-
Smeg SNL34AX1 - page 1
Contents 23 1 INSTRUCTIONS FOR SAFE A ND PROPER USE ____________________ 24 2 POSITIONING OF THE HOB ____________________________________ 26 3 ELECTRICAL CONNECT ION ____________________________________ 28 4 GAS CONNE CTION ___________________________________________ 29 5 ADAPTATION TO DIFFER ENT TYPES OF GAS _____________________ 31 6 FINAL OPER A ...
-
Smeg SNL34AX1 - page 2
Introduction 24 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKING HOB. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKING HOB. ALSO KEEP THE SERIES OF NOZZLES SUPP ...
-
Smeg SNL34AX1 - page 3
Introduction 25 THE IDENTIFICATION PLATE, WITH TECHNICAL DATA, SERIAL NUMBER AND MARKING IS CLEARLY VISIBLE UNDER THE CASING. THE PLATE ON THE CASING MUST NOT BE REMOVED. BEFORE CONNECTING THE DEVICE, MAKE SURE THAT IT HAS BEEN REGULATED FOR THE TYPE OF GAS THAT WILL FEED IT, CHECKING THE LABEL UNDER THE HOB. DO NOT PUT PANS WITHOUT PERFECTLY SMOOT ...
-
Smeg SNL34AX1 - page 4
Instructions for the installer 26 2 POSITIONING OF THE HOB The following operation requ ires building and/or carpentr y work so must be carried out by a competent tradesman. Installation can be carried out on vari ous materials such as masonry, metal, solid wood or plastic laminat ed wood as long as they are heat resistant (T 90°C). 2.1 Attachment ...
-
Smeg SNL34AX1 - page 5
Instructions for the installer 27 Bracket ‘ A ’ in the 1st slot Bracket ‘ A ’ in the 2nd slot Bracket ‘ B ’ 2.2 Fixing 90 cm hobs on 60 cm base unit If a 90 cm hob is to be bracketed to a 6 0 cm base unit, 2 central brackets “ A ” have to be us ed in addition to the sid e brackets “ B ” as shown in the drawin g below. The gas co ...
-
Smeg SNL34AX1 - page 6
Instructions for the installer 28 3 ELECTRICAL CONNECTION Make sure that the voltage and capacity of the power lin e conform to the data shown on the plate located under the casing. Do not remov e this plate for any reason. The plug on th e end of the supply cable a nd the wall socket must be the same type and conform to the curr ent electrical sys ...
-
Smeg SNL34AX1 - page 7
Instructions for the installer 29 4 GAS CONNECTION Connection to the gas mains may be made with a rigid copper pipe or with a flexible pipe and conforming to the pr ovisions defined by standard regulations in force. To facilitate connection, fitting A on the r ear of the appliance m ay be adjusted laterally. For this purpose, lo osen hexagon nut B ...
-
Smeg SNL34AX1 - page 8
Instructions for the installer 30 4.1 Connection to LPG Use a pressure regulator and make the con nection to the tank according to the provisio ns of standards regulations in force. Make sure that feed pressure conforms to the leve ls shown in the tab le in paragraph “5.3 Regulation for LPG”. 4.2 Ventilation of rooms The hob may be inst alled o ...
-
Smeg SNL34AX1 - page 9
Instructions for the installer 31 5 ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any c leaning or maintenance work, disconnect the appliance from the electrical socket. The hob has be en inspected for G25 (2L3B/P) natural gas at a pressure of 25 mbar. For function ing with other types of gas the nozzles must be replaced and the primary ai ...
-
Smeg SNL34AX1 - page 10
Instructions for the installer 32 5.3 Regulation for LPG Check that the connection h as been made as descri bed in the “Gas connection” section. Undo the screw “ D ” and push the air regul ator “ C ” fully down. Use a spanner to remove the nozzles “ B ” and fit those of suitabl e type following the instructions given in the tables f ...
-
Smeg SNL34AX1 - page 11
Instructions for the installer 33 5.4 Regulation for G25/25 mbar The hob has been ins pected for G25 (2L3B/P) at a pressure of 2 5 mbar. To allow the unit to work wit h this type of gas, perform the same operations described in paragrap h “5.3 Regulation for LPG”, but choose the nozzles and r egulate the primary air f or natural gas, as shown i ...
-
Smeg SNL34AX1 - page 12
Instructions for the installer 34 5.5 Regulation of primary air Referred to distance “ A ” in mm. 60 cm hobs with separable control panel. Burner G25 25 mbar G30/G31 28/37 mbar Auxiliary (1) 2.5 2.5 Semirapid r (2) 0.5 2.0 Semirapid l (3) 0.5 1.5 Rapid large (4) 0 2.5 Ultrarapid (5) 2.0 4.0 90 cm hobs with separable control panel. Burner G25 25 ...
-
Smeg SNL34AX1 - page 13
Instructions for the installer 35 6 FINAL OPERATIONS Having carried out the a bove adjustments, reassemble t he appliance following, backwards, the inst ructions in paragraph “5.1 Removing the separable control pa nel / 5.2 Removing the hob”. 6.1 Regulation of minimum for natural gas Replace the compo nents on the burner and slide the knobs on ...
-
Smeg SNL34AX1 - page 14
Instructions for the installer 36 6.3 Arrangement of the burners on the hob (Hob with separable control panel) 60 cm. hob BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid large 5. Ultrarapid 90 cm. hob BURNERS 1. Auxiliary 2. Semirapid 3. Rapid 4. Fish burner 5. Ultrarapid ...
-
Smeg SNL34AX1 - page 15
Instructions for the installer 37 6.4 Arrangement of the burners on the hob (Hob with built-in control panel). 60 cm. hob BURNERS 1. Auxiliary 2. Semirapid r 3. Semirapid l 4. Rapid 5. Ultrarapid 6.5 Lubrication of gas taps With time it may happen that the gas taps get blocked and h ard to turn. Clean them inside and r e-grease them. This operation ...
-
Smeg SNL34AX1 - page 16
Instructions for the user 38 7 USING THE HOB Before turning on the burners, make sure that the burn er rings, caps and grids have been fitted cor rectly. In the ultrarapid burner, notch A must be aligned wit h pin B . Grid C provided is intended for use with wok s (Chinese pans). Adapter D com es only with open grids models and is int ended for use ...
-
Smeg SNL34AX1 - page 17
Instructions for the user 39 while cook ing, all pans o r griddles must b e positioned within the coo king hob perimeter and must be a minimum distance of 3-4 cm from the knobs. 7.3 Diameter of the pans Burners Ø min. and max. (en cm.) Auxiliary 12-14 Semirapid 16-20 Rapid medio 22-26 Rapid large 22-26 Ultrarapid 22-26 Fish burner Special oval-sha ...
-
Smeg SNL34AX1 - page 18
Instructions for the user 40 or fish. 5 Strong For roasts, steaks and large boil ed joints. 6 Very strong To boil large amounts of w ater, to fry. WARNING When switching on the electric element for the first time, or if the electric element has not been used for a long time, to remove any humi dity from the insulating material it should be dr ied o ...
-
Smeg SNL34AX1 - page 19
Instructions for the user 41 8 CLEANING AND MAINTENANCE Never use a steam jet to clean the appliance. Before any intervention, disconnect the power supply of the device. 8.1 Cleaning Clean the cooking top regul arly every time you use it, obviously after it has cooled. 8.1.1 Regular daily cleaning of the hob In order to clean an d preserve the surf ...
-
Smeg SNL34AX1 - page 20
Instructions for the user 42 8.2 Cleaning of cooking hob components CAUTION: do not wash these components in a dishw asher. In normal use of the hob, the stai n less steel burner caps and pa n- stands tend to be burnishe d by the high temperatur e. Clean these parts using very fine abrasive sponges or simil ar commercial products. Then use a specif ...
¿Tienes una pregunta acerca de Smeg SNL34AX1?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Smeg SNL34AX1, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Smeg SNL34AX1 probablemente compartirá una forma de solucionarlo.