-
Poulan 34-80 - page 1
OPERA TOR'S MANU AL MODEL: PB195H42L T L A WN TRACTOR AL W A YS WEAR EYE PROTECTION DURING OPERA TION Visit our website: www .poulan-pro.com WARNING: Read this Man u al and follow all Warnings and Safety Instructions. F ail ure to do so can re sult in serious in ju ry . IMPORT ANT MANU AL Do Not Throw Away 532 43 34-80 Rev . 1 04.28.10 CL Prin ...
-
Poulan 34-80 - page 2
2 SAFETY RULES Safe Operation Practices for Ride-On Mowers DANGER: THIS CUTTING MACHINE IS CAP ABLE OF AMPUT A TING HANDS AND FEET AND THROW ING OBJECTS. F AILURE TO OBSERVE THE FOLL OWING SAFETY INSTRUCTIONS COULD RESUL T IN SERIOUS INJURY OR DEATH. I. GENERAL OPERA TION • Read, understand, and follow all instructions on the machine and in the m ...
-
Poulan 34-80 - page 3
3 SAFETY RULES Safe Operation Practices for Ride-On Mowers • Be sure the area is clear of bystanders before operat- ing. Stop machine if anyone enters the area. • Never carry passengers. • Do not mow in reverse unless absolutely necessary . Al ways look down and behind before and while back- ing. • Never carry children, even with the blades ...
-
Poulan 34-80 - page 4
4 SAFETY RULES ......................................................... 2-3 PRODUCT SPECIFICA TIONS ....................................... 4 CUSTOMER RESPONSIBILITIES ................................. 4 ASSEMBL Y ................................................................. 6-7 OPERA TION ...................................................... ...
-
Poulan 34-80 - page 5
5 Steering Wheel Steering Wheel (1) W asher Seat (1) Seat Steering Boot Steering Extension Shaft Steering Wheel Adapter Key(s) Slope Sheet (1) Oil Drain T ube F or F uture Use (1) Hex Bolt (1) Lock W asher (1) Large Flat W asher Steering Wheel Insert (1) Knob UNAS SEMBLED P ARTS ...
-
Poulan 34-80 - page 6
6 Y our new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. T o ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely . Use the correct tools as necessary to ensure proper tightness. Fig. 2 A TT ACH STEERING WHEEL (See Fig. 2) A ...
-
Poulan 34-80 - page 7
7 Fig. 4 BOL T FL A T WASHER SEA T P AN PA D T APE SL OT TA B ADJUSTMENT HANDLE NOTE: Y ou may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid. WARNING: Before start ing, read, un der stand and fol low all in struc tions in the Op er a tion section of this man u al. Be sure tractor is in a well- ...
-
Poulan 34-80 - page 8
8 These symbols may appear on your tractor or in literature supplied with the product. Learn and understand their meaning. DANGER, KEEP HANDS AND FEET AWAY FREE WHEEL (Automatic Models only) OVER TEMP LIGHT KEEP AREA CLEAR SLOPE HAZARDS 15 15 (SEE SAFETY RULES SECTION) BATTERY REVERSE FORWARD FAST SLOW ENGINE ON ENGINE OFF OIL PRESSURE FUEL CHOKE M ...
-
Poulan 34-80 - page 9
9 KNOW YOUR TRACTOR READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERA TING YOUR TRACTOR Compare the illustrations with your tractor to familiarize yourself with the locations of various controls and ad just ments. Save this manual for future reference. A TT ACHMENT CLUTCH LEVER - Used to engage the mower blades, or other attachments mount ...
-
Poulan 34-80 - page 10
10 Fig. 6 ( ) A TT ACHMENT CLUTCH LEVER “ENGAGED” ( ) A TT ACHMENT CLUTCH LEVER “DIS EN GAGED” D F Fig. 8 Fig. 7 J Fig. 9 B C OPERA TION HOW TO USE YOUR TRACTOR TO SET P ARKING BRAKE (See Fig. 6) Y our tractor is equipped with an operator presence sens - ing switch. When engine is running, any attempt by the op er a tor to leave the seat wi ...
-
Poulan 34-80 - page 11
11 Fig. 10 TO ADJUST MOWER CUT TING HEIGHT (See Fig. 10) The po si tion of the at tach ment lift le ver (A) de ter mines the cut ting height. • Put attachment lift lever in desired cutting height slot. The cutting height range is ap prox i mate ly 1" to 4". The heights are measured from the ground to the blade tip with the engine not ru ...
-
Poulan 34-80 - page 12
12 TOWING CARTS AND OTHER A T T ACH MENTS T ow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor . Use common sense when towing. T oo heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor . ADD GASOLINE ? ...
-
Poulan 34-80 - page 13
13 MOWING TIPS • Mower should be properly leveled for best mowing per for mance. See "TO LEVEL MOWER HOUSING" in the Service and Adjustments section of this manual. • The left hand side of mower should be used for trim ming. • Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of t ...
-
Poulan 34-80 - page 14
14 ➀ General Purpose Grease ➁ Refer to Maintenance “ENGINE” Section 01965 ➁ ENGINE ➀ FRONT WHEEL BEARING ZERK ➀ STEERING SECTOR GEAR TEETH ➀ FRONT WHEEL BEARING ZERK ➀ SPINDLE ZERK ➀ SPINDLE ZERK MAINTENANCE T R A C T 0 R 1 - Change more often when operating under a heavy load or in high ambient temperatures . 2 - Service more o ...
-
Poulan 34-80 - page 15
15 BA TTERY Y our tractor has a battery charging system which is suf fi cient for normal use. However , periodic charging of the battery with an automotive charger will extend its life. • Keep battery and terminals clean. • Keep battery bolts tight. • Keep small vent holes open. • Recharge at 6-10 amperes for 1 hour . NOTE: The original equ ...
-
Poulan 34-80 - page 16
16 Fig. 18 ENGINE LUBRICA TION Only use high quality detergent oil rated with API service classification SG-SL. Select the oil’s SAE viscosity grade according to your expected operating temperature. NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather , they will result in increased oil consumption when used abo ...
-
Poulan 34-80 - page 17
17 IN-LINE FUEL FIL TER (See Fig. 21) The fuel filter should be replaced once each season. If fuel filter becomes clogged, ob struct ing fuel flow to car bu re tor , re place ment is re quired. • With engine cool, remove filter and plug fuel line sec tions. • Place new fuel filter in position in fuel line with arrow pointing towards carburetor ...
-
Poulan 34-80 - page 18
18 WARNING: TO A VOID SE RI OUS IN JU RY , BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: • Depress brake pedal fully and set parking brake. • Place motion control lever in neutral position. • Place attachment clutch in “DISENGAGED” position. • T urn ignition key to “STOP ” and remove key . • Make sure the blades and all moving par ...
-
Poulan 34-80 - page 19
19 SERVICE AND ADJUSTMENTS E F C G Q R D K G P B L M A IMPORT ANT : CHECK BEL T FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES. • Raise attachment lift lever to highest position. • If necessary , adjust gauge wheels before op er at ing mower as shown in the Operation section of this manual. E F H J M Fig. 26 Fig. 27 A B D C Fig. 24 Fig. 25 • ...
-
Poulan 34-80 - page 20
20 SERVICE AND ADJUSTMENTS • If adjustment is necessary , see step in Visual Adjust- ment instructions above. • Recheck measurements, adjust if necessary until both sides are equal. FRONT -TO-BACK ADJUSTMENT (See Figs. 31 & 32) IMPORT ANT : Deck must be level side-to-side. T o obtain the best cutting re sults, the mower blades should be adj ...
-
Poulan 34-80 - page 21
21 Fig. 34 TO CHECK BRAKE If tractor requires more than five (5) feet to stop at highest speed in high est gear on a level, dry concrete or paved surface, then brake must be serviced. Y ou may also check brake by: 1. P ark tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake. 2. Disengage ...
-
Poulan 34-80 - page 22
22 TO ADJUST STEERING WHEEL ALIGNMENT If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer - ing wheel and reassemble per instructions in the Assembly section of this manual. FRONT WHEEL TOE-IN/CAMBER The front wheel toe-in and camber are not adjustable on your tractor . If damage ...
-
Poulan 34-80 - page 23
23 REPL ACING BA TTERY ( See Fig. 38 ) WARNING: Do not short battery ter mi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery , remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from ac ci den tal grounding. • Lift ...
-
Poulan 34-80 - page 24
24 Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more. WARNING: Never store the trac tor with gas o line in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any en clo sure. TRACTOR Remove mower from tractor f ...
-
Poulan 34-80 - page 25
25 TROUBLESHOOTING PROBLEM CAUSE CORRECTION Will not start 1. Out of fuel. 1. Fill fuel tank. 2. Engine not “CHOKED” properly . 2. See “TO ST ART ENGINE” in Operation section. 3. Engine flooded. 3. Wait several minutes before attempting to start. 4. Bad spark plug. 4. Replace spark plug. 5. Dirty air filter . 5. Clean/replace air filter . 6 ...
-
Poulan 34-80 - page 26
26 TROUBLESHOOTING POINTS PROBLEM CAUSE CORRECTION Engine continues to run when oper- ator leaves seat with attachment clutch engaged 1. Faulty operator -safety presence control system. 1. Check wiring, switches and connections. If not corrected, contact an authorized service center/ department. Poor cut - uneven 1. Worn, bent or loose blade. 1. Re ...
-
Poulan 34-80 - page 27
27 15 DEGREES MAX. FOLD ALONG DOTTED LINE THIS IS A 15 DEGREE SLOPE ONLY RIDE UP AND DOWN HILL, NOT ACROSS HILL SUGGESTED GUIDE FOR SIGHTING SLOPES FOR SAFE OPERATION WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not mow slopes greater than 15 degrees. Make turns gradually to preven ...
-
Poulan 34-80 - page 28
LIMITED W ARRANTY The Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materi- als and work man ship. For a period of two (2) years from date of purchase by the original consumer purchaser , we will repair or replace, at our option, without charge for parts or labor incurred in repla ...
¿Tienes una pregunta acerca de Poulan 34-80?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con Poulan 34-80, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con Poulan 34-80 probablemente compartirá una forma de solucionarlo.