-
Woods Equipment BH80X - page 1
I NST AL LA TION MAN U AL SA VE THIS MANU AL! Include it with your Backhoe Manual. It contains safety , operation, and repair part information not found in other manuals. 1012552 3-P OINT MOUNTING KIT For W oods BH70X, BH80X Backhoes MAN0472 (9/23 /2005) T ested. Proven. Unbe atable. ...
-
Woods Equipment BH80X - page 2
2 Introduction SFMK (Rev . 6/6/2005) T O THE DEALER : Assemb ly and prop er installation of this pro duct is the re sponsi bility of the Woods ® dealer . Read manua l instruc tions and safet y rules . Make sure all item s on the Dealer ’s Pre-Del ivery and Delivery Check L ists in the Opera tor ’s Manual are com pleted befo re rele asin g equi ...
-
Woods Equipment BH80X - page 3
Safety 3 BH 3-Pt Mo unt (Rev . 2/2 5/2005) INST ALLA TION This Mounting Kit is to be used on l y for the backhoes and tractors specified in the Inst allation section of t his manua l. Any other use o r modifica- tion of this mounting k it may resul t in seriou s injury or death. Hydraulic s must be con nected as instructed in this manual. D ...
-
Woods Equipment BH80X - page 4
4 Safety BH 3-Pt M ount (Rev . 2/25/2 005) (Safety R ules continue d from previou s pag e) Alwa ys wear re lative ly tigh t and belt ed c lothing to avoid getting caught in moving p arts. W ear sturdy , ro ugh-soled work shoes and protective equipment for eyes, hair , hands, hearing, and he ad; and respir ator or filter mask wh ere ap propriate ...
-
Woods Equipment BH80X - page 5
Inst allation 5 MAN047 2 (9/23/ 2005) BACKHOE 3-POINT MOU NT INST ALLA TION TRACTOR PREP ARA TION NOTE: For installin g this 3-poin t mountin g kit, refer- ence to r ight, left, for ward and rea rward di rection s are determin ed from the opera tor ’s position in the back- hoe seat. NOTE: Leave al l hardwa re lo ose until mounting kit has been fi ...
-
Woods Equipment BH80X - page 6
6 Installation MAN04 72 (9/23/20 05) Att ach T op Link Bars to Backhoe 1. Attach top li nk bar (3) to the mai n frame usin g cap screw (8) , hardene d flat was her (15), an d hex nut (1 1). 2. Slide doub le top link (1) over top link bar ( 3) and secu re using cap scr ew (10) , hardened flat washer (15) , and hex hut (1 1) through end hole on doubl ...
-
Woods Equipment BH80X - page 7
Inst allation 7 MAN047 2 (9/23/ 2005) Att ach 3-Point Mo unt to Backhoe 3. Att a ch lock bar (7) to righ t (4) an d lef t (5) rear bracke ts using cap screws (9), fou r (two pe r side) hardened flat was hers (15 ), and h ex nuts (1 1). D o not tighten nuts at thi s time. 4. Swing loc k bar up and attach it to th e double to p link bar using cap sc ...
-
Woods Equipment BH80X - page 8
8 Installation MAN04 72 (9/23/20 05) Att ach Backhoe to T ractor (Cont inued) 5. Connect trac tor 3- point lowe r lift arms t o the mounting pi ns on the back hoe. Secur e using kl ik pin (14) and was hers (17). Us e washers to take up slac k between k lik pin and 3 -poin t arm. Se e Figure 7. 6. Connect dou ble top lin k bar to the t ractor top li ...
-
Woods Equipment BH80X - page 9
Inst allation 9 MAN047 2 (9/23/ 2005) Remo ve Backhoe The only time the bac khoe may be operated from a position other than the operator seat is during backhoe a tt achme nt and removal. Opera- tor must • Read Mounting Kit Manual instructions on att aching and removing backhoe and use extreme c are. • Always st and between rear tire and bac ...
-
Woods Equipment BH80X - page 10
10 Installation MAN04 72 (9/23/20 05) Atta ch Backhoe to T rac tor This mounting kit is designed to provide secure moun ting and adequ ate operator c lear- ance when properly inst alled. Check clearance dimensions shown in Figure 1 to be sure you have inst alled mounting kit correctly . Follow all mounting i nstruc tions in thi s manual. Do not ...
-
Woods Equipment BH80X - page 11
Inst allation 11 MAN047 2 (9/23/ 2005) T ract or Connections There may be mo re than on e hole provide d in tractor top link attachment br acket. Se lect hole A, B, or C that most ev enly distr ibutes the load between to p link bracke t top and b ottom m ountin g bolts. See Figur e 10. For the Ma ssey Fergus on 1455V tractor use hole position D. NO ...
-
Woods Equipment BH80X - page 12
12 Part s MAN04 72 (9/23/2005 ) 1012552 3-POINT MOUNTING KIT 17 1 8 10 8 3 7 11 15 4 9 15 5 14 16 15 15 11 15 11 12 11 15 6 13 CD6779 R E F P ART QTY DESCRIPTION 1 1007345 1 Doubl e top l ink 3 1012532 1 T op link bar 4 1012534 1 Right rear bracke t 5 1012535 1 Left rear brac ket 6 1012567 4 M 22 Nord lock washer 7 10125 82 1 Lock bar 8 12558 * 2 3 ...
-
Woods Equipment BH80X - page 13
Appendix 13 Bolt T orque & Size Chart s (Rev . 8/14/02) BOLT T OR QUE CHA R T Always tighten har dware to these values unles s a different tor que value or tighte ning p rocedure i s list ed for a specifi c applica tion . F ast eners must al wa ys be repla ced with t he sam e grade as sp ecified in the m anual par ts list. Always use the proper ...
-
Woods Equipment BH80X - page 14
14 Appendix Bolt T orque & Size Chart s (Rev . 8/14/2002) BOLT SIZE CH AR T NO TE: Char t shows bolt thread s izes and co rrespo nding head (wrenc h) sizes for standa rd SAE and metr ic bol ts. 5/16 3/ 8 1/2 5/ 8 3/4 7/ 8 SAE Bolt Thread Sizes MM 25 50 75 100 125 150 175 IN 1 7 Metric Bolt Thread Sizes 8 MM 1 8 MM 14MM 12MM 10MM 16MM 2 34 5 6 A ...
-
Woods Equipment BH80X - page 15
F-3079 (Rev . 9/21/2005) Wo od s E q u i p m e n t Company 260 6 South Illinois Ro ute 2 Post Offi ce Box 1000 Oregon, Illinois 61061 815- 7 32-2141 tel 815- 7 32- 7580 fax www .W o odsEquipment.com W ARR ANTY (All Models Except Mow’ n Machine TM Zero-T urn Mo wers and W oods Bou ndary TM Utility V eh icles) Please Enter I nformation Be lo w and ...
-
Woods Equipment BH80X - page 16
F-8494 (Rev . 6/23/2005) W oods Equipm ent Company 260 6 South Illinois Route 2 Post Office Box 1000 Oregon, Illinoi s 610 61 815- 73 2-2141 tel 815- 73 2- 75 80 fax www .W oodsEquipme nt.com ©2005 Woods Equipment Company . All rights reserved. WOO DS, the Woods logo, and "T ested. Proven. Unbeatable." are tradem arks of Woods Equipment ...
¿Tienes una pregunta acerca de Woods Equipment BH80X?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Woods Equipment BH80X, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Woods Equipment BH80X probablemente compartirá una forma de solucionarlo.