-
Radio Shack 43-3801 - page 1
43-3801 Owner’s Manual Please read before using this equi pment. A Digital Telephone Answering System 43-3801a.fm Page 1 Monday, Feb ruary 25, 2002 8:56 AM ...
-
Radio Shack 43-3801 - page 2
2 Your system is ETL listed to UL standards and meets all applicable FCC standards. WARNING: To reduce the risk of fire or shock hazard, do not expose this product to rain or moisture. CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER OR BACK. NO USER-SER VICEABLE P ARTS INSIDE. REFER SE ...
-
Radio Shack 43-3801 - page 3
3 Contents ˆ Contents Introduction ............. ......................... ....................... .............. 4 Installation ............... ......................... .......................... ........... 6 Installing the Backup Battery ........................................... 6 Connecting the System to a Phone Line .............. ........ ...
-
Radio Shack 43-3801 - page 4
4 Introduction ˆ Introduction Thank you for p urchasing the Radio Shack Digital Telepho ne Answering System. Your system is a sophisticated, fully digital message center. Fully digital me ans th e system stores all messages on a compu ter chip. This gives you advanced capabilities ov er a tape-based answerin g machine. For example, you can save or ...
-
Radio Shack 43-3801 - page 5
5 Introduction Voice Activa ted Recording (VOX) Detect ion — the system stops recording w hen the caller hang s up or after 7 se conds of silence to help conserve memory space. Remote Operation — l ets you use a touch -tone phone (or rotary phone and pocket tone dialer) to operate the system while you are away from your home or office. Remote A ...
-
Radio Shack 43-3801 - page 6
6 Installation If you use more than o ne phone or other de vice on the li ne, add up all the RENs. If the total is more than five (or three in rural areas), your phone might not ring and your system might not answer. If ringer operation is impaired, remove a devi ce from the line. ˆ Installation INSTALLING THE BACKUP BATTERY If AC power fails or y ...
-
Radio Shack 43-3801 - page 7
7 Installation Cautions: • T o avoid losing stored information, be sure the AC adapter is plugged into an AC outl et before you repla ce the battery . • If you do not plan to use the system with batteries for a month or longer , remove the batteries. Batteries can leak chemicals that can destroy electronic parts. CONNECTING THE SYSTEM TO A PHON ...
-
Radio Shack 43-3801 - page 8
8 Preparation 1. Plug the system’s modular phone line cord into the wall jack. 2. Plug the modular phone line cord (n ot suppli ed) from your telephone into the modular phone jack on the ba ck of the system. CONNECTING AC POWER Plug the AC adapter into a standard AC outlet. The MESSAGE indicator lights. Notes: • If you did not install a backup ...
-
Radio Shack 43-3801 - page 9
9 Preparation When the MESSAGE indicator lights continuously, the system is ready to answer calls. To turn off the system, press ST OP/ON/OFF . The MESSAGE indicator turns off and the system beeps. You can also turn on the system remotely (see “Setting the System to Answer Calls” on Page 12). ADJUSTING THE V OLUME Press or hold down VOLUM E 8 8 ...
-
Radio Shack 43-3801 - page 10
10 Preparation 4. Repeatedly press or hold down MINUTE/TWO WA Y until you hear the correct minute. Note: When you hold do wn MINUTE/TWO W A Y , the sys tem moves forward in 10 minute inte rvals until it reaches 00. 5. Release TIME/SKIP . The system announces the day and time you set. To hear the current day and time, press TIME/SKI P while the syst ...
-
Radio Shack 43-3801 - page 11
11 Preparation 1. Hold down HOUR/A NNOUNCE . The system beeps. 2. Speak clearly into the microphone from abo ut 10 inches in front of the system. The MESSAGE indicator flashes. 3. When you finish your message, release HOUR/ANNOUNCE . The system sounds a tone and automatically plays back your recorded message. Notes: • The maximum length for an ou ...
-
Radio Shack 43-3801 - page 12
12 Operation 4 – The system answers after four rings. 7 – The system answers after seven rings. TS (T oll Saver) – If there are new messages, the system answers after two rings. Otherwise, the system answers after four rings. This lets you avoid unnecessary charges when calling by l ong distance to check your messages. If you hear more than t ...
-
Radio Shack 43-3801 - page 13
13 Operation outgoing message or recording an i ncoming message and resets to answer another call. Notes: • If the system’ s memory is full, it answers calls after 10 rings. The caller hears “No one is available to take your call,” the system sounds a beep, and the call er cannot leave a message. The system cannot record additional messages ...
-
Radio Shack 43-3801 - page 14
14 Operation To record a message, slide INCOMING MSG to ANN ON L Y , then hold down HOUR/ANNOUNCE . After the beep, spe ak clearly into the microphone from about 10 inches in front of the system. (The message can be about 30 seconds long.) Rele ase HOUR/ ANNOUNCE to stop recording. The system automatically plays back your recorded message. Notes: ? ...
-
Radio Shack 43-3801 - page 15
15 Operation SCREENING CALLS To screen your calls, let the system answer. Listen to the caller’s message through the system’s speaker. If you decide to answer the call, pi ck up any phon e connected to the same phone line as the system. The system stops rec o rding and resets to answer the next call. Notes: • If you pick up the phone just as ...
-
Radio Shack 43-3801 - page 16
16 Operation RECORDING A T WO-WAY PHONE CONVERSATION You can record both sides of a conversation on any phone connected to the same phone line as the system. At any time during the conversation , press MINUTE/TWO W A Y . After a beep, the system starts recording. Press MINUT E/TWO WA Y again to stop recording the conversation. The system sounds a t ...
-
Radio Shack 43-3801 - page 17
17 Operation Note: If there are no messages, the system beeps. To replay the messages, press PL A Y /P AUSE . To pause while listening to messages, press PLA Y/P AUSE . The playback resumes when you press PL A Y/P AUSE again. The system returns to the answer-ready mode after 7 se conds if you do not press PLA Y/P AUSE again. During message playback ...
-
Radio Shack 43-3801 - page 18
18 Remote Operation Note: If you press DELETE before playback of all messages, the system sounds tones to alert you. You cannot delete all messages until you playback all new messages. ˆ Remote Operation While you are away from your home or office, you can use a touch-tone phone or a pulse (rota r y) phone with a pocket tone dialer to ente r your ...
-
Radio Shack 43-3801 - page 19
19 Remote Operation system continues to play the messages, the caller hears a busy signal. We recommend that you exit remote access using th e appropriate remote command until the system beeps once before you hang up. OPERATING THE SYSTEM FROM A REMOTE LOCATION 1. Dial your phone number . Even if the system is off, it will turn on and a nswer after ...
-
Radio Shack 43-3801 - page 20
20 Troubleshooting REMOTE COMMANDS ˆ T roubleshooting We do not expect you to have any problems with your system, but if you do, try these suggestions. If the system still does not Press T o 1# Play new messages. 2# Play all messages. 3# Delete current message. 4# Repeat previous message. 5# Stop and exit. 6# Skip and exit. 7# T urn off/on the sys ...
-
Radio Shack 43-3801 - page 21
21 Troubleshooting operate properly, take it to your local RadioSh ack store for assistance. CARE Keep the system dry; if it gets wet, wipe it dry immediately. Use and store the system only in normal temperature environments. Problem Remedy The system does not answer calls. Check all phone line connections. Make sure AC power is properly connected. ...
-
Radio Shack 43-3801 - page 22
22 Troubleshooting Handle the system carefully; do not drop it. Keep the system away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new. Modifying or tampering with the system’s internal components can cause a malfunctio n and might in validate its warranty and void your FCC authorization to operate it. If your ...
-
Radio Shack 43-3801 - page 23
23 Troubleshooting • Increase the distance between the equipment and the radio or TV . • Use outlets on different electrical circuits for the eq uipment and the radio or TV . Consult your local RadioShack store if the problem continues. THE FCC W ANTS Y O U TO KNOW In the unlikely event that your system causes problems on the phone line, the ph ...
-
Radio Shack 43-3801 - page 24
02A02 43-3801 Printed in China A Limited One-Y ear W arranty This pro duct is w arranted by RadioShack agai nst manufacturi ng defects in ma- terial and wor kmanship under nor mal use for one (1) year from the d ate of pur - chase from Radio Shack company- owned stores a nd authorized Ra dioShack franchisees and dealers. EXCEPT AS PROVIDED HEREIN, ...
¿Tienes una pregunta acerca de Radio Shack 43-3801?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Radio Shack 43-3801, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Radio Shack 43-3801 probablemente compartirá una forma de solucionarlo.