-
Dometic RM3862 - page 1
INST ALLA TION AND OPERATING INSTRUCTIONS REFRIGERA TOR FOR LP-GAS AND ELECTRIC OPERA TION RM 3862 USA Corporate Office CANADA Service Office 2320 Industrial Parkway Elkhart, IN 46515 Dometic Distribution Inc. Dometic Corporation 866 Langs Drive 509 South Poplar S treet Cambridge, Ont ario LaGrange, IN 46761 For Service Center Assist ance N3H 2N7 C ...
-
Dometic RM3862 - page 2
...
-
Dometic RM3862 - page 3
3 FIG. 1 12V DC Cover , Reigniter Power module cover Flexible cord Drain water hose 12 volt T erminal block Inlet fitting Manual gas shutoff valve Burner jet Screw for protection cover Protection cover Flue baffle Heater FIG. 2 D B ON OFF AC GAS CHECK AES AUT O COLD 1 2 3 4 5 COLDEST CLC LAC AC G EF 12 3 4 5 Refrigerator control p anel LEGEND 2-W A ...
-
Dometic RM3862 - page 4
4 INST ALLA TION GENERAL INSTRUCTION This appliance is designed for storage of foods and storage of frozen foods and making ice. This appliance is certified under the latest edition of ANSI Z21.19 • CSA 1.4 Refrigerators using gas fuel. The installation must conform with local codes, or in ab- sence of local codes, the following standards as appl ...
-
Dometic RM3862 - page 5
5 12 V olt s DC Connection This refrigerator model require a continuous 12 volt DC supply to maintain the automatic energy system. The connection is made to the positive (+) and negative (-) terminals located at the rear of the refrigerator . (See FIG . 1). Correct polarity must be observed when con- necting to the DC supply . Do not use the chassi ...
-
Dometic RM3862 - page 6
6 2. Once the lower front strip is slipped under the hinge, the part is possible to swing into place as shown in FIG . 6. 3. Secure the refrigerator and the lower front strip with two screws: One screw through the hinge, and on the opposite side one screw through the lower front strip. (FIG. 6). STEP 2: Two screws installed in the top frame. The to ...
-
Dometic RM3862 - page 7
7 CERTIFIED INST ALLA TION Certified installations require one roof vent and one lower side vent. For “Certified V ent System Kit s” see p age 14 . For further information contact your dealer or distributor . CLEARANCES Minimum clearances in inches to combustible materials are: G: Top 0 K: Side 0 L: Bottom 0 M: Rear 0 N: See NOTE: Clearance “ ...
-
Dometic RM3862 - page 8
8 OPERA TING INSTRUCTIONS IMPORT ANCE OF LEVELING A REFRIGERATOR In an absorption refrigerator system, ammonia is lique- fied in the finned condenser coil at the top rear of the refrigerator. The liquid ammonia then flows into the evaporator (inside the freezer section) and is exposed to a circulating flow of hydrogen gas, which causes the ammonia ...
-
Dometic RM3862 - page 9
9 THERMOST A T The thermostat on the refrigerator controls both the gas and electric operation, thereby eliminating the necessity of resetting each time a different energy source is em- ployed. After the initial start-up, the thermost at should be moved from “ COLDEST ” to the desired temperature setting, usually at mid setting. TO SHUT OFF THE ...
-
Dometic RM3862 - page 10
10 DESCRIPTION OF OPERA TING MODES AES/AUTO MODE When operating in the AES/AUTO mode, the AES/AUTO mode indicator lamp (B) will illuminate. The control sys- tem will automatically select between AC and GAS op- eration with AC having priority over GAS. Either the AC indicator lamp (A) or the GAS indicator lamp (C) will illu- minate depending on the ...
-
Dometic RM3862 - page 11
11 ! WARNING When all the frost has melted, dry the interior of the re- frigerator with a clean cloth. Replace all food and set the thermostat to the COLDEST temperature setting for a few hours. Then reset the thermostat to the desired set- ting, usually at mid setting. CLEANING Cleaning the refrigerator is usually done after it is defrosted or put ...
-
Dometic RM3862 - page 12
12 ELECTRIC EQUIPMENT HEA TER The heat necessary for the operation of an absorption cooling unit is supplied by an electric heater mounted in a pocket of the boiler system. This model is equipped with one electric heater for 120 volt AC. To replace the heater proceed as follows: 1. Disconnect the wall plug, and the 12 volt wires. 2. Remove the powe ...
-
Dometic RM3862 - page 13
13 B. Check all connections in the LP gas system (at the back of the refrigerator) for gas leaks. The LP gas supply must be turned on. Apply a non-corrosive bubble solution to all LP gas connections. The appearance of bubbles indicates a leak and should be repaired immediately by a QUALIFIED SER VICEMAN WHO IS F AMILIAR WITH GAS SYS- TEM AND REFRIG ...
-
Dometic RM3862 - page 14
14 TROUBLESHOOTING The Refrigerator Does Not Cool Properly A. Burner jet clogged. Clean. (See Section Maintenance & Service, item 2. Periodic maintenance, Paragraph E item 1-13. B. Check level of refrigerator. C. Venting problem. Restriction in air flow across cooling unit. D. Heavy frost buildup on evaporator fins. Defrost. E. Flue baffle not ...
-
Dometic RM3862 - page 15
15 Put a screwdriver into the slot of the shelf lock. Turn the screwdriver counterclockwise. Remove the shelf locks from the wire shelf. Insert the ends of the wire shelf on the left-hand side at the desired position. Slide the wire shelf to the left. The right-hand side of the shelf will come loose. Slide the shelf into the holes on the right-hand ...
-
Dometic RM3862 - page 16
16 RM 3862 MO-FO 0309 ...
¿Tienes una pregunta acerca de Dometic RM3862?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Dometic RM3862, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Dometic RM3862 probablemente compartirá una forma de solucionarlo.