-
Belkin F5D5141-5 - page 1
Belkin Ltd. 7 Bowen Crescent, W est Gosford NSW 2250, Australia +61 (0) 2 4372 8600 +61 (0) 2 4372 8603 fax Belkin B.V . Boeing Avenue 333 1119 PH Schiphol-Rijk, The Netherlands +31 (0) 20 654 7300 +31 (0) 20 654 7349 fax Belkin T ech Support US: 877-736-5771 310-898-1100 ext. 2263 Europe: 00 800 223 55 460 Australia: 1800 235 546 New Zealand: 0800 ...
-
Belkin F5D5141-5 - page 2
User Manual F5 D5 141 -5 F5 D5 141 -8 Shar e lar ge fil es at f aster network speeds, with maximum efficiency ? ...
-
Belkin F5D5141-5 - page 3
1 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Fe at ur es . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Pa ck ag e C on te nt s . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 2 Getting to Know your Switch . . ...
-
Belkin F5D5141-5 - page 4
Intr oduction section 1 2 3 4 5 6 7 8 Congratulations on your purchase of this high-quality Belkin 5- or 8-Port Gigabit Switch. Backward-compatible with 10/100 networks, each Switch easily integrates into a new or existing network for instant high performance. It delivers dedicated 100Mbps links to each directly attached LAN segment or PC, enabling ...
-
Belkin F5D5141-5 - page 5
F eatu r es - High-speed, dedicated 10/100/1000 Ethernet ports • 5 ports (Belkin 5-Port Gigabit Switch F5D5141-5) • 8 ports (Belkin 8-Port Gigabit Switch F5D5141-8) - Standards • IEEE 802.3 z/ab 1000Base-T • IEEE 802.3u 100Base-Tx • IEEE 802.3 10Base-T - 1U chassis, place on your desk or mount on a wall - Auto MDI/MDIX ports - Auto-negoti ...
-
Belkin F5D5141-5 - page 6
F r ont-Panel LEDs Belkin 5- or 8-Port Gigabit Switches feature two rows of LEDs that provide information about connection speed and activity , plus a separate Power LED. (a) Power (POWER) LED • Green – Switch is operating normally • Off – There is no power to the Switch (b) Speed, Link, and Activity (Link/Ac ...
-
Belkin F5D5141-5 - page 7
4 Connecting Networking Devic es to your Switch 4 Connecting Networking Devic es to your Switch Connecting your Switch to your Comput ers 1. Power down all your equipment. 2. Connect a Category 5e or 6 Ether net cable between each computer’ s network interface card (NIC) and one of the numbered ports on the front of the Switch. 3. All switch port ...
-
Belkin F5D5141-5 - page 8
Connecting your Switch to your Broadband Router 1. Make sure your broadband router is correctly configured to connect to your ISP and you are able to surf the Inter net. Note: If have questions regar ding the configuration of your broadband router setup, consult your broadband router vendor . 2. Connect a Category 5e or 6 Ether net cable between on ...
-
Belkin F5D5141-5 - page 9
Connecting your Switch to another Switch 1. Connect a Category 5e or 6 cable between one of the numbered ports on the front of the Switch and one of the numbered ports on the other Switch to which you are cascading or connecting. 2. All switch ports can automatically negotiate speeds at full- and half-duplex modes to allow users to attach 10Base-T ...
-
Belkin F5D5141-5 - page 10
This Switch segments your network, significantly increasing both bandwidth and throughput. Each port on the Switch can be attached to any Ether net, Fast Ether net, or Gigabit Ethernet device, such as another switch or a server’ s network adapter . All Switch ports operate at 10/00Mbps full and half duplex, or 1000Mbps full duplex, providing up t ...
-
Belkin F5D5141-5 - page 11
The Switches can be placed on a flat surface or on the wall. Placement on a Flat Surface 1. Affix the four rubber feet shipped with the Switch on the bottom of the Switch in the area that is clearly marked on each of the four cor ners. 2. Make sure the Switch is placed in an area that allows for proper ventilation. 3. Place on a flat surface. Place ...
-
Belkin F5D5141-5 - page 12
Phy si cal Char acte ris tics Standards Conformance IEEE Std 802.3-2002 Communication Rate 10/100/1000Mbps Communication Mode Full or half duplex at 10/100Mbps Full duplex at 1000Mbps Media Supported 10Base-T : 100-Ohm Category 3 or better twisted-pair 100Base-Tx: 100-Ohm Category 5 or better twisted-pair 1000Base-T : 100-Ohm Category 5, 5e, or 6 t ...
-
Belkin F5D5141-5 - page 13
Swi tc hin g Cri te ria Network Bridging Function Filtering, forwarding, and lear ning Switching Method Store-and-forwar d MAC Address T able F5D5141-5: 8K entries F5D5141-8: 8K entries Packet Buffer F5D5141-5: 80Kbits F5D5141-8: 128Kbits 11 10 Pr oduct Specifications ...
-
Belkin F5D5141-5 - page 14
Dia gn osi ng Sw itc h Ind ic at or s Symptom Power LED does not light after power on. Probable Causes DC power adapter may be defective. Possible Solutions • Check for loose connections. • Check the power outlet by using it for another device. • Replace the DC power adapter . Symptom Port (link) LED does not light after connection is made. P ...
-
Belkin F5D5141-5 - page 15
Po wer an d Coo lin g Pr obl ems If the power indicator does not tur n on when the power cord is plugged in, you may have a problem with the power outlet, power cord, or inter nal power supply as explained in the previous section. However , if the unit powers off after running for a while, check for loose power connections, power losses or surges a ...
-
Belkin F5D5141-5 - page 16
EMI Certification FCC Class B Certification (USA) W arning: This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause interference to radio communications. It has been tested and found to comply with the limits for a Class B digital device pursuant to S ...
-
Belkin F5D5141-5 - page 17
15 14 Information 15 14 Information Immunity: • Product family standard according to EN 55024:1998 • Electrostatic Discharge according to EN 61000-4-2:1995 (Contact Discharge: ±4kV , Air Discharge: ±8kV) • Radio-frequency electromagnetic field according to EN 61000-4- 3:1996 (80–1000MHz with 1kHz AM 80% Modulation: 3V/m) • Electrical fa ...
-
Belkin F5D5141-5 - page 18
15 Information 15 1 2 3 4 5 6 7 8 section Safety Compliance Please read the following safety information carefully before installing the Switch: W arning: Do not plug a phone-jack connector into the RJ45 port. This may damage this device. W arning: This product does not contain any serviceable user parts. W arning: When connecting this device to a ...
-
Belkin F5D5141-5 - page 19
17 16 Information 17 16 Information Belkin Corporation Limited Lifetime Product Warranty What this warranty covers. Belkin Corporation warrants to the original purchaser of this Belkin product that the product shall be free of defects in design, assembly , material, or workmanship. What the period of coverage is. Belkin Corporation warrants the Bel ...
-
Belkin F5D5141-5 - page 20
17 Information 17 1 2 3 4 5 6 7 8 section Belkin Corporation reserves the right to review the damaged Belkin product. All costs of shipping the Belkin product to Belkin Corporation for inspection shall be bor ne solely by the purchaser . If Belkin determines, in its sole discretion, that it is impractical to ship the damaged equipment to Belkin Cor ...
¿Tienes una pregunta acerca de Belkin F5D5141-5?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Belkin F5D5141-5, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Belkin F5D5141-5 probablemente compartirá una forma de solucionarlo.