3. If you are replacing the filter skip to step 4. To clean the filter use a vacuum with a hose attachment to remove any dust or debris. 4. Place the new or cleaned filter into the water heater and secu re the filter to the shroud with the screw loosened earlier. NOTE: Use the guides/slots when inserting ...
-
Kenmore 153.32116 - page 21
Start Up Conditions THERMAL EXPANSION Property Damage Hazard • Avoid water heater damage. • Install thermal expansion tank or device if necessary. • Contact qualified installer or service agency. As water is heated, it expands (thermal expansion). In a closed system, the volume of water wilt grow. As the volume of water grows, there wilt be a ...
-
Kenmore 153.32116 - page 22
"AIR" IN HOT WATER FAUCETS Explosion Hazard • Flammable hydrogen gases may be present. • Keep all ignition sources away from faucet when turning on hot water. HYDROGEN GAS: Hydrogen gas can be produced in a hot water system that has not been used for a long period of time (generally two weeks or more). Hydrogen gas is extremely flamma ...
-
Kenmore 153.32116 - page 23
CORRECTIVE ACTION 1. 1. DISPLAY SHOWS UPPER ELEMENT CONNECT FAU LT LOWER ELEMENT CONNECT FAU LT 1. INDICATES Upper element is not functioning Lower element is not functioning 2. 1. 2. Turn off power at the circuit breaker/fuse box and check for a loose connection at the element. For access directions see "Element Removal/Replacement" sect ...
-
Kenmore 153.32116 - page 24
PROBLEM CORRECTIVE ACTION NO HOT WATER 1. 1. INSUFFICIENT HOT WATER/ SLOW HOT WATER RECOVERY HIGH OPERATION COSTS DRIP FROM TEMPERATURE & PRESSURE RELIEF VALVE (Warning: Do not plug or cap T&P discharge pipe.) OTHER 2, 3. POSSIBLE CAUSE(S) No power to the water heater (power button not lit) Unit in standby (power button RED) Unit in Vacatio ...
-
Kenmore 153.32116 - page 25
Never use this water heater unless it is completely full of water. To prevent damage to the tank and heating element, the tank must be filled with water. The water must flow from the hot water faucet before turning "ON" power. A. *Condensation may be seen on pipes in humid weather or pipe connections may be leaking. ® ® B. Small amounts ...
-
Kenmore 153.32116 - page 26
KENMORE ELITE HYBRID ELECTRIC HEAT PUMP WATER HEATERS 153.321160 60 Gallon 153.321180 80 Gallon ITEM NO. 1 2 3 4 5 6 MODEL NUMBER PARTS DESCRIPTION 153.321160 153.321180 Upper Access Cover 409230-000 409230-000 Lower Access Cover 409231-000 409231-000 Upper Element (4500 Watts) 9007479015 9007479015 Lower Element (2000 Watts) 9003946115 9003946115 ...
-
Kenmore 153.32116 - page 27
27 ...
-
Kenmore 153.32116 - page 28
Your Home For troubleshooting, product manuals and expert advice: managemylife www.managemylife.com For repair - in your home - of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner's manuals that you need to do-it ...
¿Tienes una pregunta acerca de Kenmore 153.32116?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Kenmore 153.32116, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Kenmore 153.32116 probablemente compartirá una forma de solucionarlo.