-
Haier HWM62-0566 - page 1
User's manual This manual is for HWM62-0566 Please read this manual carefully before using. Retain it for future reference. Fully automatic washing machine ...
-
Haier HWM62-0566 - page 2
Contents Names of the parts Safety precautions T rouble shooting Packing list Specification Installation and adjustment Usage of the drain hose Preparation before washing Put in the laundries Usage of the detergent Close the top lid Installation the water inlet hose Disposal after washing * Finish washing Use the operation buttons Answer to questio ...
-
Haier HWM62-0566 - page 3
1 Please check if the power receptacle has good earthing condition before using to guarantee your safety . W arning sign Names of the parts Meaning and description of the symbols Forbidding sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the ...
-
Haier HWM62-0566 - page 4
2 Safety precautions Please insert the power cord into special receptacle with rated vol- tage.Be sure to use single-phase three pins receptacle.The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector. When the machine is normally using, please put the power plug at the location easily to ...
-
Haier HWM62-0566 - page 5
3 Do not decompose, repair or alter the machine by yourself. Do not put any hot or heavy items (such as the kettle with hot water ) on the washing machine. Do not wash laundries with volatile materials (such as thinner, petrol etc.) The handicapped or children without care shall not use the machine. Keep the machine away from direct sunlight and he ...
-
Haier HWM62-0566 - page 6
4 Installa tion and adjustment Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Install the inner cover component 1.Open the top lid of the washing machine. 2.Put the inner cover component on the outer tub cover, a iming the inner cover shaft t ...
-
Haier HWM62-0566 - page 7
5 1. The height of the drain hose shall be less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way. 2. Do not trample or press the drain hose. 3. If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly. 4. If extra drain hose is ne ...
-
Haier HWM62-0566 - page 8
6 The exit end face of the faucet Confirm the water faucet Connection between the water inlet hose jointer and the water faucet water faucet, suitable water fauce t, not suitable It is required that the front end shall be longer than 10mm. The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage. 2 Loosen the ...
-
Haier HWM62-0566 - page 9
7 Connection between the water inlet hose and the washer Dismantle the water inlet hose Connection between the jointer of the water inlet hose and the water inlet hose Check the connection between the jointer of the water inlet hose and the water faucet 1. Do not take off the water absorption cushion. Please check if the cushion is dropped or damag ...
-
Haier HWM62-0566 - page 10
8 1 Preparation before washing Preparation before washing 1.Connect the water inlet hose. Open the water faucet. 2.Confirm that the washing machine is earthed reliably. Then insert the power plug into the receptacle. The earth terminal shall not link to gas pipeline and faucet water pipeline. 3.Put down the drain hose. Pay attention to followings b ...
-
Haier HWM62-0566 - page 11
9 2 Put in the laundries The capacity of washing and spinning of he machine refer to the largest weight ofthe standard laundries under dry conditionthat can be washed or spinned in one time. One time washing quantity shall be lower than the rated capacity. The thickness, size, type of the cloth will influence the actual washing capacity. It is suit ...
-
Haier HWM62-0566 - page 12
10 4 Close the top lid Except draining, if the top cover is opened, the washing machine will stop running and alarm. Description of the function of buttons 5 Use the operation buttons Page 15 Mode and meaning of the indicators The light is off Flashing: indicate the running program or indicate the water level On: indicate the program about to run, ...
-
Haier HWM62-0566 - page 13
11 Quick Quick and high-efficiency wash for common laundries Jeans Fibre Cotton Standard Tub dry Posthaste Program button Following automatic programs are available for selection Program Common During common and standard programs, the washing machine can detect the laundries automatically . After de tection, it will set the water level to suitable ...
-
Haier HWM62-0566 - page 14
12 b Steps of using the operation buttons and description of each step. Page 1 1 WA SH SOAK RINSE SPIN FLASH LIGHT FLASH LIGHT ST ANDARD COMMON FUZZY POSTHASTE QUICK JEANS FIBRE COTTON TUB DRY ST ART/P AUSE PROCESS/FUNCTION RESERVE WA T E R LE V E L PROGRAM POWER HEA VY WASH HEA VY RINSE HEA VY SPIN GENTLE SPIN Push the "POWER ON/OFF " bu ...
-
Haier HWM62-0566 - page 15
13 Page 10 WATER LEVEL water pressure and water level influence the wash time. Push the SELECT button for 6 times, and it will resume the initial mode. It will circulate in that sequence. When the "PROCESS/FUNCTION" button is on the "FUNCTION" state, push - "PROCESS/FUNCTION"button,it will circulate as nether sequence: ...
-
Haier HWM62-0566 - page 16
14 Figure 1 7 Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it may I nfluence your using the machine. Please first pull off the power plug from the receptacle before cleaning. 1.The method of dismantle:Push it up aslant and gently. Clean the detergent box and set it on the ...
-
Haier HWM62-0566 - page 17
15 Common phenomena Phenomena Explanation The wash procedure is paused The digitron displays E0. The safety switch acts, and the spin- ning cannot work. Amend twice automatically ,The digitron displays E3. The water filling does not work, or is slow. The digital displays E4. The drainage cannot work, or is too slow. The digitron displays E1. It sto ...
-
Haier HWM62-0566 - page 18
16 Packing list User's manual One piece Name T apping screws Quantity Bottom plate One piece The end connecting to the washing machine Jointer connecting the water inlet hose to the water faucet The end connecting to the water inlet hose jointer Inner cover component One piece Fully automatic washing machine W ater level/W ater quantity (about ...
¿Tienes una pregunta acerca de Haier HWM62-0566?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Haier HWM62-0566, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Haier HWM62-0566 probablemente compartirá una forma de solucionarlo.