-
Blaupunkt CM147 - page 1
...
-
Blaupunkt CM147 - page 2
2 FCC W arning The equipment has been tested and found to comply with the limits for a Class B device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and, if not instal ...
-
Blaupunkt CM147 - page 3
3 Español Advertencias FCC ........................................ 47 Registro del Propietario ................................ 47 Características .............................................. 48 Precauciones ................................................ 48 Panel Frontal Desmontable (Carátula) ........ 49 Conexiones Eléctricas e Instalaci? ...
-
Blaupunkt CM147 - page 4
4 Features Congratulations on your purchase of this Blaupunkt Cassette Receiver. Its Codem III-US FM/AM Tuner and Full-Logic, Soft-Touch Cassette Player provide the ultimate in sound reproduction. Its high-power amplifier and 4-Channel RCA preamp output provide you with tremendous system configuration flexibility. It’s auxiliary input jack lets y ...
-
Blaupunkt CM147 - page 5
5 Detachable Face Detaching & Attaching the Face: The face of this unit can be detached and taken with you to prevent it from being stolen. Detaching the Face: Before detaching the face, be sure to press the PWR Button first. Then press the REL (Release) Button and detach the face by gently pulling it off as illustrated. Note: Do not pull it st ...
-
Blaupunkt CM147 - page 6
6 Electrical Connections and Installation @/<?#&*>@! To avoid the aggravation of costly mistakes and serious damage that could make you feel this way, please carefully read all of the instructions before you begin. Carefully follow all instructions. You’ll be glad you did! GENERAL RECOMMENDATIONS • If you’re not confident that you c ...
-
Blaupunkt CM147 - page 7
7 • Connect the speaker leads only as indicated in the wiring diagram. Disconnect the vehicle battery’s negative terminal before making connections. • Only use speakers that have impedance ratings of 4 ohms or higher and have power-handling capabilities greater than the receiver’s stated power level. • The unit’s internal amplifier is d ...
-
Blaupunkt CM147 - page 8
8 Installation Recommendations • Carefully choose the mounting location so that the unit won’t interfere with normal driving. • Avoid mounting locations where the unit would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would subject to dust, dirt or excessive vibration. • The illustra ...
-
Blaupunkt CM147 - page 9
9 to dashboard/center console 2 NISSAN Mounting the Unit in a Japanese Car You may have difficulty mounting this unit in some Japanese cars that have ISO mounting features (side-bracket mounting systems). In this case, consult your Blaupunkt dealer. 1 Run a blade along the slits on the back of the front trim ring and separate it from the unit. Save ...
-
Blaupunkt CM147 - page 10
10 Maintenance Removing the Unit Use the Release Keys as shown below. Keep them in a safe place in case you need them in the future. Fuse Replacement When replacing the fuse, be sure to use one with the correct amperage, which will be stated on the fuse case. Never use a fuse that has a stated amperage exceeding the one supplied for this unit, as t ...
-
Blaupunkt CM147 - page 11
11 ...
-
Blaupunkt CM147 - page 12
12 Specifications Audio Power Specifications Power Output and Total Harmonic Distortion: 13.5 watts per channel minimum continuous average output into 4 ohms, 4 channels driven, from 30-15,000 Hz with no more than 1% total harmonic distortion. Other Specifications Tuner FM Tuning Range: 87.5 - 107.9 MHz Intermediate Frequency: 10.7 MHz FM Mono Sens ...
-
Blaupunkt CM147 - page 13
13 Location of Controls 1. REL (Release) Button 2. Mute/Audio Button Mute, Bass, Treble, Balance/Fade Access Name Storing/Deletion/Exit Minute: 00 3. SCA (Scan) Button Station Scan,Preset Scan,Track Scan,Disc Scan 4. DIS (Display)/MENU Button Display Change Menu Access Demo Message Off/On (8 second press) 5. Cassette Insertion Slot 6. Cassette Prog ...
-
Blaupunkt CM147 - page 14
14 Instructions — General Operation See Traffic Safety & Precautions on page 4. “Press” means a momentary press of less than 1/2 second. All presses requiring more than 1/2 second are followed by beep. (Beep for all button presses available through Direct Software Control Menu.) “Time Out” When additional button presses are anticipate ...
-
Blaupunkt CM147 - page 15
15 Audio Operation Volume Control Buttons (+/–) Press + and - to increase/decrease volume from 0 to 63, in increments of 1.25 dB/step. Volume control is accessible from all modes except Name Access and Edit modes. Mute & Cellular Mute Press Mute to temporarily reduce volume to level set under Menu. “MUTE” appears. (Same mute level is also ...
-
Blaupunkt CM147 - page 16
16 FM and AM Buttons Press FM to access last active FM bank. When in FM radio mode, press of FM advances to next FM band, FM1, FM2, or FM3/FMT. When in AM mode or other source, pressing FM button returns to last-tuned FM band. Press AM to access AM/AMT Band. Seek Tuning Press / or V to seek next receivable frequency. Tuning stops at frequency that ...
-
Blaupunkt CM147 - page 17
17 Cassette T ape Player Operation Once playback location change is complete, tape display sequence follows. Cassette Insertion & Eject “LOADING” appears upon insert and cassette play follows. Press Eject for a motorized eject. “EJECT” appears and radio plays. The following indicates what happens with insert and eject under various cond ...
-
Blaupunkt CM147 - page 18
18 Tape Track Repeat To play currently-selected track repeatedly, press RPT. While automatically rewinding to beginning of track, “FAST REW” appears. To cancel, press again. If tape manually advanced, RPTI remains active for new track. Tape Scan Press SCA to start. “TRCKSCAN” blinks during scanning operation. Unit stops at each track for sc ...
-
Blaupunkt CM147 - page 19
19 Disc Name Table Until the changer has the chance to identify the discs in a newly-inserted magazine, the names of any named discs are not available. When a new magazine is inserted, the changer reads and identifies the discs’ names at the earliest of the following opportunities: Disc Select (automatic or manual), Disc Scan, or Disc Select duri ...
-
Blaupunkt CM147 - page 20
20 Changer Reset In unlikely case of CD changer trouble, reset CD changer by turning unit’s power and/or ignition off, and then power on unit. (See TROUBLESHOOTING on page 23.) Changer T rack Program Memory (Skip/Play/Memory) Allows you to play only those tracks you want to hear. Programming a Disc 1. In CD changer mode, select CD disc you want t ...
-
Blaupunkt CM147 - page 21
21 Using the Menu (See Traffic Safety & Precautions on page 4) 1. Press DIS/MENU for 2 seconds to enter Menu mode. 2. Press / / V controls to scroll through Menu. 3. Use << or >> to change Menu setting (or to enter the following modes: Turn-on Message, Clock Adjustment, Timer Set, Station Name Access/Edit and Disc Name Access/Edit. ...
-
Blaupunkt CM147 - page 22
22 section. Use << and >> to choose minimum amount of blank time before blank skip begins from between 1 to 16 seconds. SUGGESTION: Classical music listeners may want to specify a longer blank, so that the unit doesn’t mistake soft passages for blank spots. Blank Skip Activation Press << or >> to turn Blankskip on or off. ...
-
Blaupunkt CM147 - page 23
23 Erasing ALL Radio Station Names Access Station Access mode under Menu. When a name appears, press Mute for 8 seconds. “ALLNAMES” appears for 2 seconds, then “DELETED” until deletion completed. Disc Naming (“DISCNAME”) Assigning a name to a disc makes it much easier to locate the desired disc. You can enter and store names of up to 99 ...
-
Blaupunkt CM147 - page 24
24 CD Changer operation Trouble Cause/Solution CD play does not start. • Dusty or defective disc. • The ambient temperature is more than 50 ° C (120 ° F). The disc cannot be loaded or is • The disc is inserted with the printed side downwards. automatically ejected. The sound skips due to vibration. • The changer is installed at an angle o ...
-
Blaupunkt CM147 - page 25
25 German Headquarters: Blaupunkt-Werke GmbH Postfach 77 77 77 D-31132 Hildesheim Germany Robert Bosch Corporation Sales Group — Blaupunkt Division 2800 South 25th Avenue, Broadview, Illinois 60153 1-800-950-BLAU Robert Bosch, SA., DE, C. V. Dr. Lucio 270 Cols. Doctores, Mexico 06720 Made in Malaysia Fabrique en Malasie Hecho en Malasia Fabricado ...
-
Blaupunkt CM147 - page 26
26 Notes / Notas ...
-
Blaupunkt CM147 - page 27
27 Notes / Notas ...
¿Tienes una pregunta acerca de Blaupunkt CM147?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Blaupunkt CM147, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Blaupunkt CM147 probablemente compartirá una forma de solucionarlo.