-
Roland CM-30 - page 1
Owner’s Manual Thank you, and congratulations on your choice of the Roland CUBE Monitor CM-30. Before using this unit, carefully read the sections entitled: • IMPORTANT SAFETY INSTRUCTIONS (p. 2) • USING THE UNIT SAFELY (p. 3 and 4) • IMPORTANT NOTES (p. 5) These sections provide important information concerning the proper operation of the ...
-
Roland CM-30 - page 2
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN ATTENTION : RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to aler ...
-
Roland CM-30 - page 3
3 USING THE UNIT SAFELY 001 • Before using this unit, make sure to read the instructions below, and the Owner’s Manual. .................................................................................................. 002a • Do not open or perform any internal modifi- cations on the unit. ..................................................... ...
-
Roland CM-30 - page 4
4 012a • Immediately turn the power off, remove the power cord from the outlet, and request servicing by your retailer, the nearest Roland Service Center, or an authorized Roland distributor, as listed on the “Infor- mation” page when: • The power-supply cord, or the plug has been damaged; or • If smoke or unusual odor occurs • Objects ...
-
Roland CM-30 - page 5
5 IMPORTANT NOTES 291b In addition to the items listed under “IMPORTANT SAFETY INSTRUCTIONS” and “USING THE UNIT SAFELY” on pages 2, 3 and 4, please read and observe the following: Power Supply 301 • Do not connect this unit to same electrical outlet that is being used by an electrical appliance that is controlled by an inverter (such as ...
-
Roland CM-30 - page 6
6 Panel Descriptions ■ Control Panel fig.01 ■ Jack Panel fig.01 1 2 3 4 5 7 6 1 8 10 9 2 CM-30_e.book 6 ページ ２００４年７月２８日 水曜日 午前９時３２分 ...
-
Roland CM-30 - page 7
7 Panel Descriptions 1. CH 1 knob / CH 1 Input Jacks In addition to a 1/4” phone jack, this channel is equipped with a balanced XLR connector, useful for connecting microphones. This accepts input levels ranging from mic input (-50 dBu) to line level from sound modules and other equipment (-20 dBu). * The pin assignment for the XLR type connector ...
-
Roland CM-30 - page 8
8 Making the Connections Refer to the figure shown below to connect the CM-30 and the other equipment. Here is an example of a setup that makes full use of the CM-30’s mixer and monitor functions. A mic is input to CH 1, which accepts mic level input. Connect a keyboard, recorder, or other sound-generating devices to the CH 2 and CH 3 inputs. * T ...
-
Roland CM-30 - page 9
9 Making the Connections Switching the Power On and Off Once the connections have been completed, turn on power to your various devices in the order specified. By turning on devices in the wrong order, you risk causing malfunction and/or damage to speakers and other devices. 1. Make sure that all volume controls on the CM-30 and connected devices a ...
-
Roland CM-30 - page 10
10 Making the Connections Using Two CM-30 Speakers for Stereo Playback (Stereo Link) Stereo playback is enabled simply by connecting two CM-30 units with a single or double audio cables (phone type). This function is called “Stereo Link.” Since the CM-30’s mixer section operates in stereo, the L or R channel signal can be output from a STEREO ...
-
Roland CM-30 - page 11
11 Using a Microphone Stand By using a mic stand, you can mount the CM-30 at the optimal height for use as a monitor speaker or simple PA device. Requirements when using a mic stand ● As shown in the diagram below, the mic stand’s tripod must be extended to its maximum width (at least 63 cm/25 inches) and the height must be less than 110 cm (in ...
-
Roland CM-30 - page 12
12 Appendices Block Diagram fig.13 L R PHONES (STEREO) LINK OUT L LINK OUT R POWER AMP SPEAKER LOW HIGH EQUALIZER CH 1 XLR CH 1 PHONE CH 2 L (MONO) AUX IN 1 L/R LINK IN VOLUME VOLUME CH 2 R VOLUME AUX IN 2 CH 3 L (MONO) VOLUME CH 3 R VOLUME CM-30_e.book 12 ページ ２００４年７月２８日 水曜日 午前９時３２分 ...
-
Roland CM-30 - page 13
13 Appendices Main Specifications ● Rated Power Output 30 W ● Nominal Input Level (1 kHz) Channel 1 (MIC/LINE): -50 – -20 dBu Channel 2, 3 (LINE): -20 dBu AUX IN 1, 2: -10 dBu STEREO LINK IN: -10 dBu ● Nominal Output Level (1 kHz) STEREO LINK OUT L/R: -10 dBu *0 dBu = 0.775 Vrms ● Speakers 16 cm (6.5 inches) + Tweeter (Coaxial 2-way) ● ...
-
Roland CM-30 - page 14
14 MEMO CM-30_e.book 14 ページ ２００４年７月２８日 水曜日 午前９時３２分 ...
-
Roland CM-30 - page 15
15 MEMO CM-30_e.book 15 ページ ２００４年７月２８日 水曜日 午前９時３２分 ...
-
Roland CM-30 - page 16
SD000523 1GT This product complies with the requirements of European Directives EMC 89/336/EEC and LVD 73/23/EEC. For EU Countries CM-30_e.book 16 ページ ２００４年７月２８日 水曜日 午前９時３２分 ...
¿Tienes una pregunta acerca de Roland CM-30?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Roland CM-30, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Roland CM-30 probablemente compartirá una forma de solucionarlo.