-
Denon PMA-2000IVR - page 1
INTEGRA TED STEREO AMPLIFIER PMA-2000IVR OPERA TING INSTRUCTIONS POWER MUTING FUNCTION PAUSE STOP PLAY VOLUME TRACK B REMOTE CONTROL UNIT RC-858 8 9 CD AMP 1 2 3 B POWER PHONES £ ¢ ON OFF SOURCE DIRECT VOLUME INPUT SELECTOR £ ¢ ON/STANDBY OFF MUTE/STANDBY REMOTE SENSOR REC OUT SELECTOR TUNER AUX-2 COPY BASS TREBLE BALANCE PHONO TAPE-1 2 1 CD AU ...
-
Denon PMA-2000IVR - page 2
2 2 SAFETY PRECAUTIONS 2 NOTE ON USE • Avoid high temperatures. Allow for sufficient heat dispersion when installed on a rack. • Handle the power cord carefully . Hold the plug when unplugging the cord. • Keep the set free from moisture, water , and dust. • Unplug the power cord when not using the set for long periods of time. * (For sets w ...
-
Denon PMA-2000IVR - page 3
3 SAFETY INSTRUCTIONS 1. Read Instructions – All the safety and operating instructions should be read before the product is operated. 2. Retain Instructions – The safety and operating instructions should be retained for future reference. 3 . Heed Warnings – All warnings on the product and in the operating instructions should be adhered to. 4. ...
-
Denon PMA-2000IVR - page 4
4 NOTE: 1. Always keep the POWER switch on the main unit turned on. 2. T urn the power on and off from the remote control unit. 3. Unplug the power cord when you do not plan to use the unit for a long period of time. CAUTION: If only the MUTE/ST ANDBY LED is lit red, this means that the power is turned off from the remote control unit. T urn the po ...
-
Denon PMA-2000IVR - page 5
5 q Power switch (POWER) When the power switch is turned ON ( ¢ ), the MUTE/ST ANDBY LED !1 lights. When the power switch is turned ON, power is supplied to the unit. It takes a few seconds after the power is turned on for the unit to warm up. This is due to the built-in muting circuit that eliminates noise during the on/off operation. w Remote Co ...
-
Denon PMA-2000IVR - page 6
!2 Inputs terminals (INPUTS) These are input terminals for CD players, turntables, AM/FM tuners, tape decks or other playback components. !3 Playing and recording input/output terminals (T APE-1/CD-R, T APE-2/MD) These are playing and recording input/output terminals for connection to tape decks. !4 Power amp direct terminals (POWER AMP DIRECT) Sou ...
-
Denon PMA-2000IVR - page 7
7 2 CONNECTIONS Connecting the speakers • Speaker impedance • When using speaker systems A and B separately , speakers with an impedance of 4 to 16 Ω /ohms can be connected. • When biwiring with biwireable speaker system, speakers with an impedance of 4 to 16 Ω /ohms can be connected. • Note that when using two sets of speaker systems t ...
-
Denon PMA-2000IVR - page 8
8 Cautions on Connections • Do not plug in the power cord until all connections are completed. • Be sure to connect the left and right channels properly . • Insert the plugs securely . Incomplete connections can result in noise. • Use the SWITCHED AC OUTLETS to plug in audio components. Do not use them for hair dryers or other appliances. ? ...
-
Denon PMA-2000IVR - page 9
9 3 OPERA TION (Refer to page 4 and 6) PREP ARA TION 1. CHECKING CONNECTIONS • Make sure that all the connections are proper by referring to the rear panel. • Check the polarity (positive and negative) of connections, and the directivity of stereo separation (right cord to right channel terminal, and left cord to left channel terminal). • Che ...
-
Denon PMA-2000IVR - page 10
10 4 REMOTE CONTROL OPERA TION The accessory Remote Control Unit is used to control the amplifier from a convenient distance. (1) Inserting the Dry Cell Batteries 1. Remove the battery cover on the Remote Control Unit. Notes on Battery Usage • RC-858 uses the size R03 (AAA) dry cell batteries. • The batteries will need to be r eplaced approxima ...
-
Denon PMA-2000IVR - page 11
POWER MUTING FUNCTION PAUSE STOP PLAY VOLUME TRACK B REMOTE CONTROL UNIT RC-858 8 9 CD AMP 1 2 3 11 Remote Control Unit RC-858 supplied with the PMA-2000 IV R Pre-main Amplifier Block Use these to control the PMA-2000 IV R. MUTING : When pressed, the main unit’ s power LED flashes and the speaker output is turned off. When pressed again, the mute ...
-
Denon PMA-2000IVR - page 12
12 5 TROUBLESHOOTING Check the following before assuming there is a problem with the set. 1. Are all connections proper ? 2. Is the set being operated as described in the operating instructions ? 3. Are the speakers and input components being operated properly ? If the set does not seem to be operating properly , check the points listed below . If ...
-
Denon PMA-2000IVR - page 13
13 6 SPECIFICA TIONS • POWER AMPLIFIER SECTION Rated Output Power: Both channel driven (8 Ω /ohms Load) 80 W + 80 W 20 Hz to 20 kHz, T .H.D. 0.07 % (4 Ω /ohms Load) 160 W + 160 W DIN, 1 kHz, T .H.D. 0.7 % T otal Harmonic Distortion: 0.01 % (–3 dB at rated output, 8 Ω /ohms) (1 kHz) Input Sensitivity/Input Impedance: P . DIRECT : 0.9 V/47 ...
-
Denon PMA-2000IVR - page 14
MEMO 14 ...
-
Denon PMA-2000IVR - page 15
MEMO 15 ...
-
Denon PMA-2000IVR - page 16
Printed in Japan 511 3917 001 16-11, YUSHIMA 3-CHOME, BUNKYOU-KU, TOKYO 113-0034, JAP AN T elephone: (03) 3837-5321 ...
¿Tienes una pregunta acerca de Denon PMA-2000IVR?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Denon PMA-2000IVR, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Denon PMA-2000IVR probablemente compartirá una forma de solucionarlo.