-
Regency I1100S - page 1
FPI FIREPLACE PRODUCTS INTERNA TIONAL L TD. 6988 V enture St., Delta, BC Canada, V4G 1H4 908-332b MODELS: H2100 I1 100S I3100L WOOD Fireplace Inserts & Hearth Heater 1 1/15/07 Owners & Installation Manual T ested by: Installer : Please complete the details on the back cover and leave this manual with the homeowner . Homeowner: Please keep t ...
-
Regency I1100S - page 2
Regency Wood Insert & Hearth Heater 2 Thank-you for purchasing a REGENCY FIREPLACE PRODUCT . The pride of workmanship that goes into each of our products will give you years of trouble-free enjoyment. Should you have any questions about your product that are not covered in this manual, please contact the REGENCY DEALER in your area. Keep those ...
-
Regency I1100S - page 3
Regency Wood Insert & Hearth Heater 3 REGENCY FIREPLACE INSERTS & HEARTH HEA TER T ABLE OF CONTENTS SAFETY LABEL Safety Label For I1 100S & I3100L ................................. 4 Safety Label For H2100M ............................................. 5 INST ALLA TION Before Installing Y our Insert ..................................... ...
-
Regency I1100S - page 4
Regency Wood Insert & Hearth Heater 4 LISTED FACTORY BUILT FIREPLACE INSERT CERTIFIED FOR USE IN CANADA AND U.S.A. MODEL: I3100L TESTED TO: ULC S628-M93 / UL 1482-1998 / ULC S627-00 / UL 737-2000 REPORT NO. 632-323500 (MAR.1994) DO NOT REMOVE THIS LABEL 106 COMPONENTS REQUIRED FOR INSTALLATION: 6" (150mm) STAINLESS STEEL LINER. OPTIONAL CO ...
-
Regency I1100S - page 5
Regency Wood Insert & Hearth Heater 5 SAFETY LABEL This is a copy of the label that accompanies each Regency Hearth Heater . We have printed a copy of the contents here for your review . 103 DO NOT REMOVE BRICKS OR MORTAR IN MASONRY FIREPLACE. FOR USE WITH SOLID WOOD FUEL ONLY. DO NOT USE GRATE OR ELEVATE FIRE. BUILD WOOD FIRE DIRECTLY ON HEART ...
-
Regency I1100S - page 6
Regency Wood Insert & Hearth Heater 6 INST ALLA TION CHIMNEY SPECIFICA TIONS Before installing, check and clean your chimney system thoroughly . If in doubt about its condi- tion, seek professional advice. Y our Regency Insert is designed for installation into a masonry fi replace that is constructed in accordance with the requirements of &quo ...
-
Regency I1100S - page 7
Regency Wood Insert & Hearth Heater 7 Clearance diagram for installations INST ALLA TION Side and T op facing is a maximum of 1.5" thick. Floor protection must non-combustible, insula- tive material with an R value of 1.1 or greater . * If the hearth extension is fl ush with the fl oor (F) it must extend 19.5" in front of the body f ...
-
Regency I1100S - page 8
Regency Wood Insert & Hearth Heater 8 1) Positive Flue Connection with Cleanout FLUE CONNECT OR BRACKET Package contains: 3 brackets and 6 screws. These brackets are to be used to hold the fl ue liner (not supplied) to the Insert and keep the connection. The brackets are screwed into the top of the Insert in the pre-punched holes and then scre ...
-
Regency I1100S - page 9
Regency Wood Insert & Hearth Heater 9 INST ALLA TION Diagram 4: H2100M and I3100L Faceplate Assembly B) H2100M and I3100L Insert Diagram 2: I1 100S Rear View Diagram 3: I1 100S 1) Slide the spring nuts (supplied) over the slots in the insert’s side convection panels (the spring nuts may need to be squeezed with a pair of pliers fi rst, to he ...
-
Regency I1100S - page 10
Regency Wood Insert & Hearth Heater 10 Ground Fan Fan Ground Green Neutral Live White Fan Switch Manual/ Auto Switch Black Black High (Black) Low (Red) Black Fan Thermodisc (normally open) 120V AC 60 Hz Thermo Switch Sensor Thermo Switch Sensor INST ALLA TION F AN / BLOWER Blower/Fan Wiring Diagram 3) Slide the supports into the clips. The tens ...
-
Regency I1100S - page 11
Regency Wood Insert & Hearth Heater 11 BRICK FLUE BAFFLE & SECONDAR Y AIR TUBE INST ALLA TION The fl ue baffl e system located in the upper area of the fi rebox is removable to make cleaning your chimney system easier . The brick baffl es must be installed prior to your fi rst fi re. Smoke spillage and draft problems may occur if the ...
-
Regency I1100S - page 12
Regency Wood Insert & Hearth Heater 12 Pull Open Push Closed INST ALLA TION Side View Front View Front View Hearth Heater (H2100M) Steel Baffl e Place the insulation batt on top of the baffl e. Make sure that this batt is laying fl at and does not obstruct the smoke from getting up the fl ue opening. This insulating batt may be wrapped in p ...
-
Regency I1100S - page 13
Regency Wood Insert & Hearth Heater 13 automatic temperature sensor will engage the blower when the unit is at temperature and will shut off the blower once the fi re has gone out and the unit has cooled to below a useful heat output range. T o manually operate the fan system, push the fi rst switch to "Man" and second switch to eit ...
-
Regency I1100S - page 14
Regency Wood Insert & Hearth Heater 14 6) Do not permit creosote or soot buildup in the chimney system. Check and clean chimney at regular intervals. 7) Y our Regency Insert can be very hot. Y ou may be seriously burned if you touch the insert while it is operating. W arn children of the burn hazard. 8) The insert consumes air while operating, ...
-
Regency I1100S - page 15
Regency Wood Insert & Hearth Heater 15 I1 100 & I3100 MAIN ASSEMBL Y Part # Description 846-913 Door Assembly-Small Gold (I1 100)-no glass 846-915 Door Assembly-Small Black (I1 100)-no glass 846-910 Door Assembly-Large Gold (I3100)-no glass 846-916 Door Assembly-Large Black (I3100)-no glass 2) 846-302 Glass - Replacement - (I1 100) 3) 846-3 ...
-
Regency I1100S - page 16
Regency Wood Insert & Hearth Heater 16 P ARTS LIST I1 100 & I3100 F ACEPLA TES Part # Description Faceplate: I3100L 163-910 Faceplate & T rim Set - Regular 385) 163-165 T rim Right Regular 386) 163-160 T rim T op Regular 387) 163-161 T rim Left Regular 388) * Faceplate Side Regular 389) * Faceplate T op Regular 163-912 Faceplate & T ...
-
Regency I1100S - page 17
Regency Wood Insert & Hearth Heater 17 H2100 MAIN ASSEMBL Y Part # Description Part # Description 1) 846-910 Door Assembly-Large Gold - no glass 846-916 Door Assembly-Large Black - no glass 3) 846-304 Glass - Replacement 4) 936-243 7/8" Adhesive T ape Gasket 5) 846-920 Glass Retainer Clips (set of 8) 6) * Screw 1/4-20 x 3/8" 7) 948-17 ...
-
Regency I1100S - page 18
Regency Wood Insert & Hearth Heater 18 P ARTS LIST I1 100, I3100 & H2100 FIREBRICK Part # Description 70) 902-1 1 1 Brick Regular Full Size: 1-1/4" x 4-1/2" x 9" 71) 802-104 Brick Partial: 1-1/4" x 4" x 9" 72) 802-146 Brick Partial: 1-1/4" x 1-3/4" x 9" 75) 802-139 Brick Partial: 1-1/4" x 4& ...
-
Regency I1100S - page 19
Regency Wood Insert & Hearth Heater 19 W ARRANTY Regency Fireplace Products are designed with reliability and simplicity in mind. In addition, our internal Quality Assurance T e am carefully inspects each unit thoroughly before it leaves our door . FPI Fireplace Products International Ltd. is pleased to extend this limited lifetime warranty to ...
-
Regency I1100S - page 20
Printed in Canada Installer: Please complete the following information Dealer Name & Address: ______________________________________________ ___________________________________________________________________ Installer: ___________________________________________________________ Phone #: _________________________________________________________ ...
¿Tienes una pregunta acerca de Regency I1100S?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Regency I1100S, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Regency I1100S probablemente compartirá una forma de solucionarlo.