-
Sears 47006 - page 1
OWNER’S MANUAL Model No. 47006 Sears Canada Inc., 222 Jarvis St., Toronto, Ontario, Canada M5B 2B8 40/2 AMP MANU AL BA TTER Y CHARGER 200 AMP ENGINE ST ARTER CAUTION: Read and Follow All Safety Rules and Operating Instructions Before Every Use of this Product. ...
-
Sears 47006 - page 2
1 Sears 006 - Sch 552 11/2/95 T able Of Contents W arranty .................................................................. 1 Important Safety Instructions ................................. 2 P arts ......................................................................... 3 Before Using Y our Battery Charger ........................ 4 Assembling ...
-
Sears 47006 - page 3
2 Sears 006 - Sch 552 11/2/95 – SAVE THESE INSTRUCTIONS – w •Read all instructions and cautions printed on the battery charger, battery, and vehicle or equipment using battery. •Use charger only on lead-acid type rechargeable batteries, such as those used in cars, trucks, trac- tors, airplanes, vans, RV’s, trolling motors, etc. This charg ...
-
Sears 47006 - page 4
3 Sears 006 - Sch 552 11/2/95 Description Handle Negative (BLK) cable w/clamps Positive (RED) cable w/clamps Power Cord Circuit Breaker Asm Rectifier Assembly Transformer Owner's Manual (not shown) Wheel Hub Cap Axle Axle mtg. bracket Mounting Foot Rocker Switch 3 pos. Ammeter Rocker Switch 2 pos. Pa r t s This section shows an illustration of ...
-
Sears 47006 - page 5
4 Sears 006 - Sch 552 11/2/95 B e fo r e Using Y our B a t ter y C har g er It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground and connect the power cord, and prepare to charge a battery. Assembling your charger It is important to fully assemble your charger before use. Follow these instr ...
-
Sears 47006 - page 6
5 Sears 006 - Sch 552 11/2/95 3. Tap the other axle cap onto the opposite end of the axle and place the axle assembly onto the bottom of the charger. Place one end of the bracket into slot, then place the axle assembly under each bracket. Fasten the other side of the brackets using the two 10-32 screws provided. To attach the handle: Turn the charg ...
-
Sears 47006 - page 7
6 Sears 006 - Sch 552 11/2/95 A TEMPORARY adapter may be used to connect the charger to a two-pole outlet if a properly grounded outlet is not available. Use the adapter ONLY until a properly grounded outlet can be installed by a qualified electrician. DANGER: Before using an adapter as illustrated, be certain that the center screw of the outlet pl ...
-
Sears 47006 - page 8
7 Sears 006 - Sch 552 11/2/95 To obtain the best results from your battery charger, you must know how to use it properly. This section will tell you how to set the controls. And how you can charge a battery while it is still in the vehicle, or you can remove it and then charge it. Follow the instructions below depending on how you choose to charge ...
-
Sears 47006 - page 9
8 Sears 006 - Sch 552 11/2/95 Charging Y our Battery Charging your battery in the vehicle: 1. Arrange the power cord and charging leads carefully in order to avoid damage that could be caused by the hood, door, or moving engine parts. 2. Keep clear of the fan blades, belts, pulleys, and other parts that can cause injury. 3. Check the polarity of th ...
-
Sears 47006 - page 10
9 Sears 006 - Sch 552 11/2/95 Charging your battery outside the vehicle: 1. Remove the battery from vehicle, making sure to disconnect grounded terminal first with all power turned off to the vehicle. 2. Check the polarity of the battery posts as indicated on the battery case: POSITIVE (POS, P, +) and NEGATIVE (NEG, N, -). NOTE: On top-post batteri ...
-
Sears 47006 - page 11
10 Sears 006 - Sch 552 11/2/95 Calculating charge time The Chart Method Use the following table to more accurately determine the time it will take to bring a battery to full charge. First, identify where your battery fits into the chart. • Small batteries — motorcycles, garden tractors, etc. — are usually rated in Ampere Hours (AH). For examp ...
-
Sears 47006 - page 12
11 Sears 006 - Sch 552 11/2/95 Using the engine start feature Your battery charger can be used to jump-start your car if the battery is low. Follow these instructions on how to use the engine start feature. 1. Set the right-hand OUTPUT SELECTOR switch to the OFF position. Then follow the instructions for connecting the charger to the battery in the ...
-
Sears 47006 - page 13
12 Sears 006 - Sch 552 11/2/95 Circuit breaker in charger cycles on and off with a clicking sound. Short start cycle when cranking engine. Ammeter reads less than selected charge rate when charging a discharged battery. Charger makes a loud buzz or hum. T roubleshooting Performance problems often result from little things that you can fix yourself. ...
-
Sears 47006 - page 14
When requesting service or ordering parts, always provide the following information: • Product T ype • Model Number • Part Number • Part Description OWNER’S MANUAL Model No. 47006 40/2 AMP MANU AL BA TTER Y CHARGER 200 AMP ENGINE ST ARTER F or information about troubleshooting Call toll-free from anywhere in the U.S.A. or Canada 7 am to 4 ...
¿Tienes una pregunta acerca de Sears 47006?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Sears 47006, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Sears 47006 probablemente compartirá una forma de solucionarlo.