-
Wayne-Dalton 9100/9400/9600 - page 1
GARAGE DOORS & OPENERS Part No. IMPORT ANT NO TICES! Wayne-Dalton highly recommends that you read and fully under - stand the Installation Instructions and Owner’ s Manual before you attempt this installation. T o avoid possible injur y , read the enclosed instructions carefully before installing and operating the garage door . Pay close atte ...
-
Wayne-Dalton 9100/9400/9600 - page 2
2 Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com A. FLAG ANGLES (AS REQUIRED): A1. Fully Adjustable (F .A.) Flag Angles A2. Quick Install (Q.I.) F ...
-
Wayne-Dalton 9100/9400/9600 - page 3
I m p o r t a n t S a f e t y I n s t r u c t i o n s Definition of key words used in this manual: W ARNING W ARNING INDICA TES A POTENTIALL Y HAZARDOUS SITUA TION WHICH; IF NOT AVOIDED , COULD RESUL T IN SEVERE OR FA T AL INJURY . CAUTION: PROPER TY DAMAGE OR INJURY CAN RESUL T FROM FAILURE TO FOLLOW INSTRUCTIONS. IMPORT ANT : REQUIRED STEP FOR S ...
-
Wayne-Dalton 9100/9400/9600 - page 4
5/16” x 1 5/8” Hex head lag screws (as required) 1/4”-20 x 11/16” Self drilling screws (as required) 1/4”-14 x 5/8” Self tapping screws (as required) (2) #12 x 1/2” Phillips head screws (2) 5/16”-18 x 3/4” Carriage bolts 1/4”-20 x 9/16” Track bolts (as required) 3/8”- 16 Hex nuts (As Required) 1/4”- 20 Flanged hex nuts (as ...
-
Wayne-Dalton 9100/9400/9600 - page 5
and flush with the inside edge of the jamb. T emporarily secure the weatherstrip with equally spaced nails. Repeat for other side. This will keep the bottom section from falling out of the opening during installation. Equally space nails approximately 12” to 18” apart. For Fully Adjustable track: For the header , align the weatherstrip 1/8” ...
-
Wayne-Dalton 9100/9400/9600 - page 6
INST ALLA TION Before installing your door , be certain that you have read and followed all of the instruc- tions covered in the pre-installation section of this manual. Failure to do so may result in an improperly installed door . NOTE: Reference TDS 160 for general garage door terminology at www.dasma.com . Quick Install Flag Angles T ools: None ...
-
Wayne-Dalton 9100/9400/9600 - page 7
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com If a top jamb bracket was included, secure it to vertical track using the lower hole of the hole/ s ...
-
Wayne-Dalton 9100/9400/9600 - page 8
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com section until it is seated against bottom section. Align vertical marks in the upper alignment stic ...
-
Wayne-Dalton 9100/9400/9600 - page 9
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com T op Section T ools: Hammer , Step ladder , T ape measure 14 Place the top section in the opening. ...
-
Wayne-Dalton 9100/9400/9600 - page 10
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com W ARNING W ARNING KEEP HORIZONT AL TRACK P ARALLEL AND WITHIN 3/4” TO 7/8” MAXIMUM OF DOOR EDGE ...
-
Wayne-Dalton 9100/9400/9600 - page 11
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Attaching Extension Springs T ools: 3/8” Wrench 20 Position (1) 5/16”-18 x 3-3/4” eye bolt an ...
-
Wayne-Dalton 9100/9400/9600 - page 12
Please Do Not Return This Product T o The Store. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pages business listings or go to the Find a Dealer section online at www.W ayne-Dalton.com Counterbalance lift cable 3 Hole clip Front cable lift sheave Second slot Counterbalance lift cable ...
-
Wayne-Dalton 9100/9400/9600 - page 13
Door Arm Hookup T ools: Needle nose pliers Align hole in the door arm with holes in drawbar operator bracket tabs, as shown. Insert 5/16” x 1-1/4” clevis pin, making sure hole in clevis pin is outside of second tab of drawbar operator bracket. Insert hairpin cotter into clevis pin hole and spread hairpin cotter to secure assembly , as shown. Dr ...
-
Wayne-Dalton 9100/9400/9600 - page 14
Second section 1/8” Inside lock End cap (4) 1/4”-20 x 11/16” Self drilling screws Square hole in vertical track Pull Down Rope T ools: Power drill, 1/8” Drill bit, T ape measure W ARNING W ARNING DO NOT INST ALL PULL DOWN ROPE ON DOORS WITH OPERA TORS. CHILDREN MA Y BECOME ENT ANGLED IN THE ROPE CAUSING SEVERE OR F A T AL INJURY . Measure a ...
-
Wayne-Dalton 9100/9400/9600 - page 15
Cleaning Y our Garage Door IMPORT ANT : DO NOT USE A PRESSURE W ASHER ON YOUR GARAGE DOOR! While factory-applied finishes on garage doors are durable, it is desirable to clean them on a routine basis. Some discoloration of the finish may occur when a door has been exposed to dirt-laden atmosphere for a period of time. Slight chalking may also occ ...
-
Wayne-Dalton 9100/9400/9600 - page 16
Lifetime Limited Warranty Models 9100, 9400, 9600 Subject to the terms and conditions contained in this Lifetime Limited Warranty , Wayne-Dalton, A Division Of Overhead Door Corporation (“Manufacturer”) war- rants the sections of the door , which is described at the top of this page, for as long as you own the door against: i) The door becoming ...
-
Wayne-Dalton 9100/9400/9600 - page 17
...
-
Wayne-Dalton 9100/9400/9600 - page 18
AFTER INST ALLA TION IS COMPLETE, F ASTEN THIS MANUAL NEAR THE GARAGE DOOR. Please Do Not Return This Product T o The Store Thank you for your pur chase. Contact your local Wayne-Dalton dealer . T o find your local Wayne-Dalton dealer , refer to your local yellow pa ges business listings or go to the Find a Dealer section online at www .Wayne-Dalt ...
¿Tienes una pregunta acerca de Wayne-Dalton 9100/9400/9600?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Wayne-Dalton 9100/9400/9600, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Wayne-Dalton 9100/9400/9600 probablemente compartirá una forma de solucionarlo.