-
Radio Shack PLCD9MR - page 1
OWNER’S MANUAL Mobile Audio System • CD Player • PLL Synthesizer Stereo Radio • Compact Disc Player • Automatic Memory Storing • Full Detachable Panel • Preset Equalization • Electronic Shockpr oof (ESP) Function • Auxiliary Input Function • Remote Control www .pyleaudio.com PLCD9MR ...
-
Radio Shack PLCD9MR - page 2
2 CONTENTS Installation ...........................................3 T ake out screw befor e installation.........3 DIN Front-Mount (Method A) ................3 Installing the unit .................................3 Removing the unit ...............................4 DIN Rear -Mount (Method B) .................5 Using the detachable front panel .... ...
-
Radio Shack PLCD9MR - page 3
3 INST ALLA TION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver . • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly . • Use only the parts included with the unit to ...
-
Radio Shack PLCD9MR - page 4
grounding of the unit. Note to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard. 10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace the outer trim ring and install the unit's front panel. (see the steps of “installin ...
-
Radio Shack PLCD9MR - page 5
DIN REAR-MOUNT (Method B) If your vehicle is a Nissan, Toyota, follow these mounting instructions. Use the screw holes marked T (T oyota), N (Nissan) located on both sides of the unit to fasten the unit to the factory radio mounting brackets supplied with your vehicle. T o fasten the unit to the factory radio mounting brackets. Align the screw hole ...
-
Radio Shack PLCD9MR - page 6
USING THE DET ACHABLE FRONT P ANEL REMOVING THE FRONT P ANEL 1. Pr ess the release button (RELEASE) on the front panel and pull of f the front panel. 2. Keep fr ont panel into the case. INST ALLING THE FRONT P ANEL T o install the front panel, insert the panel into the housing and make sure the panel is properly installed. Otherwise, abnormality oc ...
-
Radio Shack PLCD9MR - page 7
7 WIRING CONNECTION FRONT Lch SPEAKER GREEN GREEN/BLACK MEMORY BACK-UP (B+) MAIN UNIT IGNITION SWITCH (ACC+) POWER ANTENNA RED GROUND (B–) YELLOW BLACK BLUE RCA CABLE ANTENNA CONNECTOR (GREY) Rch RED Lch WHITE WHITE WHITE/BLACK REAR Lch SPEAKER VIOLET VIOLET/BLACK GREY GREY/BLACK FRONT Rch SPEAKER REAR Rch SPEAKER FUSE FUSE ...
-
Radio Shack PLCD9MR - page 8
8 OPERA TION LOCA TION OF KEYS 24 7 9 14 3 6 15 5 8 4 11 10 25 2 1 23 22 21 20 18 13 19 17 12 16 26 ...
-
Radio Shack PLCD9MR - page 9
9 OPERA TION SWITCHING ON/OFF THE UNIT Switch on the unit by pressing any button (except button (7) and button (4)). When system is on, press button (9) to turn off the unit. F ACEPLATE RELEASE Press button (7) to detach the removable faceplate. SOUND ADJUSTMENT Press SEL button (10) to select the desir ed adjustment mode. The adjustment mode will ...
-
Radio Shack PLCD9MR - page 10
10 RADIO OPERA TION • SWITCHING TO RADIO MODE Press MODE button (6) shortly to select radio mode, the radio mode appears in the display together with the memory band and frequency . • SELECTING THE FREQUENCY BAND At radio mode, press BND/LOU (ENT) button (13) shortly to select the desired band. The reception band will change in the following or ...
-
Radio Shack PLCD9MR - page 11
11 OPERA TION • PLA YING ALL TRACKS IN RANDOM Press SHF button (23) to play all tracks on CD in random order . Press again to cancel the function. • EJECTING A DISC Press button (4) to stop CD playing and eject the disc from the disc slot (5). ...
-
Radio Shack PLCD9MR - page 12
12 REMOTE CONTROL HANDSET FUNCTION KEYS & CONTROL 1. PWR Power ON/OFF Button 2. DSP Display Button 3. SEL Sound Mode Select Button 4. VOL V olume Up Button 5. VOL V olume Down Button 6. BND (LOU) Band Select Button (When pressed shortly) Loudness Button (When pressed long) 7. MODE Mode Button 8. TUNE/SKIP/CH T une/SKIP Down Button 9. TUNE/SKIP/ ...
-
Radio Shack PLCD9MR - page 13
13 OPERA TION DISC NOTE A. Notes on discs: 1. Attempting to use non-standard shape discs (e.g. square, star , heart) may damage the unit. Be sure to use r ound shape CD discs only for this unit. 2. Do not stick paper or tape etc., onto the label side or the recor ding side of any discs, as it may cause a malfunction. 3. Dirt, dust, scratches and wa ...
-
Radio Shack PLCD9MR - page 14
14 GENERAL P o wer Supply Requirements : DC 12 V olts, Negative Ground Chassis Dimensions : 178 (W) x 160 (D) x 50 (H) Tone Controls - Bass (at 100 Hz) : ± 10 dB - T reble (at 10 KHz) : ± 10 dB Maximum Output P ower : 4 x 40 W atts Current Drain : 5 Ampere (max.) CD PLA YER Signal to Noise Ratio : Mor e than 55 dB Channel Separation : More than 4 ...
-
Radio Shack PLCD9MR - page 15
TROUBLE SHOOTING Before going thr ough the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer . Symptom Cause Solution No power . The car ignition switch is If the power supply is not on. connected to the car accessory circuits, but the engine is not moving, switch ...
¿Tienes una pregunta acerca de Radio Shack PLCD9MR?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Radio Shack PLCD9MR, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Radio Shack PLCD9MR probablemente compartirá una forma de solucionarlo.