-
FMI GL36STE - page 1
For more information, visit www .fmiproducts.com NA TURAL GAS MODELS (V)GL36ST AND (V)GL36STE PROP ANE/LP GAS MODELS (V)GL36STP AND (V)GL36STEP 2-SIDED (SEE-THROUGH), VENTED DECORA TIVE GAS APPLIANCE OWNER’S OPERA TION AND INST ALLA TION MANU AL FOR YOUR SAFETY — Do not store or use gasoline or any other ammable ...
-
FMI GL36STE - page 2
www .fmiproducts.com 55173H 2 W ARNING: Improper installation, adjustment, altera - tion,service ormaintenancecan causeinjury orprop - erty damage. Refer to this manual for correct installation and operational procedures. For assistance or addi- tional information consult a ...
-
FMI GL36STE - page 3
www .fmiproducts.com 55173H 3 SAFETy INFORMA TION W ARNING: This product c o n t a i n s a n d / o r g e n e r a t e s chemicals known to the State of California to cause cancer or birth defects or other reproduc - tiveharm. IMPORTANT: Read this owner’s man ual care ful ly and compl ete ly bef ...
-
FMI GL36STE - page 4
www .fmiproducts.com 55173H 4 11. Keep the area around your replace clear of combustible materials, gasoline and other ammable vapor and liquids. Do not run re- place where these are used or stored. Do not place items such as clothing or decorations on or around replace. 12. Do not use this replace to cook food or burn paper or other ...
-
FMI GL36STE - page 5
www .fmiproducts.com 55173H 5 Figure 2 - T ypical T wo-Sided Fireplace Installation INTRODUCTION Models (V)GL36ST/P and (V)GL36STE/EP are decorative gas appliances that use a millivolt gas control and piezo pilot or an electronic gas control valve with an electronic ignition system respectively . These systems require a 6", B-type venting syst ...
-
FMI GL36STE - page 6
www .fmiproducts.com 55173H 6 Figure 3 - Clearances from T op V iew Figure 4 - Clearances from Side V iew MANTEL CLEARANCES W oodwork, such as wood trims, mantel s and other comb ustib le materia ls, should not be placed within 7" of the opening of this appliance (see Figure 5). Combustible material above the fireplace projecting more than 1 1 ...
-
FMI GL36STE - page 7
www .fmiproducts.com 55173H 7 FIREPLACE INST ALLA TION Continued FRAMING Construct framing using dimensions shown if Figures 6, 7 and 8. (Use the gure applicable to your application.) Figure 6 shows the framing dimensions prior to having the appliance in place. Once the unit has been tted, bring studs in agains t nailing anges located on t ...
-
FMI GL36STE - page 8
www .fmiproducts.com 55173H 8 FIREPLACE INST ALLA TION Continued OPTIONAL OUTSIDE AIR KIT (MODEL AK-4) The installation of an outside air kit should be completed during the rough framing of the re- place due to the nature of it's location. Outside combustion air is accessed through a vented crawl space. CAUTION: Air inlet ducts must not? ...
-
FMI GL36STE - page 9
www .fmiproducts.com 55173H 9 FIREPLACE INST ALLA TION Continued GAS SUPPL Y TESTING Note: This section is intended as a guide for quali - ed technicians installing gas to this appliance. CAUTION: Do not connect appliancebefore pressuretest - ing gas piping. Damage to gas valvemayresultandanunsafe con ...
-
FMI GL36STE - page 10
www .fmiproducts.com 55173H 10 T o install: 1. Remove gas line cover plate from appliance’ s outer surround at the location to be used. 2. Remove insulation from inside the gas line conduit sleeve. 3. Run gas line through sleeve. 4. Prepare incoming black iron gas line with T eon tape or pipe joint compound. (Check local codes as to the use of ...
-
FMI GL36STE - page 11
www .fmiproducts.com 55173H 11 FIREPLACE INST ALLA TION Continued MANTELS Mantels, combustible or non-combustible, may be constructed as long as proper clearances are observed (see Figure 2, page 6 and Clearances , page 6). PILOT ASSEMBL Y ADjUSTMENT The pilot assembly is factory preset for the proper ame height. Alteration to factory settings m ...
-
FMI GL36STE - page 12
www .fmiproducts.com 55173H 12 OPTIONAL GLASS DOOR Glass doors are optional with this gas appliance (see Replacement Parts and Accessories , page 19). Installing Glass Door 1. Be sure top spring clip hole is aligned with hole in replace frame (see Figure 21). Fit glass door top pin into aligned holes. 2. Swing inner end of bottom clip out away f ...
-
FMI GL36STE - page 13
www .fmiproducts.com 55173H 13 OPERA TING FIREPLACE MILLIV OL T MODELS FOR YOUR SAFETY READ BEFORE LIGHTING W ARNING: If you do not fol- low these instructions exactly , a re or explosion may result causing property damage, per - sonalinjuryorlossoflife. A. This appliance has a pilot which mu ...
-
FMI GL36STE - page 14
www .fmiproducts.com 55173H 14 TO TURN OFF GAS TO APPLIANCE 1. T urn off the wall switch. 2. T urn off all electric power to the appliance if service is to be performed. 3. Remove control access panel. 4. Pus h in gas con tr ol knob and tur n clock wis e to “OFF”. Do not force. 5. Replace control access panel. OPERA TING FIREPLACE Continued Fig ...
-
FMI GL36STE - page 15
www .fmiproducts.com 55173H 15 CLEANING AND MAINTENANCE W ARNING: Installation and repair should be done by a qualied service person. The applianceshouldbeinspected before each use and at least annuallyby a qualiedservice person. More frequent clean- in g ma y be ...
-
FMI GL36STE - page 16
www .fmiproducts.com 55173H 16 DO NOT CONNECT N.C.SW HE A T LIMIT SWITCH TH/TP TP TH WA LL SWITCH (SUPPLIED) TO 120V THERMOPILE PILOT IGNI TO R O F F P I L O T O N PILO T SAFET Y WIRE MAIN GAS INCOMING SUPPL Y MILLIVOL T WIRING DIAGRAM STEP DOWN TRANSFORMER EV2 SUPPL Y INCOMING MAIN GAS EV1 TO GAS LINE BURNER 24V AC N.C.SW HEA T LIMIT SWITCH 120V A ...
-
FMI GL36STE - page 17
www .fmiproducts.com 55173H 17 TROUBLESHOO TING MILLIVOL T SYSTEM Note: Before troubleshooting the system, make sure the gas shutoff valve is ON. The two most common causes of a malfunctioning gas appliance are: 1. Loose wiring connections 2. Construction debris clogging the pilot and/or gas control valve lter OBSERVED PROBLEM Pilot will not lig ...
-
FMI GL36STE - page 18
www .fmiproducts.com 55173H 18 TROUBLESHOO TING ELECTRONIC IGNITION SYSTEM Note: Before troubleshooting the system, make sure the gas shutoff valve is ON. The two most common causes of a malfunctioning gas appliance are: 1. Loose wiring connections 2. Construction debris clogging the pilot and/or gas control valve lter OBSERVED PROBLEM Pilot wil ...
-
FMI GL36STE - page 19
www .fmiproducts.com 55173H 19 REPLACEMENT P ARTS AND ACCESSORIES Purchase these replace replacement parts and accessories from your local dealer . If they can not supply these parts, call FMI PRODUCTS, LLC at 1-866-328-4537 for referral information. Y ou can also write to the address listed on the back page of this manual. Before ordering, plea ...
-
FMI GL36STE - page 20
55173 Rev . H 09/09 WARRANTy KEEP THIS WARRANTy FMI PRODUCTS, LL C LIMITED WARRANTIES NewProducts Standard Warranty: FMI PRODUCTS, LLC warrants this new product and any parts thereof to be free from defects in material and workmanship for a period of two (2) year from the date of rst purchase from an authorized dealer provided the product has ...
¿Tienes una pregunta acerca de FMI GL36STE?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con FMI GL36STE, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con FMI GL36STE probablemente compartirá una forma de solucionarlo.