-
Porter-Cable CPLDC2540S - page 1
Dir ect Drive Oil Lube Portable Air Compr essor Instruction manual IMPORT ANT Please make certain that the person who is to use this equipment carefully reads and understands these instructions before starting operations. Part No. A02250-041-0 ESP AÑOL: PÁGINA 25 FRANÇAIS: P AGE 49 T o lear n more about Porter -Cable visit our website at: http:/ ...
-
Porter-Cable CPLDC2540S - page 2
2- ENG A02250 SAFETY GUIDELINES - DEFINITIONS Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury . Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury . Indicates a potentially hazardous situation which, if not avoided, may result in minor ...
-
Porter-Cable CPLDC2540S - page 3
3- ENG A02250 IMPORT ANT SAFETY INSTRUCTIONS SA VE THESE INSTRUCTIONS IMPROPER OPERA TION OR MAINTENANCE OF THIS PRODUCT COULD RESUL T IN SERIOUS INJUR Y AND PROPERTY DAMAGE. READ AND UNDERST AND ALL WARNINGS AND OPERA TING INSTRUCTIONS BEFORE USING THIS EQUIPMENT . RISK OF EXPLOSION OR FIRE AL WA YS OPERA TE THE COMPRESSOR IN A WELL VENTILA TED AR ...
-
Porter-Cable CPLDC2540S - page 4
4- ENG A02250 HAZARD RISK OF BURSTING AIR T ANK: THE FOLLOWING CONDITIONS COULD LEAD TO A WEAKENING OF THE T ANK, AND RESUL T IN A VIOLENT T ANK EXPLOSION AND COULD CAUSE PROPERTY DAMAGE OR SERIOUS INJUR Y . HOW TO PREVENT IT WHA T CAN HAPPEN DRAIN T ANK DAIL Y OR AFTER EACH USE. IF T ANK DEVELOPS A LEAK, REPLACE IT IMMEDIA TEL Y WITH A NEW T ANK O ...
-
Porter-Cable CPLDC2540S - page 5
5- ENG A02250 HAZARD HOW TO PREVENT IT WHA T CAN HAPPEN HAZARD HOW TO PREVENT IT WHA T CAN HAPPEN RISK TO BREA THING AIR OBT AINED DIRECTL Y FROM THE COMPRESSOR SHOULD NEVER BE USED TO SUPPL Y AIR FOR HUMAN CONSUMPTION. IN ORDER TO USE AIR PRODUCED BY THIS COMPRESSOR FOR BREA THING, SUIT ABLE FIL TERS AND IN-LINE SAFETY EQUIPMENT MUST BE PROPERL Y ...
-
Porter-Cable CPLDC2540S - page 6
6- ENG A02250 HAZARD HOW TO PREVENT IT WHA T CAN HAPPEN RISK OF BURNS TOUCHING EXPOSED MET AL SUCH AS THE COMPRESSOR HEAD OR OUTLET TUBES, CAN RESUL T IN SERIOUS BURNS. NEVER TOUCH ANY EXPOSED MET AL P ARTS ON COMPRESSOR DURING OR IMMEDIA TEL Y AFTER OPERA TION. COMPRESSOR WILL REMAIN HOT FOR SEVERAL MINUTES AFTER OPERA TION. DO NOT REACH AROUND PR ...
-
Porter-Cable CPLDC2540S - page 7
7- ENG A02250 HAZARD HOW TO PREVENT IT WHA T CAN HAPPEN RISK OF UNSAFE OPERA TION REVIEW AND UNDERST AND ALL INSTRUCTIONS AND WARNINGS IN THIS MANUAL. BECOME F AMILIAR WITH THE OPERA TION AND CONTROLS OF THE AIR COMPRESSOR. KEEP OPERA TING AREA CLEAR OF ALL PERSONS, PETS, AND OBST ACLES. KEEP CHILDREN AWA Y FROM THE AIR COMPRESSOR A T ALL TIMES . D ...
-
Porter-Cable CPLDC2540S - page 8
8- ENG A02250 GLOSSAR Y Become familiar with these terms before operating the unit. CFM : Cubic feet per minute. SCFM: Standard cubic feet per minute; a unit of measur e of air delivery . PSIG: Pounds per square inch gauge; a unit of measur e of pressur e. Code Certification: Products that bear one or mor e of the following marks: UL, CUL, ETL, CET ...
-
Porter-Cable CPLDC2540S - page 9
9- ENG A02250 Accessories for this unit are available at the stor e the unit was purchased. ACCESSORIES T o Add Oil T o Pump DO NOT A TTEMPT TO OPERA TE THIS AIR COMPRESSOR WITHOUT FIRST ADDING OIL TO THE CRANKCASE. Serious damage can result fr om even limited operation unless filled with oil and broken in corr ectly . Make sure to closely follow i ...
-
Porter-Cable CPLDC2540S - page 10
10- ENG A02250 GROUNDING INSTRUCTIONS RISK OF ELECTRICAL SHOCK. In the event of a short circuit, gr ounding reduces the risk of shock by providing an escape wir e for the electric current. This air compr essor must be properly gr ounded. The portable air compressor is equipped with a cor d having a grounding wir e with an appropriate gr ounding plu ...
-
Porter-Cable CPLDC2540S - page 11
11- ENG A02250 Extension Cords Use extra air hose instead of an extension cord to avoid voltage dr op and power loss to the motor , and to pr event overheating. If an extension cord must be used, be sur e it is: • a 3-wire extension cor d that has a 3-blade grounding plug, and a 3-slot receptacle that will accept the plug on the pr oduct • in g ...
-
Porter-Cable CPLDC2540S - page 12
12- ENG A02250 OPERA TION Know Y our Air Compressor READ THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR UNIT . Compare the illustrations with your unit to familiarize yourself with the location of various controls and adjustments. Save this manual for futur e refer ence. Description of Operation Become familiar with these controls be ...
-
Porter-Cable CPLDC2540S - page 13
13- ENG A02250 Dipstick : Indicates the amount of oil in the pump, the + mark indicates full and the - mark indicates oil needs to be added. See Oil paragraphs in the Maintenance section for instructions. Motor Thermal Overload Protector (not shown): The motor has an automatic reset thermal overload pr otector . If the motor overheats for any reaso ...
-
Porter-Cable CPLDC2540S - page 14
14- ENG A02250 How to Start: 1. T urn the On/Auto/Off lever to “AUTO” and allow tank pr essure to build. Motor will stop when tank pressur e reaches “cut-out” pr essure. 2. Pull the regulator knob out and turn clockwise to increase pr essure. When the desired pr essure is r eached push knob in to lock in place. The compressor is r eady for ...
-
Porter-Cable CPLDC2540S - page 15
15- ENG A02250 MAINTENANCE Customer Responsibilities Daily or after each use Before each use ● ● ● ● Every 8 hours Every 40 hours Every 100 hours Y early Every 160 hours ● ● 1 1- more fr equent in dusty or humid conditions Check Safety V alve Drain T ank Oil Leaks Check Oil Change Oil Air Filter NOTE: See “Operation” section for the ...
-
Porter-Cable CPLDC2540S - page 16
16- ENG A02250 5. Drain water from air tank by opening drain valve (counter -clockwise) on bottom of tank. NOTE: Tilt tank forward to drain tank completely . W ater will condense in the air tank. If not drained, water will corrode and weaken the air tank causing a risk of air tank rupture. 6. After the water has been drained, close the drain valve ...
-
Porter-Cable CPLDC2540S - page 17
17- ENG A02250 Air Filter - Inspection and Replacement Hot surfaces. Risk of burn. Compressor heads are exposed when filter cover is removed. Allow compressor to cool prior to servicing. A dirty air filter will not allow the compressor to operate at full capacity . Keep the air filter clean at all times. 1. Remove the air filter cover . 2. Remove t ...
-
Porter-Cable CPLDC2540S - page 18
18- ENG A02250 T o Replace or Clean Check V alve 1. Release all air pressur e from air tank. See “T o Drain T ank” in the Maintenance section. 2. Unplug outfit. 3. Using an adjustable wrench loosen outlet tube nut at air tank and pump. Carefully move outlet tube away from check valve. 4. Using an adjustable wrench loosen pressur e relief tube n ...
-
Porter-Cable CPLDC2540S - page 19
19- ENG A02250 STORAGE Before you stor e the air compressor , make sure you do the following: 1. Review the "Maintenance" section on the preceding pages and perform scheduled maintenance as necessary . 2. Set the On/Auto/Off lever to “OFF”. 3. T urn the regulator counter clockwise and set the outlet pressur e to zero. 4. Remove the ai ...
-
Porter-Cable CPLDC2540S - page 20
20- ENG A02250 TROUBLESHOOTING Performing repairs may expose voltage sour ces, moving parts or compressed air sour ces, moving parts or compressed air sour ces. Personal injury may occur . Prior to attempting any repairs, unplug the air compr essor and bleed off all air tank air pressur e. PROBLEM CAUSE CORRECTION Pressur e switch does not shut off ...
-
Porter-Cable CPLDC2540S - page 21
21- ENG A02250 PROBLEM CAUSE CORRECTION Compressor is not supplying enough air to operate accessories. Prolonged excessive use of air . Compressor is not lar ge enough for air requir ement. Hole in hose. Check valve restricted. Air leaks. Restricted air intake filter Decrease amount of air usage. Check the accessory air requir ement. If it is highe ...
-
Porter-Cable CPLDC2540S - page 22
22- ENG A02250 PROBLEM CAUSE CORRECTION Motor will not run. Fuse blown, circuit br eaker tripped. 1. Check fuse box for blown fuse and replace as necessary . Reset circuit breaker . Do not use a fuse or circuit br eaker with higher rating than that specified for your particular branch circuit. 2. Check for proper fuse. Y ou should use a time delay ...
-
Porter-Cable CPLDC2540S - page 23
23- ENG A02250 PROBLEM CAUSE CORRECTION Knocking Noise. Possible defect in safety valve. Operate safety valve manually by pulling on ring. If valve still leaks, it should be replaced. Compressor mounting screws loose Tighten mounting screws,see Parts manual for torque specifications. Carbon build-up in pump Have checked by a T rained Service T echn ...
-
Porter-Cable CPLDC2540S - page 24
24- ENG A02250 LIMITED WARRANTY PORTER-CABLE CORPORA TION warrants to the original purchaser that each new air compressor and service part is fr ee from defects in material and workmanship and agrees to r epair or replace under this warranty any defective pr oduct or part as follows from the original date of pur chase. 5 YEARS – Limited warranty ...
¿Tienes una pregunta acerca de Porter-Cable CPLDC2540S?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Porter-Cable CPLDC2540S, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Porter-Cable CPLDC2540S probablemente compartirá una forma de solucionarlo.