-
Directed Audio D1200 - page 1
models D1200 D2400 OWNER’S MANUAL ...
-
Directed Audio D1200 - page 2
2 2 © 2005 Directed Electronics, Inc. all rights reserved T ABLE OF CONTENTS CONGRA TULA TIONS Congratulations for choosing a Directed Audio power amplifier from Directed Electronics, the industr y leader in high quality automotive security and audio equipment since 1990. Directed Audio power amplifiers continue to set new standards of perfor- man ...
-
Directed Audio D1200 - page 3
LIMITED TWO-YEAR CONSUMER W ARRANTY 3 3 © 2005 Directed Electronics, Inc. all rights reserved Directed Electronics, Inc. promises to the original purchaser , to replace this product should it prove to be defective in workman- ship or material under normal use, for a period of two years from the date of purchase by the dealer as indicated by the da ...
-
Directed Audio D1200 - page 4
4 4 © 2005 Directed Electronics, Inc. all rights reserved High-powered car audio systems may produce sound pressure levels that exceed the threshold at which hearing loss may result. They may also impair a driver’ s ability to hear traffic sounds or emergency vehi- cles. Use common sense and practice safe listening habits when listening to or ad ...
-
Directed Audio D1200 - page 5
5 5 © 2005 Directed Electronics, Inc. all rights reserved INST ALLA TION GUIDELINES 1. Please read this owner’ s manual carefully before installing this ampli- fier . 2. Disconnect the batter y ground terminal prior to making any elec- trical connections. 3. Check for any hazards or obstruc- tions such as gas tanks, fuel or brake lines, and wiri ...
-
Directed Audio D1200 - page 6
6 6 © 2005 Directed Electronics, Inc. all rights reserved guide. Minimum wire gauge recom- mendations for the individual ampli- fiers are listed on the specification page. Always use the same gauge wire for the amplifier ground that you use for the power wire. Be sure to examine the batter y ground cable of the vehicle, and if neces- sar y , upgra ...
-
Directed Audio D1200 - page 7
7 7 © 2005 Directed Electronics, Inc. all rights reserved 1. R R C C A A I I n n p p u u t t J J a a c c k k s s - - Accepts line level outputs from head units or signal processors at voltages between 150mV and 7.5 volts. 2. R R C C A A L L i i n n e e O O u u t t p p u u t t J J a a c c k k s s - - These pass through RCA jacks can be used to send ...
-
Directed Audio D1200 - page 8
8 8 © 2005 Directed Electronics, Inc. all rights reserved D1200/D2400 1 2 3 4 5 6 7 8 91 0 11 12 13 FIGURE 1—AMPLIFIER CONNECTIONS/CONTROLS D1200/D2400 FRONT BLACK BL UE BLACK RED - + - + TO LEDs TO FAN FIGURE 2—LED/F AN HARNESS ...
-
Directed Audio D1200 - page 9
9 9 1. F F u u s s e e s s - - These fuses protect the amplifier against internal electrical damage and are meant to protect the amplifier only . All other power connections should be fused at the source. The D1200 uses 2-30A fuses, and the D2400 uses 3-40A fuses. 2. ( ( + + ) ) 1 1 2 2 V V o o l l t t P P o o w w e e r r - Connect this terminal th ...
-
Directed Audio D1200 - page 10
1 1 0 0 © 2005 Directed Electronics, Inc. all rights reserved D1200 D2400 FUSE 40A x 3 FIGURE 2—AMPLIFIER CONNECTIONS - REAR ESP ® ® FEA TURES AND CONTROLS These amplifiers incorporate an on-board Directed ESP ® Engine. In addition to allowing menu-driven parameter adjust- ment*, operate with security products from Directed Electronics to inc ...
-
Directed Audio D1200 - page 11
1 1 1 1 © 2005 Directed Electronics, Inc. all rights reserved to the other . Bitwriter ® commands can control para- meters such as T urn on Delay , Fan Control, Input Gain adjustment, and also place the amplifier into a monitoring state for commands from an ESP2 equipped alarm. 1. T T u u r r n n - - O O n n D D e e l l a a y y - - 0.75, 1.00, 1. ...
-
Directed Audio D1200 - page 12
1 1 2 2 © 2005 Directed Electronics, Inc. all rights reserved If selected while the remote power is on, the amplifier will continue playing until the remote power is turned off. T o Clear V alet Mode, Disable V alet mode on the alarm, then cycle the remote power line off then on again. The amplifier will power up normally after the T urn On Delay ...
-
Directed Audio D1200 - page 13
1 1 3 3 © 2005 Directed Electronics, Inc. all rights reserved unlit, but still indicates ser vice codes or faults using the top light. 9. L L e e a a r r n n T T X X I I D D s s D D e e f f a a u u l l t t O O f f f f . . Before the unit will respond to Arm/Disarm/Valet Commands from the alarm system, it needs to establish communica- tions with th ...
-
Directed Audio D1200 - page 14
1 1 4 4 © 2005 Directed Electronics, Inc. all rights reserved The ESP ® Status indicator flashes to indicate the current operational mode. This can be used in conjunc- tion with the Power LED to help determine the source of the problem. N N o o t t e e : Remember that the Directed ESP ® Engine incorporates a digital gain control with a finite nu ...
-
Directed Audio D1200 - page 15
1 1 5 5 © 2005 Directed Electronics, Inc. all rights reserved SPEAKER WIRING DIAGRAMS Single subwoofer connection (top view) T wo subwoofer connection (top view) N N O O T T E E : : The dual + and -- sub-out terminals of the D600/D800/D1200/D2400 are paralleled internally and the combined load impedance should be taken into consideration when conn ...
-
Directed Audio D1200 - page 16
1 1 6 6 © 2005 Directed Electronics, Inc. all rights reserved N N N N O O T T E E O O T T E E : Remember that the Directed ESP ® amplifiers use a digital gain control with a finite number of adjust- ment steps. A very small adjustment may not cause any audible change in level. The Directed D1200/D2400 subwoofer amplifiers have the capability of c ...
-
Directed Audio D1200 - page 17
1 1 7 7 © 2005 Directed Electronics, Inc. all rights reserved Refer to figure 5 for wiring details. 1. I I n n p p u u t t S S i i g g n n a a l l - Connect these RCA jacks as described in the Front Panel Connection section of this guide. 2. S S l l a a v v e e / / M M a a s s t t e e r r S S w w i i t t c c h h Set the slave/master switch on ...
-
Directed Audio D1200 - page 18
1 1 8 8 © 2005 Directed Electronics, Inc. all rights reserved FIGURE 5—P ARALLEL SYNC GAINED D1200/D2400 MASTER SLA VE Subwoofer Wiring (top view) N N O O T T E E : : The dual + and -- sub-out terminals are paralleled internally and the combined load impedance should be taken into consideration when connecting multiple subwoofers. INPUT R L INPU ...
-
Directed Audio D1200 - page 19
1 1 9 9 © 2005 Directed Electronics, Inc. all rights reserved 1. I I n n p p u u t t S S i i g g n n a a l l - Connect these RCA jacks as described in the Front Panel Connection section of this guide. 2. S S l l a a v v e e / / M M a a s s t t e e r r S S w w i i t t c c h h Set the slave/master switch on the master amplifier to the MASTER pos ...
-
Directed Audio D1200 - page 20
2 2 0 0 © 2005 Directed Electronics, Inc. all rights reserved FIGURE 5—EXTERNAL SYNCED BRIDGE INPUT R L INPUT R L LINE OUT SLA VE MASTER SLA VE MASTER MASTER AMPLIFIER SLA VE AMPLIFIER LINE OUT 0° 180° PHASE 0° 180° PHASE MASTER SLA VE Subwoofer Wiring (top view) ...
-
Directed Audio D1200 - page 21
2 2 1 1 © 2005 Directed Electronics, Inc. all rights reserved MUL TIPLE AMPLIFIER COMBINA TIONS The Directed D1200/D2400 subwoofer amplifiers can also be used in multiples of the master/slave combinations allowing for unlimited expansion to a systems subwoofer section. T o use multiples of amplifier combinations the following directions must be ad ...
-
Directed Audio D1200 - page 22
2 2 2 2 © 2005 Directed Electronics, Inc. all rights reserved CROSSOVER SETTINGS AND GAIN ADJUSTMENT Y our Directed Audio power amplifier needs to be adjusted carefully to achieve maximum performance. These are some guidelines to follow when fine-tuning the amplifier . Because this amplifier is only designed for subwoofer applications, the low ...
-
Directed Audio D1200 - page 23
2 2 3 3 © 2005 Directed Electronics, Inc. all rights reserved LED TUBE INST ALLA TION (OPTIONAL) This Directed Audio amplifier has been designed with a custom heat sink that can accommodate two (optional—not supplied) V ARAD LED tubes. 1. Before installing the LED tubes, remove and discard the mounting feet from the V ARAD LED tubes. 2. Slide ea ...
-
Directed Audio D1200 - page 24
2 2 4 4 © 2005 Directed Electronics, Inc. all rights reserved CEA SPECIFICA TIONS D D 1 1 2 2 0 0 0 0 Power Output: 300 Watts RMS x 1 at 4 ohms and < 1% THD+N Signal to Noise Ratio: -60 dBA (reference 1 Watt into 4 ohms) Additional Power: 600 Watts RMS x 1 at 1 ohm and < 1% THD+N D D 2 2 4 4 0 0 0 0 Power Output: 400 Watts RMS x 1 at 4 ohms ...
-
Directed Audio D1200 - page 25
2 2 5 5 © 2005 Directed Electronics, Inc. all rights reserved SPECIFICA TIONS D D 1 1 2 2 0 0 0 0 D D 2 2 4 4 0 0 0 0 Maximum W atts 1200W 2400W RMS continuous Power 1 400W 800W RMS continuous Power 2 600W 1200W Frequency Response 20-250Hz 20-250Hz Damping Factor 50 50 V ariable Low Pass Crossover 12dB slope 30-250Hz 30-250Hz Subsonic Filter Ye s ...
-
Directed Audio D1200 - page 26
The company behind this system is Directed Electronics, Inc. Since its inception, Directed has had one purpose, to provide customers with the finest vehicle security , car stereo products, rear seat entertainment, and accessories avail- able. The recipient of more than 20 patents in the field of advanced electronic tech- nology , Directed is ISO 90 ...
¿Tienes una pregunta acerca de Directed Audio D1200?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Directed Audio D1200, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Directed Audio D1200 probablemente compartirá una forma de solucionarlo.