-
Emotiva ERC-1 - page 1
...
-
Emotiva ERC-1 - page 2
...
-
Emotiva ERC-1 - page 3
TABLE OF CONTENTS Thank You for your ERC-1 Purchase 5 Limited Warranty 6 Service Assistance For the ERC-1 6 Emotiva Disclosure 7 FCC Compliance 7 Safety Precautions 8 A Note for the Cable Television (CATV) Installer 9 Unpacking the ERC-1 9 Inventory 9 TECHNICAL SPECIFICATIONS 10 Key Features of Your New ERC-1 Audiophile CD Player 11 Disc Handling 1 ...
-
Emotiva ERC-1 - page 4
TROUBLESHOOTING 20 The disc does not rotate 20 The disc is playing but there is no sound 20 The disc stops, noise is heard or the sound drops out 20 A CD-R / CD-RW disc cannot be played 20 The remote control does not operate 20 A specific CD cannot be played 20 Digital signal has no output 20 4 ...
-
Emotiva ERC-1 - page 5
THANK YOU FOR YOUR ERC-1 PURCHASE Dear Music Enthusiast, Thank you for purchasing the Emotiva ERC-1 CD Play er. We sincerely believe that it offers you outstanding performance and value. Emotiva pr oducts are engineered and produced with the highest quality materials and incorporate the la test technology. We think you will find the Emotiva ERC-1 m ...
-
Emotiva ERC-1 - page 6
LIMITED WARRANTY The Emotiva ERC-1 CD Player has been created to perform flawlessly for many years. As a result of this quality and crafts manship, Emotiva offers the follo wing warranty to owners of the ERC-1. Emotiva Audio warrants the ERC- 1 to be free from defects in materials and workmanship for a period of five years from the original date of ...
-
Emotiva ERC-1 - page 7
Emotiva Disclosure Copyright 2009 Emotiva All Rights Reserved. Emotiva reserves the right to make improvements to its products at any time. Therefore, the specificat ions of the product and the specif ic details of this manual are subject to change at any time. Emotiva and the Emotiva "E" are registered trademarks of Emotiva Audio Corpora ...
-
Emotiva ERC-1 - page 8
SAFETY PRECAUTIONS Read this User's Guide thoroughly before attemp ting to install and c onfigure the ERC-1 CD Player. All the safety and oper ation instructions should be read before any operation of the component(s) begin. After successful installation and configuration of t he ERC-1 CD Player, be sure to retain this manual in a safe place f ...
-
Emotiva ERC-1 - page 9
A Note for the Cable Tel evision (CATV) Installer This reminder is to call the CATV system installe r's attention to Article 82040 of the NEC that provides guidelines for proper grounding and in particular, specif ies that the ca ble ground shall be connected to the grounding system of the building as close to the point of cable entry as pract ...
-
Emotiva ERC-1 - page 10
TECHNICAL SPECIFICATIONS • Output voltage: 1V rms (7V peak) • Channel separation: ≥ 95dB - ref. 1kHz • Frequency response: 20Hz~20kHz (+/- 0.1dB) • S/N: ≥ 100dB (A weighted ） • THD: ≤ 0.01 ％ 0dB 1KHz ） • Playback formats: Redbook CD, HDCD, MP3 • Digital Output Filter: 24-Bit, 384 times oversampling (Analog Devices 1955 ） ...
-
Emotiva ERC-1 - page 11
KEY ERC-1 FEATURES Four (4) independent power supplies to drive each section of the unit separately. This prevents the different sections from interacting and causi ng noise. The separate power supplies apply to: 1. CD carriage 2. Digital section 3. Analog section 4. Display The CD drive mechanism and the digital section of the audio is encased in ...
-
Emotiva ERC-1 - page 12
DISC HANDLING Use only discs with regular shapes. If an irregular disc (a disc wit h a special shape) is used the ERC-1 may be damaged. Discs usable with the ERC-1 CD Audio (CD-DA), CD-R, CD-RW, HDCD Holding discs Avoid touching the surface of a di sc where recording is performed. Loading discs Hold the CD by the edges loosely and gent ly slide the ...
-
Emotiva ERC-1 - page 13
FRONT PANEL LAYOUT 1. PLAY/PAUSE This is used to play and pause the disc. 2. PREVIOUS This is used to jump to the st art of the current trac k or to jump to the start of the previous track. 3. NEXT This is used to advance to t he start of the next track. 4. STOP This is used to stop the disc. 5. DISPLAY This contains all information abo ut the disc ...
-
Emotiva ERC-1 - page 14
REAR PANEL LAYOUT 1. BALANCED OUTPUTS (1 set) These are used to connect the ERC-1 to a si ngle input device (pre/pro, receiver) with balanced (XLR) type cables. 2. ANALOG OUTPUTS (2 sets) These are used to connect the ERC-1 to two separate input devices, (pre/pro, receiver) with RCA type cables. 3. DIGITAL OUTPUTS These are used to connect the ERC- ...
-
Emotiva ERC-1 - page 15
REMOTE CONTROL . EJECT isc from the unit. sed to dim the displa y light. It also turns off th e it between On and Standby mode. y and Pause the disc. d to jump to the st art of the current track or to sed to search backward and has three different ed to search fo rward and has three different ed to advance to the start of the next track. track. Pre ...
-
Emotiva ERC-1 - page 16
11. A-B This allows you to loop a certai n section of a track, a full track, multiple tracks etc. Press once to start the loop, press again where you want the loop to end. The player will now play the section between the two loop points. Press the A-B button again an d the ERC-1 returns to normal play. 12. DISPLAY Pressing the display button change ...
-
Emotiva ERC-1 - page 17
CHANGING THE REMOTE CONTROL BATTERIES Emotiva recommends using high quality AAA batte ries in the ERC-1 remote control. To change the remote control batteries y ou will need a small Philips head screwdriver. Remove the six (6) Philips head screws on the back of the remote. Make sure you use the proper size screwdriver so you do not damage t he scre ...
-
Emotiva ERC-1 - page 18
OPERATING INSTRUCTIONS LOADING & EJECTING DISCS 1. Press the Standby/On button, make sure unit is on. 2. The display will read EMOTIVA for a few se conds at power up. LOADING will then appear on the screen. The play er will then say READY. Insert disc into the slot-loader gently. Do not push hard. Allow the slot-loa der to grab the disc from yo ...
-
Emotiva ERC-1 - page 19
LOCATING A PARTICULAR POINT IN A TRACK 1. Make sure that the disc is playing the desired track. 2. Press the Left REV Button on the remote cont rol, the CD will then rewind within the track. Press again and the disc will rewi nd faster. Press a third time and the disc rewinds faster. Press a fourth time and the disc will resume no rmal play or pres ...
-
Emotiva ERC-1 - page 20
TROUBLESHOOTING • The disc does not rotate 1. Is the power cable plugged in? 2. Is the power switch on? 3. Is the disc placed upside down? 4. Is the disc dirty? 5. Is the disc scratched? 6. Is the disc warped? • The disc is playing but there is no sound 1. Are the receiver or pre/pro and amplifier and sp eakers connected correctly? 2. Is the re ...
-
Emotiva ERC-1 - page 21
21 Revised 06/2009 All contents © 2009 Emotiv a Audio Corporatio n. ...
-
Emotiva ERC-1 - page 22
22 ...
¿Tienes una pregunta acerca de Emotiva ERC-1?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Emotiva ERC-1, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Emotiva ERC-1 probablemente compartirá una forma de solucionarlo.