-
Echo SHC-210 - page 1
H EDGE C LIPPER O PERA T OR ' S M ANUAL 1 Shaft Hedge Clipper Operator's Manual MODEL SHC-210 Serial Number 07001001 - 07999999 X750005481 03/03 X7502253801 W ARNING DANGER Read rules for safe operation and instructions carefully. ECHO provides an Operator's Manual and a Safety Manual. Both must be read and understood for proper and ...
-
Echo SHC-210 - page 2
2 I NTRODUCTION Welcome to the ECHO family. This ECHO product was designed and manufactured to provide long life and on-the-job dependability. Read and understand this manual and the SAFETY MANUAL you found in the same package. You will find both easy to use and full of helpful operating tips and SAFETY messages. T ABLE OF C ONTENTS Introduction .. ...
-
Echo SHC-210 - page 3
H EDGE C LIPPER O PERA T OR ' S M ANUAL 3 S AFETY DECALS Locate these safety decals on your unit. Make sure the decals are legible and that you understand and follow the instructions on them. If a decal cannot be read, a new one can be ordered from your ECHO dealer. See PARTS ORDERING instructions for specific information. IMPORTANT The enclos ...
-
Echo SHC-210 - page 4
4 INTERNA TIONAL SYMBOLS Symbol description/application Symbol form/shape Symbol description/application Symbol form/shape Hot Surface Carburetor adjustment - Idle speed Carburetor adjustment - High speed mixture Symbol description/application Symbol form/shape Symbol description/application Symbol form/shape Read and understand Operator's Man ...
-
Echo SHC-210 - page 5
H EDGE C LIPPER O PERA T OR ' S M ANUAL 5 EXTENDED OPERA TION / EXTREME CONDITIONS Vibration and Cold It is believed that a condition called Raynaud’s Phenomenon, which affects the fingers of certain individuals, may be brought about by exposure to vibration and cold. Exposure to vibration and cold may cause tingling and burning sensations, ...
-
Echo SHC-210 - page 6
6 SAFE OPERA TION W ARNING DANGER Do not operate this product indoors or in inadequately ventilated areas. Engine exhaust contains poisonous emissions and can cause serious injury or death. Read the Manual • Provide all users of this equipment with the Operator's Manual and Safety Manual for instructions on Safe Operation. Clear the Work Are ...
-
Echo SHC-210 - page 7
H EDGE C LIPPER O PERA T OR ' S M ANUAL 7 D ESCRIPTION The ECHO product you have purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, some assembly of SHC-210 is required. After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the con ...
-
Echo SHC-210 - page 8
8 1. POWER HEAD - Includes the Engine, Clutch, Fuel System, Ignition System and Recoil Starter. 2. GRIP, RIGHT HAND REAR - Cushioned grip for right hand. 3. THROTTLE TRIGGER LOCKOUT - This lever must be held during starting. Operation of the throttle trigger is prevented unless throttle trigger lockout lever is engaged. 4. STOP SWITCH - mounted on ...
-
Echo SHC-210 - page 9
H EDGE C LIPPER O PERA T OR ' S M ANUAL 9 S PECIFICA TIONS MODEL ----------------------------------------------------- SHC-210 Length ------------------------------------------------------- 1790 mm (70.5 in.) Width -------------------------------------------------------- 250 mm (9.84 in.) Height ------------------------------------------------ ...
-
Echo SHC-210 - page 10
10 A SSEMBL Y Tools Required: 4 mm hex wrench, screwdriver Parts Required: Power Head/Drive Shaft Assembly and Gear Housing Assembly GEAR HOUSING ASSEMBL Y / DRIVE SHAFT W ARNING DANGER Hedge Clipper Blades are very sharp. Wear gloves to protect hands. 1 . Remove protective cap from drive shaft end. 2 . Remove locating screw (A) and align the locat ...
-
Echo SHC-210 - page 11
H EDGE C LIPPER O PERA T OR ' S M ANUAL 11 P RE -O PERA TION FUEL Fuel Requirements Gasoline - Use 89 Octane [R + M/2] (mid grade or higher) gasoline known to be good quality. Gasoline may contain up to 15% MTBE (methyl tertiary-butyl ether). Gasohol containing methyl (wood) alcohol is NOT approved. Two Stroke Oil - A two-stroke engine oil mee ...
-
Echo SHC-210 - page 12
12 O PERA TION ST ARTING COLD ENGINE W ARNING DANGER The attachment will operate immediately when the engine starts and could result in loss of control and possible serious injury. Keep movable parts of the attachment off the ground and away from objects that could become entangled or thrown. 1. Stop Switch Move Stop Switch button away from the STO ...
-
Echo SHC-210 - page 13
H EDGE C LIPPER O PERA T OR ' S M ANUAL 13 ST ARTING W ARM ENGINE The starting procedure is the same as Cold Start except DO NOT close the choke, and do not depress throttle trigger to wide open position. W ARNING DANGER The attachment should not move at idle, otherwise serious personal injury may result. NOTE If attachment moves, readjust car ...
-
Echo SHC-210 - page 14
14 M AINTENANCE Your ECHO product is designed to provide many hours of trouble free service. Regular scheduled maintenance will help achieve that goal. If you are unsure or are not equipped with the necessary tools, you may want to take your unit to an ECHO Service Dealer for maintenance. To help you decide whether you want to DO-IT-YOURSELF or hav ...
-
Echo SHC-210 - page 15
H EDGE C LIPPER O PERA T OR ' S M ANUAL 15 AIR FIL TER Level 1. Tools required: 25 or 50 mm (1 or 2 in.) cleaning brush Parts required: 90008 REPOWER TM Air & Fuel Filter Kit 1 . Close choke (Cold Start Position [ ] ). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from the air ...
-
Echo SHC-210 - page 16
16 SP ARK PLUG Level 2. Tools Required: T-Wrench, feeler gauge, soft metal brush Parts Required: Spark Plug, NGK BPMR-8Y P/N A425000000 1 . Remove spark plug and check for fouling, worn and rounded center electrode. 2 . Clean the plug or replace with a new one. DO NOT sand blast to clean. Remaining sand will damage engine. 3 . Adjust spark plug gap ...
-
Echo SHC-210 - page 17
H EDGE C LIPPER O PERA T OR ' S M ANUAL 17 1 . Disconnect spark plug lead from spark plug. 2 . Remove (1) screw from top guard, and remove guard. 3 . Remove (4) screws from engine/muffler cover, and remove cover. 4 . Use the brush to remove dirt form cylinder fins. 5 . Remove grass and leaves from the grid between the recoil starter and fuel t ...
-
Echo SHC-210 - page 18
18 6 . Assemble components in reverse order. NOTE When installing the engine/muffler cover, be certain the tabs of the metal deflector shield are in the slots of the cover. Cylinder Exhaust Port Level 3. IMPORTANT The cylinder exhaust port must be inspected and cleaned of excess carbon every 3 months or 90 hours of operation in order to maintain th ...
-
Echo SHC-210 - page 19
H EDGE C LIPPER O PERA T OR ' S M ANUAL 19 LUBRICA TION Blades Level 1. Tools Required: Clean rag, cleaning brush , oil can Parts Required: 20W Engine Oil (lubrication), 50-50 mixture of kerosene and 20W oil (cleaning) W ARNING DANGER Blades are very sharp. Wear gloves to protect hands, otherwise serious personal injury may result. 1 . Brush l ...
-
Echo SHC-210 - page 20
20 Drive Shaft Assembly Level 1. NOTE Hedge Clipper drive shaft should be greased every 25 hours of operation. Tools required: 4 mm Hex wrench, screwdriver, clean rag, small brush Parts required: ECHO ® LUBE TM 14 oz. cartridge P/N 91015 or Lithium Based Grease W ARNING DANGER Blades are very sharp. Wear gloves to protect hands, otherwise serious ...
-
Echo SHC-210 - page 21
H EDGE C LIPPER O PERA T OR ' S M ANUAL 21 SHARPENING BLADES Level 3. Tools required: (2) 10 mm wrenches, flat file, screwdriver Parts required: None W ARNING DANGER Hedge Clipper Blades are very sharp. Wear gloves to protect hands. 1 . Disconnect spark plug wire from spark plug. 2 . Slide blades to midpoint cutting position using slots (A) on ...
-
Echo SHC-210 - page 22
22 T ROUBLESHOOTING W ARNING DANGER Fuel vapors are extremely flammable and may cause fire and/or explosion. Never test for ignition spark near an open spark plug opening, otherwise serious personal injury may result. T R A H C G N I T O O H S E L B U O R T M E L B O R P E N I G N E m e l b o r Pk c e h Cs u t a t Se s u a Cy d e m e R e n i g n E ...
-
Echo SHC-210 - page 23
H EDGE C LIPPER O PERA T OR ' S M ANUAL 23 Long T erm S torage (over 30 days) Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage mainte- nance which includes the following: 1 . Store unit in a dry, dust free place, out of the reach of children. W ARNING DANGER Do not store in enclosu ...
-
Echo SHC-210 - page 24
DEALER? Call 1-800-432-ECHO or www .echo-usa.com S ER VICING I NFORMA TION P ARTS Genuine ECHO Parts and ECHO REPOWER™ Parts and Assemblies for your ECHO products are available only from an Authorized ECHO Dealer. When you do need to buy parts always have the Model Number and Serial Number of the unit with you. You can find these numbers on the e ...
¿Tienes una pregunta acerca de Echo SHC-210?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Echo SHC-210, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Echo SHC-210 probablemente compartirá una forma de solucionarlo.