-
Bosch Appliances L0609466 - page 1
Installation Instructions Bosch Dual Fuel Range Slide-In Model ...
-
Bosch Appliances L0609466 - page 2
Table of Contents Safety ...................................................... 1 Installation ................................................. 3 Before You Begin ............................................................. 3 Installation Procedure .......................................................... 8 Service .............................. ...
-
Bosch Appliances L0609466 - page 3
Safety IMPORTANT SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS Important Safety Instructions Appliance Handling Safety Safety Codes and Standards Electric Safety WARNING: Do not repair or replace any part of the appliance unless specifi- cally recommended in the manuals. Improper installation, service or mainte- nance can cause injury or pro ...
-
Bosch Appliances L0609466 - page 4
,_Safety Gas Safety • Be sure your appliance is properly installed and grounded by a qualified tech- nician. Installation, electrical connections and grounding must comply with all applicable codes. • Install a gas shutoff valve near the appliance. It must be easily accessible in an emergency. • Leak testing must be conducted by the installer ...
-
Bosch Appliances L0609466 - page 5
Related Equipment Safety ,_ Safety • Warning: All ranges can tip. Injury to persons could result. Install anti-tip device packaged with range. Verify that the anti-tip devices are engaged. See installation instructions. Figure 2: Tipping Precautions • Remove all tape and packaging before using the appliance. Destroy the pack- aging after unpack ...
-
Bosch Appliances L0609466 - page 6
Installation Tools and Parts Needed Additional Parts Needed For Hard Wire Installations Parts Included General Information Range Power Supply Cord Kit (240V -30 Amp) Note: Not necessary for Canadian installations; Canadian units are shipped with the power cord already installed. Measuring Tape Phillips Head Screwdriver 1-1/4" (31.8 mm) Wrench ...
-
Bosch Appliances L0609466 - page 7
Preparation Installation Prepare Unit Remove all packaging material and discard. Tip: Place the range on a piece of the cardboard to protect floors. Remove drawer and set aside. 1. Pull drawer all the way out. 2. Locate locking clips on the rails, one on each side. 3. Push up on the clip on the left rail. Pull the drawer out until clip locks into p ...
-
Bosch Appliances L0609466 - page 8
Installation Electrical Requirements 4. Close the door until it stops. It will be about half- way open. 5. Holding the door firmly on both sides and using both hands, pull the door straight out of the hinge slots. Hold firmly, the door is heavy. 6. Place the door in a stable location. Refer to data plate for more information. See "Product Data ...
-
Bosch Appliances L0609466 - page 9
Gas Requirements Installation _k_ cauti°n: Make certain that gas shutoff valve and all burner controls are in the OFF position before beginning. Shut off main gas supply valve before disconnecting the old range and leave it off until the new hook-up has been completed. Don't forget to relight the pilot on other gas appliances when you turn th ...
-
Bosch Appliances L0609466 - page 10
Installation Allow a minimum of 30 inches between cabinets where range isto be installed 1.. _. ..... F _ . 30" _£16_ ........... Figure 5: Cutout Requirements - Typical Installation Note: The slide-in range can also replace a freestanding range. In this case, verify that the opening is at least 30 inches. Figure 6: Cutout Requirements - Repl ...
-
Bosch Appliances L0609466 - page 11
Installation ® 4" (10.2 cm) rain. 1 30" (76.2 cm) '_ min. centered 30" (76.2 cm) min. no clearance required (12 mm clearance required in Canada) ® 4" (10.2 cm) min. Figure 7: Cabinet Preparation Prepare Walls and Floor Countertop Requirements Mounting Requirements Required Clearance I From cooktop to materials above: Ther ...
-
Bosch Appliances L0609466 - page 12
Installation 2. Secure bracket with 2 screws adequate for mounting surface (i.e., forwood floor usewood screws, for concrete floor useconcrete anchors andscrews). rearwait cabinet walt device flush against cabinet walt Figure 8: Anti-Tip Bracket Ventilation Recommendations We strongly recommend the installation of a ventilation hood above this appl ...
-
Bosch Appliances L0609466 - page 13
Installation Install 2 screws through holes in trim andin range backwall. See Figure 9: Back- wall Trim Strip andFigure 10: Install Backwall Trim _rip Backwall Trim Strip Figure 9: Backwall Trim Strip j. . Back of Range Figure 10: Install Backwall Trim Strip Connect Electric There are two possible electrical connections: 1. Four wire range cord 2 ...
-
Bosch Appliances L0609466 - page 14
Installation Install Strain Relief Place strain relief in knockout below terminal block. See Figure 11: Strain Relief Knockout. ,_ Warning: The strain relief provided with your range cord must be properly installed. Strain reliefs vary. Carefully read and follow the instructions included with your strain relief. 1. In the knockout panel below the t ...
-
Bosch Appliances L0609466 - page 15
Installation Warning: Risk of Electric Shock or Fire. Frame grounded to neutral through a ground strap. Grounding through the neutral conductor is prohibited for new branch-circuit installations (1996 NEC), mobile homes, and recreational vehicles, or in an area where local codes prohibit grounding through the neutral conductor. Forinstallations whe ...
-
Bosch Appliances L0609466 - page 16
Installation . Remove top nut, star washer, and round washer from each post. Note: DO NOT remove last round washer, last nut or internal wiring leads. . 5. Remove screw from bottom end of ground strap. Remove ground strap from center post, rotate so that wide end is at top and attach wide end to range through hole below junction box. Attach green w ...
-
Bosch Appliances L0609466 - page 17
10. Properly secure strain relief (see previous section). Note: DONOT plug in range at this time. Installation Three Wire Range Cord Connection The Four Wire Connection (above) is preferred, but where local codes and ordi- nances permit grounding through neutral and where conversion to four wire is impractical, the unit may be connected to the powe ...
-
Bosch Appliances L0609466 - page 18
Installation 7. Tighten all connections securely andreplace terminal block cover. / green ground screw Figure 18: Completed Three Wire Range Cord Connection 8. Properly secure strain relief. See "Install _rain Relief' on page 12 for detailed instructions. Note: DO NOT plug in range at this time. Connect Gas Supply Shut off main gas supply ...
-
Bosch Appliances L0609466 - page 19
Important note for LP users Flexible Connector Method Installation The range is shipped from the factory for use with natural gas. For use with pro- pane (LP) gas, your range must first be converted using the LP conversion kit. If using rigid pipe, skip to "Rigid Pipe Method" on page 19. Attach Connector B A/ Figure 20: Flexible Connector ...
-
Bosch Appliances L0609466 - page 20
Installation drawer adjustable leg Figure 21: Adjust the Front Leveling Leg Slide Range into Opening . 2. Plug in power cord. Slide range into opening, being careful not to damage countertops, floors, or the range drawer front. Do not apply pressure to cooktop when sliding into position. Be careful not to crimp flexible connector. Tip: 1. . 3. If t ...
-
Bosch Appliances L0609466 - page 21
Rigid Pipe Method Adjust Front of Range for Proper Installation Installation 1. Adjust front leveling legs so that the cooktop trim rests snugly against the countertop all the way around. 2. Verify that both front legs are resting solidly on the floor. 3. Use a level to verify that the range is level and plumb. 4. Carefully tip range forward to ens ...
-
Bosch Appliances L0609466 - page 22
Installation . Make sure circuit breaker is off and then plug range cord into electrical outlet. Caution: Before you plug in an electrical cord, be sure all controls are in the Off position. 2. Line up range in front of opening. 3. Measure back left corner of opening from floor to top of countertop. 4. Adjust front leveling legs so that the bottom ...
-
Bosch Appliances L0609466 - page 23
Installation to verify thatboth back legs are resting solidly on the floor. Alsoverify that the leftrange legis under the anti-tip bracket. Caution: Verify thatthe weight of the range is not resting on the countertop. This could result in damage to the countertop andthe appliance. Test for Gas Leaks 3. If the back legs are not resting solidly on th ...
-
Bosch Appliances L0609466 - page 24
Installation Test the Installation Turn on power at breaker Test self-clean lock Test Rangetop Burners: Caution: If the display flashes and beeps, the polarity of the wiring may be reversed. Reversed polarity can damage the range and can result in electrical shock hazard. Immediately switch off power at the breaker and return to "Connect Elect ...
-
Bosch Appliances L0609466 - page 25
Yellow Flames: Further adjustment is required. Yellow Tips on Outer Cones: Normal for LP Gas. Soft Blue Flames: Normal for Natural Gas. If the flame is completely or mostly yellow, verify that the regulator is set for the correct fuel. After adjustment, retest. Some yellow streaking is normal during the initial start-up. Allow unit to oper- ate 4-5 ...
-
Bosch Appliances L0609466 - page 26
5551 McFadden Avenue, Huntington Beach, CA 92649 • 800-944-2904 • www.boschappliances.com 9000135014 (No ECO) ° 10089 Rev A ° 04/06 • © BSH Home Appliances Corporation • Litho U. S. A. ...
¿Tienes una pregunta acerca de Bosch Appliances L0609466?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Bosch Appliances L0609466, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Bosch Appliances L0609466 probablemente compartirá una forma de solucionarlo.