Español dropdown-ico

Manual de instrucciones Cisco Systems 6503

19 de páginas 0.52 mb
Descargar

Pasar a la página of 19

Summary
  • Cisco Systems 6503 - page 1

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 1 of 19 White P aper High A vailability for the Cisco Catalyst 650 0 S eries Switc hes Figure 1 The Cisco Catalyst 6500 Series WS-6503, WS-C6506, WS-C6509, WS-C6509-NEBS, and WS-C6513 Overview Cisco ...

  • Cisco Systems 6503 - page 2

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 2 of 19 redundancy . For more detail on high-a vailability network designs, refer to the white paper , Gigabit Campus Design , at: http://www .cisco.com/warp/public/cc/so/neso/lnso/cpso/camp_wp.htm . ...

  • Cisco Systems 6503 - page 3

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 3 of 19 The changes to the switching mode are done automatically , depending on the hardware installed. No specific configuration is necessary on the SFM for typical operation. The current switchin ...

  • Cisco Systems 6503 - page 4

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 4 of 19 Example 2: Classic and Fabric-Enabled System The following output is from a configuration with dual supervisor engines, one SFM, one classic line card in slot 3, and two fabric-enabled line ...

  • Cisco Systems 6503 - page 5

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 5 of 19 Redundant Supervisor Engines As previously mentioned, the High A vailability feature on the Cisco Catalyst 6500 Series provides lo w-impact, stateful switchov er between redundant supervisor ...

  • Cisco Systems 6503 - page 6

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 6 of 19 disabling port channels (PagP), and turning trunking of f for ports to which workstations are directly attached, the fast switchov er time can be reduced to approximately 10 seconds. In a liv ...

  • Cisco Systems 6503 - page 7

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 7 of 19 T able 1 shows protocols and features for high a v ailability as of Cisco Catalyst OS version 7.5 that are supported, compatible, and incompatible. For a current list of the features that are ...

  • Cisco Systems 6503 - page 8

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 8 of 19 Both supervisor engines run a synchronizing operation to allow for transfer of this data. When a database entry is updated on the activ e supervisor engine, the synchronizing operation places ...

  • Cisco Systems 6503 - page 9

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 9 of 19 The image synchronization feature of Cisco Catalyst OS provides software consistenc y between supervisor engines, but it does not allow for softw are upgrades without taking the system offli ...

  • Cisco Systems 6503 - page 10

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 10 of 19 http://www .cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/ol_1982.htm - xtocid8 Cisco Catalyst OS Image Upgrade Procedur e Based on the discussion abov e, the following procedure ...

  • Cisco Systems 6503 - page 11

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 11 of 19 10. Reset the standby supervisor engine. Sup-A> (enable) reset 2 The standby supervisor engine reboots with the new Cisco Catalyst OS image, remains in standby mode, and does not af fect ...

  • Cisco Systems 6503 - page 12

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 12 of 19 Dual Router Mode DRM is the original MSFC configuration for redundant supervisor engine or MSFC configurations. In this mode, both MSFCs are activ e routers on the network. Having tw o act ...

  • Cisco Systems 6503 - page 13

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 13 of 19 The following commands enable MSFC config-sync: MSFC-Sup-15 (config)# redundancy MSFC-Sup-15 (config-r)# high-availability MSFC-Sup-15 (config-r-ha)# config-sync W ith config-sync, all con ...

  • Cisco Systems 6503 - page 14

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 14 of 19 For these scenarios, SRM is no w av ailable. Single Router Mode SRM is provided as an option for customers who wish to implement redundant supervisor engines or MSFCs in a system with only o ...

  • Cisco Systems 6503 - page 15

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 15 of 19 The same IP and Media Access Control (MA C) addresses are used for the designated router , whether or not the MSFC is the designated router . The MSFC that is chosen as the designated router ...

  • Cisco Systems 6503 - page 16

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 16 of 19 SRM and IP Multicast W ith SRM, the VLAN interfaces on the nondesignated router are in a down state. Even after a f ailover , these interfaces will not mov e into an up state until the super ...

  • Cisco Systems 6503 - page 17

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 17 of 19 DRM hostname DRM ! redundancy high-availability config-sync ! interface Vlan20 ip address 10.20.1.3 255.255.255.0 alt ip address 10.20.1.2 255.255.255.0 standby ip 10.30.1.4 standby priority ...

  • Cisco Systems 6503 - page 18

    Cisco Systems, Inc. All contents are Copyright © 1992–2002 Cisco Systems, Inc. All rights reserved. Important Notices and Pri vac y Statement. Page 18 of 19 disabled, the power a v ailable to the system is the combined power of the po wer supplies. Note that in this configuration, if one supply fails, the system might not ha ve enough power to ...

  • Cisco Systems 6503 - page 19

    Corporate Headquarters Cisco Systems, Inc. 170 W est T asman Drive San Jose, CA 95134-1706 USA www .cisco.com T el: 408 526-4000 800 553-NETS (6387) Fax: 408 526-4100 European Headquarters Cisco Systems International BV Haarlerbergpark Haarlerbergweg 13-19 1101 CH Amsterdam The Netherlands www-europe.cisco.com T el: 31 0 20 357 1000 Fax: 31 0 20 35 ...

Fabricante Cisco Systems Categoría Switch

Los documentos del dispositivo Cisco Systems 6503 que obtenemos del fabricante se pueden dividir en varios grupos. Entre ellos están::
- dibujos técnicos Cisco Systems
- manuales de instrucciones 6503
- hojas de producto Cisco Systems
- folletos informativos
- o etiquetas energéticas Cisco Systems 6503
Todos son importantes, pero lo más importante desde el punto de vista del usuario de un dispositivo lo encontraremos en el manual de instrucciones Cisco Systems 6503.

Un conjunto de documentos determinado como manual de instrucciones se divide también en tipos más detallados, tales como: instrucciones de montaje Cisco Systems 6503, instrucciones de servicio, instrucciones cortas o instrucciones de usuario Cisco Systems 6503. Dependiendo de la situación debes buscar el documento que necesitas. En nuestra página puedes consultar el manual de instrucciones más popular del producto Cisco Systems 6503.

Manuales de instrucciones parecidos

El manual de instrucciones del dispositivo Cisco Systems 6503, ¿cómo debería ser?
El manual de instrucciones, también determinado como el manual de usuario o simplemente instrucciones, es un documento técnico que tiene como objetivo ayudar a los usuarios a utilizar Cisco Systems 6503. Las instrucciones normalmente las realiza un escritor técnico pero en un lenguaje comprensible para todos los usuarios de Cisco Systems 6503.

El manual de instrucciones completo de Cisco Systems debe contener unos elementos básicos. Una parte de ellos es menos importante, como por ejemplo: la portada / la página principal o las páginas de autor. Sin embargo, lo demás debe facilitarnos la información más importante desde el punto de vista del usuario.

1. Introducción y pistas sobre cómo orientarse con el manual Cisco Systems 6503 - Al principio de cada manual se deben encontrar las indicaciones acerca de la manera de usar un manual de instrucciones. Debe contener información sobre dónde encontrar el índice Cisco Systems 6503, preguntas frecuentes o problemas más comunes – son los apartados más buscados por los usuarios de cada manual de instrucciones.
2. Índice - listados de todos los consejos acerca de Cisco Systems 6503 que encontraremos en el documento
3. Consejos de uso de las funciones básicas del dispositivo Cisco Systems 6503 - que deben facilitarnos los primeros pasos durante el uso de Cisco Systems 6503
4. Troubleshooting - una secuencia sistematizada de acciones que nos ayudará a diagnosticar los problemas más importantes con Cisco Systems 6503
5. FAQ - las preguntas frecuentes
6. Datos de contacto Información acerca de cómo encontrar los datos de contacto del fabricante / servicio de Cisco Systems 6503 en cada país si no somos capaces de solucionar el problema por nuestra cuenta.

¿Tienes una pregunta acerca de Cisco Systems 6503?

Utiliza el formulario que se encuentra abajo

Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Cisco Systems 6503, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Cisco Systems 6503 probablemente compartirá una forma de solucionarlo.

Copia el texto de la imagen

Captcha
Nueva imagen

Comentarios (0)