-
JVC KD-S675 - page 1
INSTRUCTIONS §”·π–π” GET0012-001A [U] For installation and connections, refer to the separate manual. °√ÿ≥“¥Ÿ§ŸË¡◊Õ∑’Ë·¬°µË“ßÀ“° „π°“√µ‘¥µ—Èß·≈–°“√‡™◊ËÕ¡µËÕ KD-S675 CD RECEIVER KD-S675 ENGLISH ∂“ ¥ „Ë´’¥’ KD-S675 !"#$ !"#$%&&apos ...
-
JVC KD-S675 - page 2
2 ENGLISH BEFORE USE * For safety .... • Do not raise the volume level too much, as this will block outside sounds, making driving danger ous. • Stop the car befor e performing any complicated operations. * T emperature inside the car .... If you have parked the car for a long time in hot or cold weather , wait until the temperatur e in the car ...
-
JVC KD-S675 - page 3
3 ENGLISH CONTENTS How to reset your unit .......................................................................... 2 BASIC OPERA TIONS .................................................... 4 RADIO OPERA TIONS ................................................... 5 Listening to the radio ............................................................... ...
-
JVC KD-S675 - page 4
4 ENGLISH BASIC OPERA TIONS Note: When you use this unit for the first time, set the built-in clock corr ectly , see page 19. Note on One-T ouch Operation: When you select a sour ce in step 2 below , the power automatically comes on. Y ou do not have to pr ess this button to turn on the power . 1 T urn on the power . 2 Select the source. T o operat ...
-
JVC KD-S675 - page 5
5 ENGLISH RADIO OPERA TIONS Listening to the radio 1 Select the band (FM1, FM2, FM3 or AM). Y ou can select any one of FM1, FM2, and FM3 to listen to an FM station. 2 Start searching a station. When a station is received, searching stops. T o stop searching before a station is received, press the same button you have pressed for searching. T o tune ...
-
JVC KD-S675 - page 6
6 ENGLISH Storing stations in memory Y ou can use one of the following two methods to store broadcasting stations in memory . • Automatic preset of FM stations: SSM (Strong-station Sequential Memory) • Manual preset of both FM and AM stations FM station automatic preset: SSM Y ou can preset 6 local FM stations in each FM band (FM1, FM2, and FM3 ...
-
JVC KD-S675 - page 7
7 ENGLISH Manual preset Y ou can preset up to 6 stations in each band (FM1, FM2, FM3 and AM) manually . EXAMPLE: Storing an FM station of 88.3 MHz into the preset number 1 of the FM1 band 1 Select the FM1 band. 2 T une into a station of 88.3 MHz. See page 5 to tune into a station. 3 Press and hold the button for more than 2 seconds. 4 Repeat the ab ...
-
JVC KD-S675 - page 8
8 ENGLISH 1 Select the band (FM1, FM2, FM3 or AM) you want. 2 Select the number (1 – 6) for the preset station you want. T uning into a pr eset station Y ou can easily tune into a preset station. Remember that you must store stations first. If you have not stored them yet, see pages 6 and 7. 2 1 FM1 FM2 FM3 AM EN05-09.KD-S675[U] 24/3/05, 8:46 PM ...
-
JVC KD-S675 - page 9
9 ENGLISH Scanning br oadcast stations When you press RPT/SCAN while listening to the radio, station scanning starts. Each time a broadcast is tuned in, scanning stops for about 5 seconds (tuned frequency number flashes on the display), and you can check what program is now being broadcasted. If you want to listen to that program, press the same bu ...
-
JVC KD-S675 - page 10
10 ENGLISH CD OPERA TIONS Playing a CD 1 Insert a disc into the loading slot. The unit turns on, draws a CD and starts playback automatically . • When a CD is inserted upside down, “EJECT” appears on the display and the CD automatically ejects. T o stop play and eject the CD Press 0 . CD play stops and the CD automatically ejects from the loa ...
-
JVC KD-S675 - page 11
11 ENGLISH Locating a track or a particular portion on a CD T o fast forward or reverse the track Press and hold ¢ , while playing a CD, to fast forward the track. Press and hold 4 , while playing a CD, to reverse the track. T o go to the next track or the previous track Press ¢ briefly, while playing a CD, to go ahead to the beginning of the nex ...
-
JVC KD-S675 - page 12
12 ENGLISH Selecting CD playback modes Other convenient CD functions Prohibiting CD ejection Y ou can prohibit the CD ejection and can “lock” a CD in the loading slot. Press and hold CD and 0 for more than 2 seconds. “EJECT” flashes on the display for about 5 seconds, and the CD is “locked.” T o cancel the prohibition and “unlock” t ...
-
JVC KD-S675 - page 13
13 ENGLISH SOUND ADJUSTMENTS 1 Select the item you want to adjust. Indication T o do: Range BAS Adjust the bass –06 (min.) — +06 (max.) (Bass) TRE Adjust the treble –06 (min.) — +06 (max.) (T reble) F AD Adjust the front and rear speaker R06 (rear only) — F06 (front only) (Fader)* balance BAL Adjust the left and right speaker L06 (left on ...
-
JVC KD-S675 - page 14
14 ENGLISH T urning on/off the loudness function The human ear is less sensitive to low and high frequencies at low volumes. The loudness function can boost these frequencies to produce well-balanced sound at low volume level. Each time you press LOUD, the loudness function turns on and off alternatively . @ A EN13-18.KD-S675[U] 14/12/00, 6:43 PM 1 ...
-
JVC KD-S675 - page 15
15 ENGLISH Using the Sound Contr ol Memory (SCM) Y ou can select and store a preset sound adjustment suitable to each playback source. ( Advanced SCM ) Selecting and storing the sound modes Once you select a sound mode, it is stored in memory , and will be recalled every time you select the same source. A sound mode can be stored each of the follow ...
-
JVC KD-S675 - page 16
16 ENGLISH Recalling the sound modes 1 When “SCM LINK” is set to “LINK ON,” select the source. The sound mode stored in memory for the selected source is recalled. Notes: • Y ou can adjust each sound mode to your pr efer ence, and stor e it in memory . If you want to adjust and stor e your original sound mode, see “Storing your own soun ...
-
JVC KD-S675 - page 17
17 ENGLISH Canceling Advanced SCM Y ou can cancel the Advanced SCM (Sound Control Memory), and unlink the sound modes and the playback sources. When shipped from the factory , a different sound mode can be stored in memory for each source so that you can change the sound modes simply by changing the sources. LINK ON: Advanced SCM (different SCMs fo ...
-
JVC KD-S675 - page 18
18 ENGLISH Storing your own sound adjustments Y ou can adjust the sound modes (BEA T , SOFT , POP: see page 15) to your preference and store your own adjustments in memory . 1 Call up the sound mode you want to adjust. See page 15 for details. 2 T o adjust the bass or treble sound level Select “BAS” or “TRE.” T o turn on or of f the loudnes ...
-
JVC KD-S675 - page 19
19 ENGLISH 1 Press and hold SEL for more than 2 seconds. “CLOCK H,” “CLOCK M,” “SCM LINK,” “LEVEL” or “TEL” appears on the display . 2 Set the hour . 1. Select “CLOCK H” if not shown on the display . 2. Adjust the hour . 3 Set the minute. 1. Select “CLOCK M.” 2. Adjust the minute. 4 Start the clock. 2, 3 1, 4 2, 3 2. 1. ...
-
JVC KD-S675 - page 20
20 ENGLISH T o check the current clock time (changing the display mode) Press DISP repeatedly . Each time you press the button, the display mode changes as follows. • If the unit is not in use when you press DISP , the power turns on, the clock time is shown for 5 seconds, then the power turns off. Clock Elapsed playing time During tuner operatio ...
-
JVC KD-S675 - page 21
21 ENGLISH 1 Press and hold SEL for more than 2 seconds. “CLOCK H,” “CLOCK M,” “SCM LINK,” “LEVEL” or “TEL” appears on the display . 2 Select “LEVEL” if not shown on the display . 3 Select the desired mode —“AUDIO 1”, “AUDIO 2” or “OFF”. 4 Finish the setting. Selecting the level display Y ou can select the leve ...
-
JVC KD-S675 - page 22
22 ENGLISH Selecting the telephone muting This mode is used when a cellular phone system is connected. Depending on the phone system used, select either “MUTING 1” or “MUTING 2,” whichever mutes the sounds from this unit. When shipped from the factory , this mode is deactivated. • MUTING 1: Select this if this setting can mute the sounds. ...
-
JVC KD-S675 - page 23
23 ENGLISH How to detach the control panel Before detaching the control panel, be sure to turn off the power . 1 Unlock the control panel. 2 Lift and pull the control panel out of the unit. 3 Put the detached control panel into the case provided. How to attach the control panel 1 Insert the left side of the control panel into the groove on the pane ...
-
JVC KD-S675 - page 24
24 ENGLISH REMOTE OPERA TIONS 1. Remove the battery holder . 1) Push out in the direction indicated by the arrow using a ball point pen or a similar tool. 2) Remove the battery holder . 2. Place the battery . Slide the battery into the holder with the + side facing upwards so that the battery is fixed in the holder . 3. Return the battery holder . ...
-
JVC KD-S675 - page 25
25 ENGLISH Using the r emote contr oller 1 Functions the same as the button on the main unit. 2 • Functions as the BAND button while listening to the radio. Each time you press the button, the band changes. • Does not function as the PROG /DISC + button. 3 • Functions as the PRESET button while listening to the radio. Each time you press the ...
-
JVC KD-S675 - page 26
26 ENGLISH Center holder COMPACT DIGITAL AUDIO MAINTENANCE Handling CDs This unit has been designed only to reproduce the CDs bearing the mark. Other discs cannot be played back. How to handle CDs When removing a CD from its case, press down the center holder of the case and lift the CD out, holding it by the edges. • Always hold the CD by the ed ...
-
JVC KD-S675 - page 27
27 ENGLISH What appears to be trouble is not always serious. Check the following points before calling a service center . Symptoms • CD cannot be played back. • CD sound is sometimes interrupted. • Sound cannot be heard from the speakers. • SSM (Strong-station Sequential Memory) automatic preset does not work. • Static noise while listeni ...
-
JVC KD-S675 - page 28
28 ENGLISH AUDIO AMPLIFIER SECTION Maximum Power Output: Front: 45 watts per channel Rear: 45 watts per channel Continuous Power Output (RMS): Front: 17 watts per channel into 4 Ω , 40 to 20 000 Hz at no more than 0.8% total harmonic distortion. Rear: 17 watts per channel into 4 Ω , 40 to 20 000 Hz at no more than 0.8% total harmonic distortion ...
-
JVC KD-S675 - page 29
KD-S675 Installation/Connection Manual O² O² O² O² O² ÒÒ ÒÒ Ò ØVOd²« ULOKFð V ØVOd²« ULOKFð V ØVOd²« ULOKFð V ØVOd²« ULOKFð V ØVOd²« ULOKFð V qOu²« qOu²« qOu²« qOu²« qOu²« wÐdŽ wÐdŽ wÐdŽ wÐdŽ wÐdŽ • wzUÐdN? ...
-
JVC KD-S675 - page 30
Flat type screws (M5 x 6 mm)* ® …bŽUI« W¹u² wž«dÐ M5 ©rK ∂ ™ * * Not included with this unit. * Ëe dOž Ò Æ“UN'« «c¼ l œ Note: When installing the unit on the mounting bracket, make sure to use the 6 mm-long screws. If longer screws are used, they could damage the unit. ∫WEŠö ∫WEŠö ∫WE? ...
-
JVC KD-S675 - page 31
ENGLISH ELECTRICAL CONNECTIONS T o prevent short circuits, we recommend that you disconnect the battery ’ s negative terminal and make all electrical connections before installing the unit. If you are not sure how to install this unit correctly , have it installed by a qualified technician. Note: This unit is designed to operate only on 12 volts ...
-
JVC KD-S675 - page 32
PRECAUTIONS on power supply and speaker connections: • DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the unit will be seriously damaged. • Connect the black lead (ground), yellow lead (to car battery , constant 12V), and red lead (to an accessory terminal) correctly . • BEFORE connecting the speaker leads o ...
¿Tienes una pregunta acerca de JVC KD-S675?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con JVC KD-S675, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con JVC KD-S675 probablemente compartirá una forma de solucionarlo.