-
Hatco Hatco 3CS2 - page 1
HYDRO-HEA TER Sanitizing Sink Heaters Food Rethermalizers/Bain-Marie Heaters Installation & Operating Manual I&W #07.05.133.00 This manual contains important safety information concerning the maintenance, use, and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury . If you are ...
-
Hatco Hatco 3CS2 - page 2
Sanitizing Sink Heaters and Food Rethermalizers/Bain- Marie Heaters. W e recommend all installation, operating and safety instructions appearing in this manual be read prior to installation or operation of your Hatco Hydro- Heater . Safety instructions that appear in this manual after a warning symbol and the words W ARNING or CAUTION printed in bo ...
-
Hatco Hatco 3CS2 - page 3
CAUTIONS W ater in the unit and holding vessel is very hot. W ear protective gloves and pr oper attir e when operating to avoid injury . Do not use extension pipes on the inlet and outlet connections on heater units. Poor performance or unsafe conditions may occur . Unit is not weatherproof. For safe and proper operation locate the unit indoors whe ...
-
Hatco Hatco 3CS2 - page 4
IMPOR T ANT SAFETY INSTRUCTIONS 2 Form No. HHM-1 103 IMPOR T ANT! Read the following important safety instructions to avoid personal injury or death, and to avoid damage to the equipment or pr operty . CAUTIONS Do not overtighten unions or nuts. Overtightening may cause leaks. Do not turn the electrical current to the unit on until the holding vess ...
-
Hatco Hatco 3CS2 - page 5
Model 208 V olt 240 V olt FR2-3 NEMA 6-20P NEMA 6-20P FR2-4 NEMA 6-30P NEMA 6-30P SPECIFICA TIONS MODEL DESCRIPTIONS 3 ALL MODELS The Hydro-Heater mounts to the underside of a holding vessel, leaving the entire vessel area free. Units are shipped ready to install with all gaskets and fittings. Hydro-Heaters include a stainless steel front, powder c ...
-
Hatco Hatco 3CS2 - page 6
SPECIFICA TIONS 4 Form No. HHM-1 103 Kilowatts Wir e Sizing Fuse or Model V oltage (kW) Phase Amps A WG*† Circuit Br eaker* Shipping W eight 3CS2-3 208 3 1 14.5 12 20 24 lbs. (1 1 kg) 3CS2-4 208 4 1 19.2 12 30 24 lbs. (1 1 kg) 3CS2-6 208 6 1 28.8 10 40 27 lbs. (12 kg) 3CS2-3 240 3 1 12.5 12 20 24 lbs. (1 1 kg) 3CS2-4 240 4 1 16.7 12 30 24 lbs. (1 ...
-
Hatco Hatco 3CS2 - page 7
Kilowatts Wir e Sizing Fuse or Model V oltage (kW) Phase Amps A WG* † Circuit Br eaker* Shipping W eight FR2-3 208 3 1 14.5 12 20 24 lbs. (1 1 kg) FR2-4 208 4 1 19.2 12 30 24 lbs. (1 1 kg) FR2-6 208 6 1 28.8 10 40 27 lbs. (12 kg) FR2-3 240 3 1 12.5 12 20 24 lbs. (1 1 kg) FR2-4 240 4 1 16.7 12 30 24 lbs. (1 1 kg) FR2-6 240 6 1 25.0 10 40 27 lbs. ( ...
-
Hatco Hatco 3CS2 - page 8
SPECIFICA TIONS 6 Form No. HHM-1 103 SIZING INFORMA TION Hatco recommends the following guidelines be used to ensure proper operation and sanitation. For 3CS2 Series in a Manual W arewashing Application • Minimum 2000 watts (2 kW) per square foot (.2 watts per sq. mm) of vessel top. • 3CS2 units are sized based on a 140ºF (60ºC) supply water ...
-
Hatco Hatco 3CS2 - page 9
INST ALLA TION 7 PLUMBING An adhesive backed paper template is shipped with the unit and is used to locate the sink strainer holes. Use the following procedure to install the heater unit to the holding vessel. NOTE: The FR2 heater should be positioned with no mor e than 3' (914 mm) on either side when mounted under holding vessel. See Figur e ...
-
Hatco Hatco 3CS2 - page 10
INST ALLA TION 8 Form No. HHM-1 103 CAUTION Do not overtighten unions or nuts. Overtightening may cause leaks. NOTE: A 3/4" (19 mm) hose or pipe may be connected to the heater sump drain and run to an open sight drain. The sump drain should not be permanently connected to the sanitary drain system. Check local plumbing code for pr oper drain i ...
-
Hatco Hatco 3CS2 - page 11
NOTE–AUTO-FILL UNITS ONL Y: When the tank water level r eaches the low water pr obe the display will show the curr ent water temperatur e and a small red light will glow in the upper left-hand corner of the display indicating the heating elements ar e ener gized. W ater will continue to fill the tank until the upper water pr obe has been satisfie ...
-
Hatco Hatco 3CS2 - page 12
10 Form No. HHM-1 103 OPERA TION NOTE: If steps 6-9 ar e interrupted or no changes ar e made for 15 seconds the contr oller will go back to its original setting without accepting the change. NOTE: If unit displays “E1” or “E2” the internal water sensing pr obe is out of temperatur e range. If this occurs contact Hatco Parts and Service T ea ...
-
Hatco Hatco 3CS2 - page 13
OPERA TION 11 Form No. HHM-1 103 W ater T emp. At Start-Up T emperature °F (°C) W ater Heated T o: W ater T emp. At Start-Up T emperature °F (°C) W ater Heated T o: MINUTES TO HEA T T ABLE * * Results may vary depending upon wattage/square foot. As wattage per foot increase, the speed of heating will increase. 9" (229 mm) DEEP W A TER - 75 ...
-
Hatco Hatco 3CS2 - page 14
12 Form No. HHM-1 103 MAINTENANCE GENERAL W ARNING T o avoid any electrical shock hazard, or physical burns turn the power OFF at the fuse disconnect switch/circuit br eaker or unplug the unit from the power sour ce and allow to cool completely before performing any maintenance or cleaning. W ARNING T o prevent any injury or damage to the unit do n ...
-
Hatco Hatco 3CS2 - page 15
13 Form No. HHM-1 103 MAINTENANCE OPTIONAL POWER FLUSH CLEANING NOTE: Power Flush Kit sold separately . 1. Turn power switch to OFF position. 2. Connect one end of a drain hose onto the sump drain outlet and place the open end in a bucket or open site drain in a manner according to local plumbing codes. 3. Drain the holding vessel by moving the sum ...
-
Hatco Hatco 3CS2 - page 16
Form No. HHM-1 103 14 MAINTENANCE DELIMING INSTRUCTIONS CAUTION Inspect daily for lime and sediment buildup inside unit. Excessive amounts can affect unit performance and reduce the operating life of the unit. NOTE: Pr oduct failur e caused by liming or sediment buildup is not cover ed under warranty . CAUTION T o avoid any damage to the heater uni ...
-
Hatco Hatco 3CS2 - page 17
Form No. HHM-1 103 15 MAINTENANCE W ARNING If service is requir ed on this unit, contact your Authorized Hatco Service Agent, or contact the Hatco Service Department at 800-558-0607 or 414-671-6350; fax 800-690-2966 or international fax 414-671-3976. W ARNING This product has no “user” serviceable parts. T o avoid damage to the unit or injury t ...
-
Hatco Hatco 3CS2 - page 18
Form No. HHM-1 103 16 HA TCO LIMITED W ARRANTY 1. PRODUCT W ARRANTY Hatco warrants the products that it manufactures (the “Products”) to be free from defects in materials and workmanship, under normal use and service, for a period of one (1) year from the date of purchase when installed and maintained in accordance with Hatco’ s written instr ...
-
Hatco Hatco 3CS2 - page 19
Form No. HHM-1 103 17 NOTES ...
-
Hatco Hatco 3CS2 - page 20
HA TCO CORPORA TION P .O. Box 340500, Milwaukee, WI 53234-0500 U.S.A. (800) 558-0607 (414) 671-6350 Parts & Service Fax (800) 690-2966 Int’l. Fax (414) 671-3976 www .hatcocorp.com HA TCO AUTHORIZED P ARTS DISTRIBUTORS Printed in U.S.A. November 2003 ALABAMA Jones McLeod Appl. Svc. Birmingham 205-251-0159 ARIZONA Auth. Comm. Food Equip. Phoeni ...
¿Tienes una pregunta acerca de Hatco Hatco 3CS2?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Hatco Hatco 3CS2, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Hatco Hatco 3CS2 probablemente compartirá una forma de solucionarlo.