-
Gefen EXT-HDMI1.3-1FO - page 1
® E x te n de r f o r H D MI ® 1. 3 ove r O n e Fi b e r w ith I R EX T - H D MI1. 3- 1 FO Us e r Manual www. ge f e n. co m ...
-
Gefen EXT-HDMI1.3-1FO - page 2
ASKING FOR ASSIST ANCE T echnical Support : T elephone (818) 772-9100 (800) 545-6900 Fax (818) 772-9120 T echnical Support Hours: 8:00 AM to 5:00 PM Monday thru Friday Paci fi c T ime Write T o: Gefen, LLC c/o Customer Service 20600 Nordhoff St Chatsworth, CA 9131 1 www .gefen.com support@gefen.com Notice Gefen, LLC reserves the right to make chan ...
-
Gefen EXT-HDMI1.3-1FO - page 3
CONTENTS 1 Introduction 2 Operation Notes 3 Features 4 Sender Unit Layout 5 Sender Unit Descriptions 6 Receiver Unit Layout 7 Receiver Unit Descriptions 8 Connecting and Operating the Extender 9 DIP Switch Con fi guration 10 DIP Switches 1 1 Local EDID / External (Pass-Through) EDID Modes 1 1 Deep Color 1 1 Calibration Procedure 12 Speci fi catio ...
-
Gefen EXT-HDMI1.3-1FO - page 4
1 INTRODUCTION Congratulations on your purchase of the Extender for HDMI 1.3 Over One Fiber with IR. Y our complete satisfaction is very important to us. Gefen Gefen delivers innovative, progressive computer and electronics add-on solutions that harness integration, extension, distribution and conversion technologies. Gefen’s reliable, plug-and-p ...
-
Gefen EXT-HDMI1.3-1FO - page 5
2 OPERA TION NOTES READ THESE NOTES BEFORE INST ALLING OR OPERA TING THE EXTENDER FOR HDMI 1.3 OVER ONE FIBER WITH IR • IR data repeater functionality is single-directional. IR data can only be transmitted from the Receiving unit back to the Sending unit. IR data cannot be transmitted from the Sending unit to the Receiving unit. • Use one SC-te ...
-
Gefen EXT-HDMI1.3-1FO - page 6
3 FEA TURES HDMI 1.3 Features • 225 MHz (up to 12 bit YUV 444 @ 1080p) • Deep Color • Dolby T rueHD and DTS-HD Master Audio • Lip-Sync • CEC Protocol Pass-Through Features • Supports video resolutions up to 1080p,1920 x 1200 and 2K • 3DTV Pass-Through • Delivers highest quality signal of any HDMI extension method • EDID Detection/ ...
-
Gefen EXT-HDMI1.3-1FO - page 7
4 SENDER UNIT LA YOUT Front Back 3 45 67 12 ...
-
Gefen EXT-HDMI1.3-1FO - page 8
5 SENDER UNIT DESCRIPTIONS 1 Power Indicator This two-color LED will turn bright red once the included 5V DC locking power supply has been properly connected to the unit and the locking power supply has been connected to an available wall outlet. This LED will turn bright green once the Sender unit and Receiver unit are communicating correctly . 2 ...
-
Gefen EXT-HDMI1.3-1FO - page 9
6 Front Back RECEIVER UNIT LA YOUT 34 5 12 8 67 ...
-
Gefen EXT-HDMI1.3-1FO - page 10
7 RECEIVER UNIT DESCRIPTIONS 1 RS-232 Output Port Connect a controlling device to this port. 2 Locking HDMI Output Port Connect a HDTV display to this HDMI port 3 IR Window Receives signals from the Hi-Def source IR remote control unit. The IR signals are sent back to the source device, when using an IR Blaster . 4 Calibration Indicator This LED wi ...
-
Gefen EXT-HDMI1.3-1FO - page 11
8 EXT -HDMI1.3-1FO SC-SC FIBER OPTIC CABLE (Up to 1,000 ft) Sender HDMI Source Receiver HD Display HDMI CABLE How to Connect the Extender for HDMI 1.3 over One Fiber with IR 1. Connect a Hi-Def source to the Sender Unit using the included Locking HDMI cable. Connect the HDTV display to the Receiver Unit with a user-supplied HDMI cable. 2. Connect a ...
-
Gefen EXT-HDMI1.3-1FO - page 12
DIP SWITCH CONFIGURA TION 9 DIP Switches On the bottom of the Sender Unit and Receiver Unit are a bank of four (4) DIP switches. These DIP switches provide control over EDID, Deep Color , and unit Calibration. Remove the strip of tape to expose the DIP switches. T o change the DIP switch settings, move the appropriate DIP switch to its ON or OFF po ...
-
Gefen EXT-HDMI1.3-1FO - page 13
10 DIP SWITCH CONFIGURA TION DIP 1 - EDID Mode • OFF - Local EDID When Local EDID mode is used, the EDID will be assembled by copying all video and audio features of the connected device. Deep Color support will be manually controlled: If Deep Color is supported by the display(s), DIP 2 should be set to the ON position (see DIP 2 - Deep Color , b ...
-
Gefen EXT-HDMI1.3-1FO - page 14
11 DIP SWITCH CONFIGURA TION Calibrating the Sender Unit and Receiver Unit IMPORT ANT : Before beginning the calibration process, make sure that the Sender Unit and Receiver are not powered. 1. Make sure DIP switch 3 on both the Sender Unit and the Receiver Unit are in the OFF position (see page 9). 2. Connect one end of the fi ber cable to the Se ...
-
Gefen EXT-HDMI1.3-1FO - page 15
12 SPECIFICA TIONS Video Ampli fi er Bandwidth ........................................................................ 225 MHz Maximum Resolutions Supported: ..................................1080p60, 1920x1200, 2K Input Video Signal .............................................................................. 1.2 V olts p-p Input DDC Signal ... ...
-
Gefen EXT-HDMI1.3-1FO - page 16
W ARRANTY 13 Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is noti fi ed within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanica ...
-
Gefen EXT-HDMI1.3-1FO - page 17
20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www .gefen.com support@gefen.com Rev A5 This product uses UL listed power supplies. Pb ...
¿Tienes una pregunta acerca de Gefen EXT-HDMI1.3-1FO?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Gefen EXT-HDMI1.3-1FO, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Gefen EXT-HDMI1.3-1FO probablemente compartirá una forma de solucionarlo.