-
Honda 08E92-SNA-100B - page 1
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 1 of 21 08E92-SNA-1B00-91 FEB 2008 200 6-2008 CIVIC 4-DOOR (A/T ONLY) REMOTE ENGINE STARTER SYSTEM INSTALLATION INSTRUCTIONS Accessory Application Publications No. Issue Date Control unit bracket Relay bracket 3 Black relays (4-pin) 18 Wire ties Remote Engine Start ...
-
Honda 08E92-SNA-100B - page 2
2 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 7 Foam cushion tapes Flange nut Clip Green relay (5-pin) Template Illustration of the Engine Starter System Installed on the Vehicle 7401010T ENGINE STARTER HARNESS ANTENNA RELAY (5-PIN) 2 FUSES 40A 3 RELAYS (4-PIN) CONTROL UNIT 2 FUSES 3A TOOLS AND SUPPLIE ...
-
Honda 08E92-SNA-100B - page 3
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 3 of 21 Setting the Control Unit 3. Get the control unit. Using a small flat-tip screwdriver, adjust the switches on the control unit to the locations shown. Using a isopropyl alcohol on a shop towel, clean the area where the protective tape will attach. Attach the ...
-
Honda 08E92-SNA-100B - page 4
4 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 8. Remove the driver’s dashboard lower cover (eight clips). 5202121T DRIVER’S DASHBOARD LOWER COVER 8 CLIPS 7. If equipped, remove the driver’s dashboard under cover (turn the knob counterclockwise, and release two clips and pin). 5202112T KNOB DRIVER ...
-
Honda 08E92-SNA-100B - page 5
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 5 of 21 9. Lower the tilt lever, and pull the steering wheel toward you. Insert a long blade flat-tip screwdriver along the guide of the column lower cover, and pry the retaining tab of the column upper cover. 10. Push on the column lower cover in the area shown to ...
-
Honda 08E92-SNA-100B - page 6
6 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 1 3. Remove the sunvisor holders. Using a small flat- tip screwdriver, push the hook, and turn the holder 90°, then pull it out. 12. If equipped, use a small flat-tip screwdriver to remove the left and right lens from the map light console (four retaining ...
-
Honda 08E92-SNA-100B - page 7
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 7 of 21 1 8. Pull away the weatherstrip from the left front pillar trim. Remove the left front pillar trim (two clips). 5202100T 2 CLIPS LEFT FRONT PILLAR TRIM WEATHERSTRIP 1 9 . Remove the clip from the left front pillar trim, and install a new clip on the left fr ...
-
Honda 08E92-SNA-100B - page 8
8 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 23. Measure the antenna cable as shown. Attach the three foam cushion tapes to the antenna cable in the measurement shown. 2 4. Using isopropyl alcohol on a shop towel, clean the area where the antenna will attach. Allow the area to dry before proceeding. 2 ...
-
Honda 08E92-SNA-100B - page 9
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 9 of 21 27. Route the antenna cable under the roof liner towards the driver’s side of vehicle, and down along the vehicle harness. Be careful not to crease the roof liner. 28 . Continue routing the antenna cable between the front pillar and the dashboard. 5308192 ...
-
Honda 08E92-SNA-100B - page 10
10 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 3 4. Install the four relays to the engine starter harness relay blocks. Be careful to install the relays properly, or a malfunction will result. Routing the Engine Starter Harness 3 3. Attach the 3 A fuse labels to the engine starter harness fuse case, an ...
-
Honda 08E92-SNA-100B - page 11
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 11 of 21 3 7. Disconnect the vehicle 8-pin connector on the rear of the wiper switch and plug the engine starter harness 8-pin connector into the vehicle 8-pin connector. 3 8. Secure the connected 8-pin connector with a wire tie to the engine starter harness. 6D011 ...
-
Honda 08E92-SNA-100B - page 12
12 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 3 9. Wrap the vehicle 7-pin connector with one foam cushion tape, then place the vehicle 7-pin connector into the gap of the column. 6D01111T VEHICLE 7-PIN CONNECTOR (brown) (Squeeze into this area.) FOAM CUSHION TAPE VEHICLE 7-PIN CONNECTOR VEHICLE BRACKE ...
-
Honda 08E92-SNA-100B - page 13
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 13 of 21 4 6 . Secure the engine starter harness to the vehicle harness using a wire tie. • With driver's dashboard under cover: Secure in the hole you made in the instrument panel. • Without driver's dashboard under cover: Secure through the existing ...
-
Honda 08E92-SNA-100B - page 14
14 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 5 0. Wrap foam cushion tape to the vehicle 2-pin and 4-pin connectors and secure them with a wire tie. Then, secure the vehicle harness with a wire tie. Reconnect the vehicle 42-pin connector. 6D01292T 4-PIN CONNECTOR PORT 2-PIN CONNECTOR PORT FOAM CUSHION ...
-
Honda 08E92-SNA-100B - page 15
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 15 of 21 5 3. Install the clip from the engine starter harness to the fuse box bracket behind the fuse box. 6D01181T ENGINE STARTER HARNESS FUSE BOX BRACKET CLIP FRONT GROUND BOLT (Reuse.) ENGINE STARTER HARNESS GROUND TERMINAL 51 . Connect the engine starter harne ...
-
Honda 08E92-SNA-100B - page 16
16 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 6 0. Check that all wire harnesses are routed properly and all connectors are plugged in. 6 1. Reinstall all removed parts. Check that all clips and other fasteners are installed securely. Take care not to pinch the airbag with a clip during reinstallation ...
-
Honda 08E92-SNA-100B - page 17
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 17 of 21 752501AS CAR ICON 752502AS CHECK BUTTON Input the VIN and other required information. 752504AS Select “R/C ENG STARTER.” CHECK BUTTON 752503AS Select “Honda Systems.” CHECK BUTTON REMOTE ENGINE STARTER REGISTRATION 1. Acquire the PCM code from ISIS ...
-
Honda 08E92-SNA-100B - page 18
18 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 752505AS “REMARKS” message CHECK BUTTON 752506AS Select “REGISTER REMOTE CONTROL ENGINE STARTER UNIT.” CHECK BUTTON 752507AS “Obtain PCM-code" message CHECK BUTTON 752509AS Input the PCM code. CHECK BUTTON 7. A REMARKS message will display. ...
-
Honda 08E92-SNA-100B - page 19
© 2008 American Honda Motor Co., Inc. - All Rights Reserved. AII 38216-38957 (0802) 19 of 21 752510AS "Registration" message CHECK BUTTON 752511AS “Check that the engine can be started by the Transmitter” CHECK BUTTON 1 1. The following message will display: The registration of the Remote Control Engine Starter Unit has been complete ...
-
Honda 08E92-SNA-100B - page 20
20 of 21 AII 38216-38957 (0802) © 2008 American Honda Motor Co., Inc. - All Rights Reserved. 732904A Y DISPLAY COMMAND BUTTON START BUTTON TRANSMITTER STOP BUTTON FUNCTION CHECK Operating Conditions • The hood is closed. • Shift lever is in Park. • The key is not in the ignition switch. • All doors and trunk are closed and locked. Inspecti ...
¿Tienes una pregunta acerca de Honda 08E92-SNA-100B?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Honda 08E92-SNA-100B, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Honda 08E92-SNA-100B probablemente compartirá una forma de solucionarlo.